- 您現在的位置：買賣IC網 > PDF目錄3515 > MAX4012EUK+T (Maxim Integrated Products)IC OPAMP GP R-R 200MHZ SOT23-5 PDF資料下載
參數資料
| 型號： | MAX4012EUK+T |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 2/17頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC OPAMP GP R-R 200MHZ SOT23-5 |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 1 |
| 放大器類型： | 電壓反饋 |
| 電路數： | 1 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 600 V/µs |
| -3db帶寬： | 200MHz |
| 電流 - 輸入偏壓： | 5.4µA |
| 電壓 - 輸入偏移： | 4000µV |
| 電流 - 電源： | 5.5mA |
| 電流 - 輸出 / 通道： | 120mA |
| 電壓 - 電源，單路/雙路(±)： | 3.15 V ~ 11 V，±1.575 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | SC-74A，SOT-753 |
| 供應商設備封裝： | SOT-23-5 |
| 包裝： | 標準包裝 |
| 其它名稱： | MAX4012EUK+TDKR |
第1頁當前第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁
MAX4012/MAX4016/MAX4018/MAX4020
Detailed Description
The MAX4012/MAX4016/MAX4018/MAX4020 are sin-
gle-supply, rail-to-rail, voltage-feedback amplifiers that
employ current-feedback techniques to achieve
600V/s slew rates and 200MHz bandwidths. Excellent
harmonic distortion and differential gain/phase perfor-
mance make these amplifiers an ideal choice for a wide
variety of video and RF signal-processing applications.
The output voltage swing comes to within 50mV of each
supply rail. Local feedback around the output stage
assures low open-loop output impedance to reduce
gain sensitivity to load variations. This feedback also
produces demand-driven current bias to the output
transistors for ±120mA drive capability, while constrain-
ing total supply current to less than 7mA. The input
stage permits common-mode voltages beyond the nega-
tive supply and to within 2.25V of the positive supply rail.
Applications Information
Choosing Resistor Values
Unity-Gain Configuration
The MAX4012/MAX4016/MAX4018/MAX4020 are inter-
nally compensated for unity gain. When configured for
unity gain, the devices require a 24
resistor (RF) in
series with the feedback path. This resistor improves
AC response by reducing the Q of the parallel LC cir-
cuit formed by the parasitic feedback capacitance and
inductance.
Inverting and Noninverting Configurations
Select the gain-setting feedback (RF) and input (RG)
resistor values to fit your application. Large resistor val-
ues increase voltage noise and interact with the amplifi-
er’s input and PC board capacitance. This can
generate undesirable poles and zeros and decrease
bandwidth or cause oscillations. For example, a nonin-
verting gain-of-two configuration (RF = RG) using 1k
resistors, combined with 1pF of amplifier input capaci-
tance and 1pF of PC board capacitance, causes a pole
at 159MHz. Since this pole is within the amplifier band-
width, it jeopardizes stability. Reducing the 1k
resis-
tors to 100
extends the pole frequency to 1.59GHz,
but could limit output swing by adding 200
in parallel
with the amplifier’s load resistor. Table 1 shows sug-
gested feedback, gain resistors, and bandwidth for
several gain values in the configurations shown in
Figures 1a and 1b.
Layout and Power-Supply Bypassing
These amplifiers operate from a single 3.3V to 11V power
supply or from dual supplies to ±5.5V. For single-supply
operation, bypass VCC to ground with a 0.1F capacitor
as close to the pin as possible. If operating with dual sup-
plies, bypass each supply with a 0.1F capacitor.
Low-Cost, High-Speed, Single-Supply
Op Amps with Rail-to-Rail Outputs
10
______________________________________________________________________________________
IN
RG
VOUT = [1+ (RF / RG)] VIN
RF
RTO
RTIN
RO
VOUT
MAX40_ _
IN
RG
VOUT = -(RF / RG) VIN
RF
RTO
RS
RTIN
RO
VOUT
MAX40_ _
Figure 1a. Noninverting Gain Configuration
Figure 1b. Inverting Gain Configuration
相關PDF資料 |
PDF描述 |
|---|---|
| RMCF0805FT47K0 | RES 47K OHM 1/8W 1% 0805 SMD |
| 5-103817-6 | 24 MODII HDR 3RST UNSHRD .100 |
| 929550-01-32-EU | CONN HEADER .100 SNGL R/A 32POS |
| AD8007AR | IC OPAMP CF ULDIST LN LP 8SOIC |
| MMS-127-02-L-DH | CONN RCPT 2MM 54POS DL HORZ SMD |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX40-13.0C | 制造商:MDE 制造商全稱:MDE Semiconductor, Inc. 功能描述:HIGH CURRENT TRANSIENT VOLTAGE SUPPRESSOR (TVS) DIODE |
| MAX40-13.0CA | 制造商:MDE 制造商全稱:MDE Semiconductor, Inc. 功能描述:HIGH CURRENT TRANSIENT VOLTAGE SUPPRESSOR (TVS) DIODE |
| MAX40-130CA | 制造商:MDE 制造商全稱:MDE Semiconductor, Inc. 功能描述:HIGH CURRENT TRANSIENT VOLTAGE SUPPRESSOR (TVS) DIODE STAND-OFF VOLTAGE 12 TO 150 Volts 40000 Watt Peak Pulse Power |
| MAX40-13CA | 制造商:MDE 制造商全稱:MDE Semiconductor, Inc. 功能描述:HIGH CURRENT TRANSIENT VOLTAGE SUPPRESSOR (TVS) DIODE STAND-OFF VOLTAGE 12 TO 150 Volts 40000 Watt Peak Pulse Power |
| MAX4014 | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:Low-Cost, High-Speed, Single-Supply, Gain of +2 Buffers with Rail-to-Rail Outputs in SOT23 |
發布緊急采購，3分鐘左右您將得到回復。