參數資料
型號： MAX3349EETE+
廠商： Maxim Integrated Products
文件頁數： 3/16頁
文件大小： 0K
描述： IC TXRX USB 2.0 FS 16-TQFN
標準包裝： 75
類型： 收發器
驅動器/接收器數： 1/1
規程： USB 2.0
電源電壓： 4 V ~ 5.5 V
安裝類型： 表面貼裝
封裝/外殼： 16-TQFN 裸露焊盤
供應商設備封裝： 16-TQFN-EP（4x4）
包裝： 管件
MAX3349E
Hi-Speed USB 2.0 Full-Speed Transceiver
with UART Multiplexing Mode
______________________________________________________________________________________
11
USB Mode
The MAX3349E is in USB mode when VBUS is greater
than VTH-BUS and the bus detect output (BD) is logic-
high. In USB mode, power for the MAX3349E is derived
from VBUS, typically provided through the USB connec-
tor. An internal linear regulator generates the required
+3.3V VTRM voltage from VBUS. VTRM powers the inter-
nal USB transceiver circuitry and the D+ enumeration
resistor. Bypass VTRM to GND with a 1F ceramic
capacitor as close to the device as possible. Do not
power external circuitry from VTRM.
Disable Mode
Connect VBUS to a system power supply and leave VL
unconnected or connect to ground to enter disable
mode. In disable mode, D+ and D- are high imped-
ance, and withstand external signals up to +5.5V. OE,
SUS, and control signals are ignored.
UART Mode
Connect VL and VUART to system power supplies, and
leave VBUS unconnected or below VTH-BUS to operate
the MAX3349E in UART mode. The MAX3349E sup-
ports VUART from +2.7V to +3.3V (see Table 1).
USB Control Signals
OE
OE controls the direction of communication for USB
mode. When OE is logic-low, VP and VM operate as
logic inputs, and D+/D- are outputs. When OE is logic-
high, VP and VM operate as logic outputs, and D+/D-
are inputs. RCV is the output of the differential USB
receiver connected to D+/D-, and is not affected by the
OE logic level.
ENUM
Drive ENUM logic-high to enable the internal 1.5k
pullup resistor from D+ to VTRM. Drive ENUM logic-low
to disable the internal pullup resistor and logically dis-
connect the MAX3349E from the USB.
SUS
Operate the MAX3349E in low-power USB suspend
mode by driving SUS logic-high. In suspend mode, the
USB differential receiver is turned off and VBUS con-
sumes 38A (typ) of supply current. The single-ended
VP and VM receivers remain active to detect a SE0
state on USB bus lines D+ and D-. The USB transmitter
Table 1. Power-Supply Configuration
INPUTS
OUTPUTS
VP
VM
D+
D-
00
0
01
0
1
10
1
0
11
1
Table 2. USB Transmit Truth Table (OE = 0)
INPUTS
OUTPUTS
D+
D-
VP
VM
RCV
0000
RCV*
0101
0
1010
1
1111X
Table 3a. USB Receive Truth Table (OE = 1,
SUS = 0)
INPUTS
OUTPUTS
D+
D-
VP
VM
RCV
0000
0
0101
0
1010
0
1111
0
Table 3b. USB Receive Truth Table (OE = 1,
SUS = 1)
*
= Last State
X = Undefined
VBUS(V)
VTRM(V)
VL(V)
VUART(V)
CONFIGURATION
+4.0 to +5.5
+3.0 to +3.6 Output
+1.4 to +2.75
GND, Unconnected, or
+2.7V to +3.3V
USB Mode
+3.0 to +5.5
+2.8 to +3.6
+1.4 to +2.75
GND or Unconnected
Battery Mode
+4.0 to +5.5
+3.0 to +3.6 Output
GND or Unconnected
GND, Unconnected, or
+2.7V to +3.3V
Disable Mode
GND or Unconnected
High Impedance
+1.4 to +2.75
+2.7V to +3.3V
UART Mode
相關PDF資料
PDF描述
MAX334EWE IC SWITCH QUAD SPST 16SOIC
MAX335EWG IC SWITCH OCTAL SPST 24SOIC
MAX3362AKA#TG16 IC TXRX RS485/422 SGL SOT23-8
MAX336CWI IC MULTIPLEXER 16X1 28SOIC
MAX3380EEUP+T IC TXRX RS232 460KBPS 20-TSSOP
相關代理商/技術參數
參數描述
MAX3349EETE+ 功能描述:IC TXRX USB 2.0 FS 16-TQFN RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:25 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:4.5 V ~ 5.5 V 安裝類型:通孔 封裝/外殼:16-DIP（0.300"，7.62mm） 供應商設備封裝:16-PDIP 包裝:管件
MAX3349EETE+T 制造商:Maxim Integrated Products 功能描述:USB TRNSCVR 1TX 1RX 12MBPS 16TQFN EP - Tape and Reel
MAX334C/D 制造商:Maxim Integrated Products 功能描述:
MAX334CJE 功能描述:模擬開關 IC RoHS:否 制造商:Texas Instruments 開關數量:2 開關配置:SPDT 開啟電阻（最大值）:0.1 Ohms 切換電壓（最大）: 開啟時間（最大值）: 關閉時間（最大值）: 工作電源電壓:2.7 V to 4.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-16
MAX334CPE 功能描述:模擬開關 IC RoHS:否 制造商:Texas Instruments 開關數量:2 開關配置:SPDT 開啟電阻（最大值）:0.1 Ohms 切換電壓（最大）: 開啟時間（最大值）: 關閉時間（最大值）: 工作電源電壓:2.7 V to 4.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-16
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*