- 您現在的位置：買賣IC網 > PDF目錄383363 > MAX3318EUP (MAXIM INTEGRATED PRODUCTS INC) 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors PDF資料下載
參數資料
| 型號： | MAX3318EUP |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | 通用總線功能 |
| 英文描述： | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
| 中文描述： | LINE TRANSCEIVER, PDSO20 |
| 封裝： | TSSOP-20 |
| 文件頁數： | 13/16頁 |
| 文件大小： | 190K |
| 代理商： | MAX3318EUP |
M
±15kV ESD-Protected, 2.5V, 1μA, 460kbps,
RS-232 Compatible Transceivers
______________________________________________________________________________________
13
Capacitor Selection
The capacitor type used for C1–C4 is not critical for
proper operation; polarized or nonpolarized capacitors
can be used. The charge pump requires 0.1μF capaci-
tors. Increasing the capacitor values (e.g., by a factor of
2) reduces ripple on the transmitter outputs and slightly
reduces power consumption. C2, C3, and C4 can be
increased without changing C1’s value.
However, do
not increase C1 without also increasing the values of
C2, C3, C4, and C
BYPASS
to maintain proper ratios
(C1 to other capacitors).
When using the minimum-required capacitor values,
make sure the capacitor value does not degrade exces-
sively with temperature. If in doubt, use capacitors with
a higher nominal value. The capacitor’s equivalent
series resistance (ESR), which usually rises at low tem-
peratures, influences the amount of ripple on V+ and V-.
Power-Supply Decoupling
In most circumstances, a 0.1μF bypass capacitor is
adequate. In applications that are sensitive to power-
supply noise, decouple V
CC
to ground with a capacitor
of the same value as charge pump capacitor C1.
Connect bypass capacitors as close to the IC as possible.
Transmitter Outputs when
Exiting Shutdown
Figure 2 shows two transmitter outputs when exiting
shutdown mode. As they become active, the two trans-
mitter outputs are shown going to opposite RS-232 com-
patible levels (one transmitter input is high, the other is
low). Each transmitter is loaded with 3k
in parallel with
2500pF. The transmitter outputs display no ringing or
undesirable transients as they come out of shutdown.
Note that the transmitters are enabled only when the
magnitude of V- exceeds approximately -3V.
High Data Rates
The MAX3316E–MAX3319E maintain RS-232 compatible
±3.7V minimum transmitter output voltage even at high
data rates. Figure 8 shows a transmitter loopback test
circuit. Figure 9 shows a loopback test result at
230kbps. For Figure 9, all transmitters were driven
simultaneously at 230kbps into EIA/TIA-562 loads in
parallel with 1000pF.
Chip Information
TRANSISTOR COUNT: 1130
MAX3316E
MAX3317E
MAX3318E
MAX3319E
5k
R_ IN
R_ OUT
FORCEON**
C2-
C2+
C1-
C1+
V-
V+
V
CC
C4
C3*
C1
C2
C
BYPASS
V
CC
FORCEOFF**
*C3 CAN BE RETURNED TO V
CC
OR GND.
**MAX3318E/MAX3319E
T_ OUT
T_ IN
GND
V
CC
1000pF
Figure 8. Loopback Test Circuit
2V/div
5V/div
2V/div
T1 IN
T1 OUT
R1 OUT
Figure 9. Loopback Test Result at 230kbps
相關PDF資料 |
PDF描述 |
|---|---|
| MAX3318EAP | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
| MAX3318ECAP | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
| MAX3316EEUP | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
| MAX3317EEUP | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
| MAX3318EEUP | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX3318EUP+ | 功能描述:RS-232接口集成電路 460kbps 1uA 2.5V Transceiver RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| MAX3318EUP+T | 功能描述:RS-232接口集成電路 460kbps 1uA 2.5V Transceiver RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| MAX3318EUP-T | 功能描述:RS-232接口集成電路 RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| MAX3318IDB | 功能描述:RS-232接口集成電路 2.5V 460-Kbps Transceiver RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| MAX3318IDBE4 | 功能描述:RS-232接口集成電路 2.5V 460-Kbps Transceiver RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
發布緊急采購，3分鐘左右您將得到回復。