- 您現在的位置：買賣IC網 > PDF目錄385523 > MAX2307_1 (Maxim Integrated Products, Inc.) Evaluation Kit PDF資料下載
參數資料
| 型號： | MAX2307_1 |
| 廠商： | Maxim Integrated Products, Inc. |
| 英文描述： | Evaluation Kit |
| 中文描述： | 評估板 |
| 文件頁數： | 2/5頁 |
| 文件大?。?/td> | 200K |
| 代理商： | MAX2307_1 |
E
MAX2307 Evaluation Kit
2
_______________________________________________________________________________________
Quick Start
Each EV kit is fully assembled and factory tested.
Follow the instructions in the
Connections and Setup
section.
Test Equipment Required
Connections and Setup
1) Verify the DC power supply is set to less than +4.2V
before attaching the supply to the EV kit. A good
starting voltage is +2.8V.
2) Set V
GC
to +2.2V.
3) Verify the jumpers JU1 and JU2 are in the “V
CC
”
position.
4) The supply current should be approximately 30mA.
5) Connect a signal generator to the IFIN connector
using an SMA cable. Set the generator’s output to
165MHz at -20dBm power level.
6) Connect a second signal generator to the LO input
connector using an SMA cable. Set the generator’s
output to 741MHz at -15dBm power level.
7) Connect the RF output of the EV kit to the spectrum
analyzer using an SMA cable. Take care to use quali-
ty connector adapters for the spectrum analyzer’s
input. Avoid using BNC-type connectors due to their
high VSWR while operating in the gigahertz range.
8) To assist in troubleshooting, verify the correct volt-
ages on the PC board with a multimeter. Use Table 1
to verify correct node voltage during proper opera-
tion.
9) Set the spectrum analyzer’s center frequency to
906MHz.
10)Set the marker position to the peak level.
11)Read the output power of the center frequency. This
should be about +4dBm, depending on cable and
connector losses.
EQUIPMENT
DESCRIPTION
DC Power Supply
Capable of supplying +2.8V to 4.2V
at a minimum of 50mA
HP 8561E
Spectrum Analyzer
Or equivalent high-sensitivity
spectrum analyzer
Digital Multimeters
To monitor supply voltage and supply
current (if desired)
HP 8648C RF
Generators, 2
For the IFIN and LO inputs or
equivalent sine-wave sources
Table 1. Nominal DC Voltage
PIN
NUMBER
PIN NAME
NOMINAL DC
VOLTAGE (V)
A1
A2
A3
VCC
VCCMIXP
VCCMIXM
GND
LOIN/
SHDNLO
GC
RFOUT
IFINP
IFINM
SHDN
+2.8
+2.8
+2.8
0
+2.8
+2.2
+2.8
0.948
0.948
+2.8
A4, C1
B1
B3
B4
C2
C3
C4
Component Suppliers
SUPPLIER
PHONE
843-448-9411
847-639-6400
800-344-4539
800-328-3911
800-831-9172
800-745-8656
FAX
WEB
AVX
Coilcraft
Digi-Key
EF Johnson
Murata
Toko
843-448-1943
843-639-1469
218-681-3380
507-835-6969
814-238-0490
708-699-1194
www.avxcorp.com
www.coilcraft.com
www.digikey.com
www.efjohnson.com
www.murata.com
www.tokoam.com
相關PDF資料 |
PDF描述 |
|---|---|
| MAX2307EVKIT-T | Evaluation Kit |
| MAX2307 | Low-Power Cellular Upconverter-Driver |
| MAX2335_1 | Evaluation Kit |
| MAX2335EVKIT | Evaluation Kit |
| MAX2335 | 450MHz CDMA/OFDM LNA/Mixer |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX2307EBC DIE | 制造商:Maxim Integrated Products 功能描述: |
| MAX2307EBC-T | 功能描述:上下轉換器 RoHS:否 制造商:Texas Instruments 產品:Down Converters 射頻:52 MHz to 78 MHz 中頻:300 MHz LO頻率: 功率增益: P1dB: 工作電源電壓:1.8 V, 3.3 V 工作電源電流:120 mA 最大功率耗散:1 W 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PQFP-128 |
| MAX2307EVKIT | 功能描述:射頻開發工具 RoHS:否 制造商:Taiyo Yuden 產品:Wireless Modules 類型:Wireless Audio 工具用于評估:WYSAAVDX7 頻率: 工作電源電壓:3.4 V to 5.5 V |
| MAX2308EGI | 功能描述:調節器/解調器 CDMA If VGAs & I/Q Demodulator w/VCO RoHS:否 制造商:Texas Instruments 封裝 / 箱體:PVQFN-N24 封裝:Reel |
| MAX2308EGI-T | 功能描述:調節器/解調器 CDMA If VGAs & I/Q Demodulator w/VCO RoHS:否 制造商:Texas Instruments 封裝 / 箱體:PVQFN-N24 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。