- 您現在的位置：買賣IC網 > PDF目錄9859 > MAX194BCWE+T (Maxim Integrated Products)IC ADC 14BIT 85KSPS 16-SOIC PDF資料下載
參數資料
| 型號： | MAX194BCWE+T |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 23/24頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 14BIT 85KSPS 16-SOIC |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 1,000 |
| 位數： | 14 |
| 采樣率（每秒）： | 85k |
| 數據接口： | QSPI?，串行，SPI? |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 80mW |
| 電壓電源： | 模擬和數字，雙 ± |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-SOIC（0.295"，7.50mm 寬） |
| 供應商設備封裝： | 16-SOIC W |
| 包裝： | 帶卷 (TR) |
| 輸入數目和類型： | 1 個單端，單極；1 個單端，雙極 |
MAX194
sion and EOC will go high on the following CLK falling
edge (Figure 4). CONV is ignored during conversions.
External Clock
The conversion clock (CLK) should have a duty cycle
between 25% and 75% at 1.7MHz (the maximum clock
frequency). For lower frequency clocks, ensure the
minimum high and low times exceed 150ns. The mini-
mum clock rate for accurate conversion is 125Hz for
temperatures up to +70°C or 1kHz at +125°C due to
leakage of the sampling capacitor array. In addition,
CLK should not remain high longer than 50ms at tem-
peratures up to +70°C or 500s at +125°C. If CLK is
held high longer than this, RESET must be pulsed low
to initiate a recalibration because it is possible that
state information stored in internal dynamic memory
may be lost. The MAX194’s clock can be stopped
indefinitely if it is held low.
If the frequency, duty cycle, or other aspects of the
clock signal’s shape change, the offset created by cou-
pling between CLK and the analog inputs (AIN and
REF) changes. Recalibration corrects for this offset and
restores DC accuracy.
Output Data
The conversion result is clocked out MSB first, format-
ted as 14 data bits plus two sub-LSBs. Serial data is
available on DOUT only when CS is held low.
Otherwise, DOUT is in a high-impedance state. There
are two ways to read the data on DOUT. To read the
data bits as they are determined (at the CLK clock
rate), hold CS low during the conversion. To read
results between conversions, hold CS low and clock
SCLK at up to 5MHz.
If you read the serial data bits as they are determined
(at the conversion-clock rate), EOC frames the data bits
(Figure 6). Conversion begins with the first falling CLK
edge, after CONV goes low and the input signal has
been acquired. Data bits are shifted out of DOUT on
subsequent falling CLK edges. Clock data in on CLK’s
rising edge or, if the clock speed is greater than 1MHz,
on the following falling edge of CLK to meet the maxi-
mum CLK-to-DOUT timing specification. See the
Operating Modes and SPI/QSPI Interfaces section
for additional information. Reading the serial data dur-
ing the conversion results in the maximum conversion
throughput, because a new conversion can begin
immediately after the input acquisition period following
the previous conversion.
14-Bit, 85ksps ADC with 10A Shutdown
8
_______________________________________________________________________________________
TRACK/HOLD
CLK
CONVERSION
BEGINS
CONVERSION
ENDS
tAQ
*
* THE FALLING EDGE OF CONV MUST OCCUR IN THIS REGION
tCEL
tCW
tCEH
tCC2
tCC1
EOC
CONV
Figure 4. Initiating Conversions—Less than 3 CLK cycles since end of previous conversion.
SPI/QSPI are trademarks of Motorola Corp.
相關PDF資料 |
PDF描述 |
|---|---|
| MX574AJCWI+T | IC ADC 12BIT W/REF 28-SOIC |
| MS27468T21F35S | CONN RCPT 79POS JAM NUT W/SCKT |
| MAX166CEPP+ | IC ADC 8BIT MPU COMP 20-DIP |
| MAX158BCWI+ | IC ADC CMOS 8BIT W/MUX&REF28SOIC |
| D38999/24MB98PB | CONN RCPT 6POS JAM NUT W/PINS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX194BEPE | 功能描述:模數轉換器 - ADC RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| MAX194BEPE+ | 功能描述:模數轉換器 - ADC 14Bit 85ksps 5V Precision ADC RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| MAX194BEWE | 功能描述:模數轉換器 - ADC RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| MAX194BEWE+ | 功能描述:模數轉換器 - ADC 14Bit 85ksps 5V Precision ADC RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| MAX194BEWE+T | 功能描述:模數轉換器 - ADC 14Bit 85ksps 5V Precision ADC RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
發布緊急采購，3分鐘左右您將得到回復。