- 您現在的位置：買賣IC網 > PDF目錄384654 > MAX1760EUB (MAXIM INTEGRATED PRODUCTS INC) 0.8A, Low-Noise, 1MHz, Step-Up DC-DC Converter PDF資料下載
參數資料
| 型號： | MAX1760EUB |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | 0.8A, Low-Noise, 1MHz, Step-Up DC-DC Converter |
| 中文描述： | 1.6 A SWITCHING REGULATOR, 1200 kHz SWITCHING FREQ-MAX, PDSO10 |
| 封裝： | MO-187C-BA, MICRO, SOP-10 |
| 文件頁數： | 8/12頁 |
| 文件大小： | 417K |
| 代理商： | MAX1760EUB |
M
0.8A, Low-Noise, 1MHz,
Step-Up DC-DC Converter
8
_______________________________________________________________________________________
output filter capacitor and the load. As the energy
stored in the inductor is depleted, the current ramps
down and the synchronous rectifier turns off. At light
loads, the device operates at fixed frequency or only as
needed to maintain regulation, depending on the
CLK/SEL setting (Table 2).
Normal Operation
Pulling CLK/SEL low selects the MAX1760
’
s normal
operating mode. In this mode, the device operates in
PWM when driving medium-to-heavy loads, and auto-
matically switches to PFM if the load requires less
power. PFM operation allows higher efficiency than
PWM under light load conditions.
Forced PWM Operation
When CLK/SEL is high, the MAX1760 operates in a low-
noise PWM-only mode. During forced PWM operation,
the MAX1760 switches at a constant frequency (1MHz),
and modulates the MOSFET switch pulse width to con-
trol the power transferred per cycle to regulate the out-
put voltage. Switching harmonics generated by
fixed-frequency operation are consistent and easily fil-
tered. See the Noise Spectrum plot in the
Typical
Operating Characteristics.
Synchronized PWM Operation
The MAX1760 can be synchronized in PWM mode to an
external frequency of 500kHz to 1.2MHz by applying an
external clock signal to CLK/SEL. This allows interfer-
ence to be minimized in wireless applications. The syn-
chronous rectifier is active during synchronized PWM
operation.
Synchronous Rectifier
The MAX1760 features an internal, P-channel synchro-
nous rectifier to enhance efficiency. Synchronous recti-
fication provides 5% improved efficiency over similar
nonsynchronous boost regulators. In PWM mode, the
synchronous rectifier is turned on during the second
half of each switching cycle. In low-power mode, an
internal comparator turns on the synchronous rectifier
when the voltage at LX exceeds the boost regulator
output, and turns it off when the inductor current drops
below 60mA. When setting output voltages greater than
4V, an external 0.5A Schottky diode must be connected
in parallel with the on-chip synchronous rectifier.
Low-Voltage Startup Oscillator
The MAX1760 uses a CMOS, low-voltage startup oscil-
lator for a 1.1V guaranteed minimum startup input volt-
age. At startup, the low-voltage oscillator switches the
N-channel MOSFET until the output voltage reaches
2.15V. Above this level, the normal boost-converter
feedback and control circuitry take over. Once the
device is in regulation, it can operate down to 0.7V
input since internal power for the IC is bootstrapped
from the output through OUT. Do not apply full load
until the output exceeds 2.3V.
Shutdown
The MAX1760 has a shutdown mode that reduces qui-
escent current to 0.1μA. During shutdown (
ON
= high),
the reference and all feedback and control circuitry are
off. During shutdown, the output voltage is one diode
drop below the input voltage.
Table 1. Typical Available Output Current
NUMBER OF NiCd/NiMH
CELLS
5.0
3.6
3
750
3.3
2.4
2
3.3
1.2
1
OUTPUT VOLTAGE
(V)
INPUT VOLTAGE
(V)
800
350
OUTPUT CURRENT
(mA)
5.0
2.4
500
Table 2. Selecting the Operating Mode
CLK/SEL
MODE
FEATURES
0
Normal Operation
High efficiency at all loads. Fixed frequency at all but light loads.
1
Forced PWM
Low noise, fixed frequency at all loads.
External Clock
500kHz to 1.2MHz
Synchronized PWM
Low noise, fixed frequency at all loads.
相關PDF資料 |
PDF描述 |
|---|---|
| MAX1761 | Small, Dual, High-Efficiency Buck Controller for Notebooks |
| MAX1761EEE | Replaced by TMS320VC5506 : Digital Signal Processor 100-LQFP |
| MAX1763 | 1.5A, Low-Noise, 1MHz, Step-Up DC-DC Converter |
| MAX1763EEE | 1.5A, Low-Noise, 1MHz, Step-Up DC-DC Converter |
| MAX1763EUE | Replaced by TMS320C6410 : Digital Signal Processors 68-PLCC -40 to 85 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX1760EUB+ | 功能描述:直流/直流開關轉換器 0.8A Low-Noise 1MHz Step-Up RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| MAX1760EUB+T | 功能描述:直流/直流開關轉換器 0.8A Low-Noise 1MHz Step-Up RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| MAX1760EUB-T | 功能描述:直流/直流開關轉換器 0.8A Low-Noise 1MHz Step-Up RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| MAX1760EVKIT | 功能描述:直流/直流開關轉換器 Evaluation Kit for the MAX1760 RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| MAX1760HETB | 制造商:Maxim Integrated Products 功能描述:0.8A, LOW-NOISE, 1MHZ, STEP-UP DC-DC CONVERTE - Rail/Tube |
發布緊急采購，3分鐘左右您將得到回復。