- 您現在的位置：買賣IC網 > PDF目錄384652 > MAX1602EEE (MAXIM INTEGRATED PRODUCTS INC) Single-Channel CardBus and PCMCIA VCC/VPP Power-Switching Network PDF資料下載
參數資料
| 型號： | MAX1602EEE |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | 運動控制電子 |
| 英文描述： | Single-Channel CardBus and PCMCIA VCC/VPP Power-Switching Network |
| 中文描述： | 2-CHANNEL, DBL POLE DBL THROW SWITCH, PDSO16 |
| 封裝： | 0.150 INCH, 0.025 INCH PITCH, QSOP-16 |
| 文件頁數： | 10/12頁 |
| 文件大小： | 130K |
| 代理商： | MAX1602EEE |
Figure 2. Application with Cirrus Logic Interface
M
S ingle-Channel CardBus and PCMCIA V CC/V PP
Power-S witc hing Network
10
______________________________________________________________________________________
independent of resistive and capacitive loads (see rise-
time photos in the Typical Operating Characteristics).
Fall times are a function of loading, and are compensat-
ed by internal circuitry.
Power savings is automatic: internal charge pumps draw
very low current when the VCC switches are static.
Standby mode reduces switch supply current to 11μA.
Operating Modes
The MAX1602 is compatible with the C irrus
CL-PD67XX, Databook DB86184, and Intel 82365SL PC
Card Interface Controllers (PCIC). Four control inputs
select the internal switches’ positions and the operating
modes according to the input code. Select the proper
code format for the chosen controller with the CODE
input pin (see Pin Description and Tables 1, 2, and 3).
CODE reconfigures the logic decoder to one of three
interface controllers:
Low = Standard “Intel” code (Figure 3)
High = “Cirrus” code (Figure 2)
Mid-supply = “Databook” code (Figure 4)
An additional 1μA (3μA max) of VY supply current will
flow if CODE = mid-supply (VY/2).
The MAX1602 has two operating modes: normal and
standby. Normal mode supplies the selected outputs
with their appropriate supply voltages. Standby mode
places all switches at ground, high impedance, or a
combination of the two.
Overc urrent Protec tion
Peak detecting circuitry protects both the VCC and VPP
switches against overcurrent conditions. When current
through any switch exceeds the internal current limit
(4A for VCC switches and 200mA for VPP switches) the
switch turns off briefly, then turns on again at the con-
trolled rise rate. If the overcurrent condition lasts more
than 2μs, the
FAULT
output goes low.
FAULT
is not
latched. A continuous short-circuit condition results in a
pulsed output current and a pulsed
FAULT
output until
thermal shutdown is reached.
FAULT
is open-drain and
requires an external pull-up resistor.
T hermal S hutdown
If the IC junction temperature rises above +150°C, the
thermal shutdown circuitry opens all switches, including
the GND switches, and
FAULT
is pulled low. When the
temperature falls below +130°C, the switches turn on
again at the controlled rise rate. If the overcurrent con-
dition remains, the part cycles between thermal shut-
down and overcurrent.
Undervoltage Loc kout
If the VX switch input voltage drops below 1.9V, the
associated switch turns off and
FAULT
goes low. For
example, if VY is 3.3V and VX is 0V, and if the interface
controller selects VY, the VCC output will be 3.3V. If VX
is selected, VCC changes to a high-impedance output
and
FAULT
goes low.
When a voltage is initially applied to 12IN, it must be
greater than 8V to allow the switch to operate.
Operation continues until the voltage falls below 2V
(the VPP output is high impedance).
When VY drops to less than 2.6V, all switches are
turned off and the VCC and VPP outputs are high
impedance.
__________Applic ations Information
S upply Bypassing
Bypass the VY, VX, and 12IN inputs with ceramic 0.1μF
capacitors. Bypass the VCC and VPP outputs with a
0.1μF capacitor for noise reduction and ESD protection.
VY
VY
VX
12IN
CODE
A:VPP_VCC
A:VPP_PGM
A:VCC_5
A:VCC_3
A0VPP
A1VPP
A0VCC
A1VCC
VCC
TOPC CARD SOCKET
SOCKET
INTERFACE
CIRRUS LOGIC
CL-PD6720
CL-PD6722
CL-PD6729
GND
VPP
V
CC
MAX1602
TOPC
CARD
SOCKET
GND
+3.3V
+5V
+12V
相關PDF資料 |
PDF描述 |
|---|---|
| MAX1606 | 16-Bit Bus Transceivers And Registers With 3-State Outputs 56-TSSOP -40 to 85 |
| MAX1606EUA | 28V Internal Switch LCD Bias Supply with True Shutdown |
| MAX1607ESA | USB Current-Limited Switch in Pin-Compatible Package |
| MAX1607 | USB Current-Limited Switch in Pin-Compatible Package |
| MAX1608 | 16-Bit Bus Transceivers And Registers With 3-State Outputs 56-TSSOP -40 to 85 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX1602EEE+ | 功能描述:電源開關 IC - 配電 CardBus & PCMCIA VCC VPP Pwr-Swt Net RoHS:否 制造商:Exar 輸出端數量:1 開啟電阻（最大值）:85 mOhms 開啟時間（最大值）:400 us 關閉時間（最大值）:20 us 工作電源電壓:3.2 V to 6.5 V 電源電流（最大值）: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-5 |
| MAX1602EEE+T | 功能描述:電源開關 IC - 配電 CardBus & PCMCIA VCC VPP Pwr-Swt Net RoHS:否 制造商:Exar 輸出端數量:1 開啟電阻（最大值）:85 mOhms 開啟時間（最大值）:400 us 關閉時間（最大值）:20 us 工作電源電壓:3.2 V to 6.5 V 電源電流（最大值）: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-5 |
| MAX1602EEE-T | 功能描述:電流和電力監控器、調節器 RoHS:否 制造商:STMicroelectronics 產品:Current Regulators 電源電壓-最大:48 V 電源電壓-最小:5.5 V 工作溫度范圍:- 40 C to + 150 C 安裝風格:SMD/SMT 封裝 / 箱體:HPSO-8 封裝:Reel |
| MAX16030TG+ | 功能描述:監控電路 Dual/Triple/Quad Sequencng/Suprvisory RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| MAX16030TG+T | 功能描述:監控電路 Dual/Triple/Quad Sequencng/Suprvisory RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。