- 您現在的位置：買賣IC網 > PDF目錄9858 > MAX13345EEBC+T (Maxim Integrated Products)IC TXRX USB FS 3WIRE 12-UCSP PDF資料下載
參數資料
| 型號： | MAX13345EEBC+T |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 2/18頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC TXRX USB FS 3WIRE 12-UCSP |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 2,500 |
| 類型： | 收發器 |
| 驅動器/接收器數： | 1/1 |
| 規程： | USB 2.0 |
| 電源電壓： | 2.3 V ~ 3.6 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 12-WFBGA，WLCSP |
| 供應商設備封裝： | 12-UCSP（3x4） |
| 包裝： | 帶卷 (TR) |
第1頁當前第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁
MAX13342E/MAX13345E
3-Wire Interface Full-Speed USB Transceivers
With/Without Internal Series Resistors
10
______________________________________________________________________________________
3-Wire DAT/SE0 Interface
The MAX13342E/MAX13345E use DAT and SE0 to
drive data or a single-ended zero onto the D+/D- lines.
When
OE is low, SE0 is an input and functions as a
single-ended zero driver. When SE0 is high, both D+
and D- are driven low. When SE0 is driven low, the
D+/D- outputs are controlled by DAT.
DAT is used to send data on D+/D- when both
OE and
SE0 are low. When DAT is high, D+ is driven high and
D- is driven low. When DAT is low, D+ is driven low and
D- is driven high.
In receive mode (
OE = high), DAT is the output of the
differential receiver connected to D+ and D-. SE0 only
goes active high when both D+ and D- are low.
Control Signals
USB Detection
The MA13342E/MAX13345E USB detection function
indicates that VBUS is present. The MAX13342E/
MAX13345E push-pull bus detection output (BD) moni-
tors VBUS, and asserts high when VBUS and VL are pre-
sent. BD asserts low if VBUS is less than +3.6V and
enters sharing mode.
OE
OE controls the direction of communication when VL
and VBUS are both present. When OE is low, DAT and
SE0 operate as logic inputs and D+/D - are outputs.
When
OE is high, DAT and SE0 operate as logic out-
puts and D+/D- are inputs.
SUS
SUS determines whether the MAX13342E/MAX13345E
operate in normal mode or in suspend mode. Drive
SUS low for normal operation. Drive SUS high to enable
suspend mode. In suspend mode, the single-ended
receivers (D+/D-) are active to detect a wake-up event.
Supply current decreases to less than 45A in suspend
mode.
The MAX13342E/MAX13345E can transmit data on D+
and D- while in suspend mode. This function is used to
signal a remote wake-up event.
ENUM
A 1.5k
pullup resistor on D+ is used to indicate full-
speed (12Mbps) operation. Drive ENUM high to con-
nect the internal pullup resistor from D+ to VTRM. Drive
ENUM low to disconnect the internal pullup resistor
from D+ to VTRM.
D+ and D-
D+ and D- are bidirectional signals and are ESD pro-
tected to ±15kV (HBM).
OE controls the direction of D+
and D- when in USB normal mode (Tables 3 and 4).
VTRM
An internal linear regulator generates the VTRM voltage
(+3.3V typ). VTRM derives power from VBUS (see the
Power-Supply Configuration section). VTRM powers the
internal USB circuitry and provides the pullup voltage
for the internal 1.5k
resistor. Bypass VTRM to GND
with a 1F ceramic capacitor as close to the device as
possible. Do not use VTRM to provide power to external
circuitry.
相關PDF資料 |
PDF描述 |
|---|---|
| MAX13342EETD+T | IC TXRX USB FS 3WIRE 14-TDFN |
| MS3101F20-23S | CONN RCPT 2POS FREE HNG W/SCKT |
| MAX13345EETD+T | IC TXRX USB FS 3WIRE 14-TDFN |
| MS3101A20-24S | CONN RCPT 4POS FREE HNG W/SCKT |
| MS27474P14A18P | CONN RCPT 18POS JAM NUT W/PINS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX13345EETD+T | 功能描述:USB 接口集成電路 Full-Speed 12Mbps USB Transceiver RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
| MAX13362ATL/V+ | 功能描述:監控電路 Automotive Contact Monitor RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| MAX13362ATL/V+T | 功能描述:監控電路 Automotive Contact Monitor RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| MAX13362EVKIT+ | 功能描述:界面開發工具 Evaluation Kit for the MAX13362 RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V |
| MAX13366GTE/V+ | 功能描述:板機接口霍耳效應/磁性傳感器 Auto Quad 2-Wire Hall Effect Sw Int RoHS:否 制造商:Honeywell 類型:Bipolar Hall-Effect Digital Position Sensor 工作電源電壓:3 V to 24 V 電源電流:3.5 mA 最大輸出電流:20 mA 工作點最小值/最大值:5 G, 55 G 最小/最大釋放點（Brp）:- 55 G, - 5 G 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23 |
發布緊急采購，3分鐘左右您將得到回復。