- 您現在的位置：買賣IC網 > PDF目錄1936 > MAX13223EEUP+T (Maxim Integrated Products)IC TXRX RS-232 2TX/2RX 20-TSSOP PDF資料下載
參數資料
| 型號： | MAX13223EEUP+T |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 10/12頁 |
| 文件大小： | 0K |
| 描述： | IC TXRX RS-232 2TX/2RX 20-TSSOP |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 2,500 |
| 類型： | 收發器 |
| 驅動器/接收器數： | 2/2 |
| 規程： | RS232 |
| 電源電壓： | 3 V ~ 5.5 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 20-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 20-TSSOP |
| 包裝： | 帶卷 (TR) |
Detailed Description
Figure 2 shows the receiver test circuit. Figure 3 shows
driver propagation delay and Figure 4 shows receiver
propagation delay.
Dual Charge-Pump Voltage Converter
The MAX13223E internal power supply consists of a
dual-mode regulated charge pump that provides output
voltages of +5.5V (doubling charge pump) and -5.5V
(inverting charge pump), regardless of the input volt-
age (VCC) over the +3.0V to +5.5V range. The charge
pumps operate in a discontinuous mode. If the output
voltages are less than 5.5V, the charge pumps are
enabled. If the output voltages exceed 5.5V, the charge
pumps are disabled. Each charge pump requires a fly-
ing capacitor (C1, C2) and a reservoir capacitor (C3,
C4) to generate the V+ and V- supplies.
RS-232 Transmitters
The transmitters are inverting level translators that convert
logic levels to EIA/TIA-232/V.28 levels. They guarantee a
250kbps data rate with worst-case loads of 3k
Ω in parallel
with 1000pF, providing compatibility with PC-to-PC com-
munication software. The MAX13223E can operate at data
rates of 250kbps (max). Transmitters can be paralleled to
drive multiple receivers. When FORCEOFF is driven to
ground, or the AutoShutdown circuitry senses invalid volt-
age levels at all receiver inputs, the transmitters are dis-
abled and the outputs are forced into a high-impedance
state. Figure 5 shows a complete system connection.
RS-232 Receivers
The MAX13223E’s receivers convert RS-232 signals to
logic output levels. Both receiver outputs can be three-
stated using the EN input. In shutdown (FORCEOFF or
AutoShutdown), the MAX13223E’s receiver outputs are
active and asserted low if EN = Low (Table 1). Driving
EN high places the receivers’ outputs in a high-imped-
ance state.
MAX13223E
±70V Fault-Protected, 3.0V to 5.5V,
2Tx/2Rx RS-232 Transceiver
_______________________________________________________________________________________
7
Pin Description
PIN
NAME
FUNCTION
1
EN
Receiver Enable Control Input. Drive EN low for normal operation. Drive EN high to force the receiver outputs
(R1OUT, R2OUT) into a high-impedance state.
2
C1+
Positive Terminal of the Voltage Doubler Charge-Pump Capacitor
3
V+
+5.5V Generated by Charge Pump
4
C1-
Negative Terminal of the Voltage Doubler Charge-Pump Capacitor
5
C2+
Positive Terminal of Inverting Charge-Pump Capacitor
6
C2-
Negative Terminal of Inverting Charge-Pump Capacitor
7
V-
-5.5V Generated by Charge Pump
8
T2OUT
RS-232 Transmitter 2 Output
9
R2IN
RS-232 Receiver 2 Input
10
R2OUT
Receiver 2 Logic Output
11
INVALID
Valid Signal Detector Output. INVALID is high if a valid RS-232 level is present on any receiver input.
12
T2IN
Transmitter 2 Logic Input
13
T1IN
Transmitter 1 Logic Input
14
FORCEON
Active-High FORCEON Input. Drive FORCEON high to override AutoShutdown, keeping transmitters and
charge pump on (FORCEOFF must be high).
15
R1OUT
Receiver 1 Logic Output
16
R1IN
RS-232 Receiver 1 Input
17
T1OUT
RS-232 Transmitter 1 Output
18
GND
Ground
19
VCC
+3.0V to +5.5V Supply Voltage. Bypass VCC with a 0.1F ceramic capacitor located as close to the device
as possible.
20
FORCEOFF
Active-Low FORCEOFF Input. Drive FORCEOFF low to shut down transmitters, receivers, and on-board
charge pumps, overriding AutoShutdown and FORCEON.
相關PDF資料 |
PDF描述 |
|---|---|
| MAX13234EAUP+ | TXRX RS-232 250KBPS 2X2 20TSSOP |
| MAX1329BETL+ | IC DAS 12BIT 300KSPS 40-TQFN-EP |
| MAX13342EEBC+T | IC TXRX USB FS 3WIRE 12-UCSP |
| MAX13410EESA+T | IC TXRX RS-485 LDO/CTRL 8-SOIC |
| MAX1342BETX+ | IC ADC/DAC 12BIT W/FIFO 36WQFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX1322ECM | 功能描述:模數轉換器 - ADC RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| MAX1322ECM+ | 功能描述:模數轉換器 - ADC 14-Bit 2Ch 526ksps 3V Precision ADC RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| MAX1322ECM+T | 功能描述:模數轉換器 - ADC 14-Bit 2Ch 526ksps 3V Precision ADC RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| MAX1322ECM-T | 功能描述:模數轉換器 - ADC RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| MAX13234EAUP+ | 功能描述:RS-232接口集成電路 3-5.5V 250Kbps RS232 Line Driver/Receiver RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
發布緊急采購，3分鐘左右您將得到回復。