- 您現在的位置：買賣IC網 > PDF目錄383313 > MAX1205 (Maxim Integrated Products, Inc.) +5v sINGLE-sUPPLY, 1mSPS, 14-bIT sELF-cALIBRATING adc PDF資料下載
參數資料
| 型號： | MAX1205 |
| 廠商： | Maxim Integrated Products, Inc. |
| 英文描述： | +5v sINGLE-sUPPLY, 1mSPS, 14-bIT sELF-cALIBRATING adc |
| 中文描述： | +5V單電源、1Msps、14位自校準ADC |
| 文件頁數： | 8/12頁 |
| 文件大?。?/td> | 127K |
| 代理商： | MAX1205 |
M
+5V S ingle-S upply, 1Msps, 14-Bit
S elf-Calibrating ADC
8
_______________________________________________________________________________________
Requirements for Referenc e
and Analog S ignal Inputs
Fully differential switched-capacitor circuits (SC) are
used for both the reference and analog inputs (Figure 2).
This allows either single-ended or differential signals to
be used in the reference and/or analog signal paths.
The signal voltage on these pins (INP, INN, RFN_,
RFP_) should never exceed the analog supply rail,
AV
DD
, and should not fall below ground.
Choic e of Referenc e
It is important to choose a low-noise reference, such as
the MAX6341, which can provide both excellent load
regulation and low temperature drift. The equivalent
input circuit for the reference pins is shown in Figure 3.
Note that the reference pins drive approximately 1k
of
resistance on chip. They also drive a switched capaci-
tor of 21pF. To meet the dynamic performance, the ref-
erence voltage is required to settle to 0.0015% within
one clock cycle. Accomplish this by choosing an
appropriate driving circuit (Figure 4). The capacitors at
the reference pins (RFPF, RFNF) provide the dynamic
charge required during each clock cycle, while the op
amps ensure accuracy of the reference signals. These
capacitors must have low dielectric-absorption charac-
teristics, such as polystyrene or teflon capacitors.
The reference pins can be connected to either single-
ended or differential voltages within the specified maxi-
mum levels. Typically the positive reference pin (RFPF)
would be driven to 4.096V, and the negative reference
pin (RFNF) connected to analog ground. There are
sense pins, RFPS and RFNS, which can be used with
RFPF
INP
INN
RFPF
CM
CM
RFNF
Figure 2. Simplified MDAC Architecture
RFPF
RFPS
RFNF
RFNS
Figure 3. Equivalent Input at the Reference Pins. The sense
pins should not draw any DC current.
STAGE1
7
DAV
INP
INN
CM
AV
DD
RFN_
RFP_
AGND
CLK
DV
DD
DGND
DRV
DD
ST_CAL
DOR
D13–D0
17
ADC
ADC
MDAC
8X
S/H
STAGE2
STAGE3
STAGE4
CORRECTION AND
CALIBRATION LOGIC
END_CAL
OE
OUTPUT DRIVERS
CLOCK
GENERATOR
MAX1205
Figure 1. Internal Block Diagram
相關PDF資料 |
PDF描述 |
|---|---|
| MAX1205EMH | +5v sINGLE-sUPPLY, 1mSPS, 14-bIT sELF-cALIBRATING adc |
| MAX1205CMH | +5v sINGLE-sUPPLY, 1mSPS, 14-bIT sELF-cALIBRATING adc |
| MAX121EAP | 308Ksps ADC with DSP Interface and 78dB SINAD |
| MAX121EWE | 308Ksps ADC with DSP Interface and 78dB SINAD |
| MAX121CAP | 308Ksps ADC with DSP Interface and 78dB SINAD |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX1205CMH | 制造商:Maxim Integrated Products 功能描述:44 PINS MQFP PKG - Bulk |
| MAX1205CMH+ | 制造商:Maxim Integrated Products 功能描述:ADC SGL PIPELINED 1MSPS 14BIT PARALLEL 44MQFP - Rail/Tube |
| MAX1205CMH+T | 制造商:Maxim Integrated Products 功能描述:ADC SGL PIPELINED 1MSPS 14BIT PARALLEL 44MQFP - Tape and Reel |
| MAX1205CMH-T | 制造商:Maxim Integrated Products 功能描述:44 PINS MQFP PKG - Tape and Reel |
| MAX1205EMH | 制造商:Maxim Integrated Products 功能描述:44 PINS MQFP PKG - Bulk |
發布緊急采購，3分鐘左右您將得到回復。