- 您現在的位置：買賣IC網 > PDF目錄17010 > MAX11635EVKIT+ (Maxim Integrated Products)KIT EVAL FOR 12-BIT ADCS 4-CH PDF資料下載
參數資料
| 型號： | MAX11635EVKIT+ |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 14/24頁 |
| 文件大小： | 0K |
| 描述： | KIT EVAL FOR 12-BIT ADCS 4-CH |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 1 |
| 系列： | * |
MAX11634–MAX11637
12-Bit, 300ksps ADCs with Differential
Track/Hold, and Internal Reference
______________________________________________________________________________________
21
Partial Reads and Partial Writes
If the first byte of an entry in the FIFO is partially read
(CS is pulled high after fewer than eight SCLK cycles),
the second byte of data that is read out contains the
next 8 bits (not b[7:0]). The remaining bits are lost for
that entry. If the first byte of an entry in the FIFO is read
out fully, but the second byte is read out partially, the
rest of the entry is lost. The remaining data in the FIFO
is uncorrupted and can be read out normally after tak-
ing CS low again, as long as the four leading bits (nor-
mally zeros) are ignored. Internal registers that are
written partially through the SPI contain new values,
starting at the MSB up to the point that the partial write
is stopped. The part of the register that is not written
contains previously written values. If CS is pulled low
before EOC goes low, a conversion cannot be complet-
ed and the FIFO is corrupted.
Transfer Function
Figure 8 shows the unipolar transfer function for single-
ended or differential inputs. Figure 9 shows the bipolar
transfer function for differential inputs. Code transitions
occur halfway between successive-integer LSB values.
Output coding is binary, with 1 LSB = VREF/4096 for
unipolar and bipolar operation, and 1 LSB = 0.125°C
for temperature measurements.
Layout, Grounding, and Bypassing
For best performance, use PC boards. Do not use wire-
wrap boards. Board layout should ensure that digital
and analog signal lines are separated from each other.
Do not run analog and digital (especially clock) signals
parallel to one another or run digital lines underneath the
MAX11634–MAX11637 package. High-frequency noise
in the VDD power supply can affect performance.
Bypass the VDD supply with a 0.1F capacitor to GND,
close to the VDD pin. Minimize capacitor lead lengths for
best supply-noise rejection. If the power supply is very
noisy, connect a 10
resistor in series with the supply to
improve power-supply filtering.
Definitions
Integral Nonlinearity
Integral nonlinearity (INL) is the deviation of the values
on an actual transfer function from a straight line. This
straight line can be either a best-straight-line fit or a line
drawn between the end points of the transfer function,
once offset and gain errors have been nullified. INL for
the MAX11634–MAX11637 is measured using the end-
point method.
Differential Nonlinearity
Differential nonlinearity (DNL) is the difference between
an actual step width and the ideal value of 1 LSB. A
DNL error specification of less than 1 LSB guarantees
no missing codes and a monotonic transfer function.
Aperture Jitter
Aperture jitter (tAJ) is the sample-to-sample variation in
the time between the samples.
Aperture Delay
Aperture delay (tAD) is the time between the rising
edge of the sampling clock and the instant when an
actual sample is taken.
CS
DOUT
SCLK
DIN
EOC
MSB1
LSB1
MSB2
(ACQUISITION1)
(ACQUISITION2)
(CONVERSION1)
(CONVERSION BYTE)
EXTERNALLY TIMED ACQUISITION, SAMPLING AND CONVERSION WITHOUT CNVST.
Figure 7. Clock Mode 11
相關PDF資料 |
PDF描述 |
|---|---|
| GMC13DREI | CONN EDGECARD 26POS .100 EYELET |
| VE-B2Y-EY | CONVERTER MOD DC/DC 3.3V 33W |
| MAX11617EVKIT+ | KIT EVALUATION FOR MAX11617 |
| PCM16XL0 | PROCESSOR MODULE FOR MPLAB-ICE |
| ECE-V1CA331P | CAP ALUM 330UF 16V 20% SMD |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX11635EVKIT+ | 功能描述:數據轉換 IC 開發工具 MAX11635 Eval Kit RoHS:否 制造商:Texas Instruments 產品:Demonstration Kits 類型:ADC 工具用于評估:ADS130E08 接口類型:SPI 工作電源電壓:- 6 V to + 6 V |
| MAX11635EVSYS# | 功能描述:數據轉換 IC 開發工具 MAX11635 Eval Kit RoHS:否 制造商:Texas Instruments 產品:Demonstration Kits 類型:ADC 工具用于評估:ADS130E08 接口類型:SPI 工作電源電壓:- 6 V to + 6 V |
| MAX11636 | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:12-Bit, 300ksps ADCs with Differential |
| MAX11636EEE+ | 功能描述:模數轉換器 - ADC 8Ch 12-Bit 300ksps w/FIFO & Int Ref RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| MAX11636EEE+T | 功能描述:模數轉換器 - ADC 8Ch 12-Bit 300ksps w/FIFO & Int Ref RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
發布緊急采購，3分鐘左右您將得到回復。