- 您現在的位置：買賣IC網 > PDF目錄2007 > MAX1104EUA+ (Maxim Integrated Products)IC CODEC 8BIT 8-UMAX PDF資料下載
參數資料
| 型號： | MAX1104EUA+ |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 7/17頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC CODEC 8BIT 8-UMAX |
| 標準包裝： | 50 |
| 類型： | 通用 |
| 數據接口： | * |
| 分辨率（位）： | 8 b |
| ADC / DAC 數量： | 1 / 1 |
| 三角積分調變： | 無 |
| 動態范圍，標準 ADC / DAC (db)： | 59 / 55 |
| 電壓 - 電源，模擬： | 2.7 V ~ 5.5 V |
| 電壓 - 電源，數字： | 2.7 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-TSSOP，8-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 8-uMAX |
| 包裝： | 管件 |
Two control words are necessary to enable the ADC.
The first control word brings the ADC out of shutdown,
and sets the T/H in acquisition mode. The second con-
trol word initiates the conversion.
Bit 2 (E2) controls the reference. A logic “1” enables
the reference, a logic “0” disables the reference, further
reducing power consumption.
Power Supply Bypassing and Layout
For best performance, use printed circuit boards. Wire-
wrap boards are not recommended. Board layout
should ensure that digital and analog signal lines are
separated from each other. Do not run analog and digi-
tal (especially clock) lines parallel to one another or run
digital lines underneath the device.
Figure 10 shows the recommended system-ground
connections. A single-point analog ground (star-ground
point) should be established at the device ground.
Connect all analog grounds to the star ground. No digi-
tal-system ground should be connected to this point.
The ground return to the power supply for the star
ground should be connected to this point. The ground
return to the power supply for the star ground should
be low impedance and as short as possible for noise-
free operation. High-frequency noise in the VDD power
supply may affect device performance. Bypass the
supply to the star ground with 0.1F and 1F capaci-
tors close to the device. Minimize capacitor lead
lengths for best supply-noise rejection. If the power
supply is very noisy, connect a 10
resistor in series
with VDD to form a lowpass filter.
MAX1102/MAX1103/MAX1104
8-Bit CODECs
______________________________________________________________________________________
15
GND
+3V/+5V
SYSTEM POWER SUPPLIES
VDD
DGND
VDD
1
F
10
0.1
F
GND
DIGITAL
CIRCUITRY
MAX1102
MAX1103
MAX1104
Figure 10. Power-Supply Connections
相關PDF資料 |
PDF描述 |
|---|---|
| MAX11100EUB+ | IC ADC 16BIT SRL 200KSPS 10UMAX |
| MAX11101EUB+ | IC ADC 14BIT SRL 200KSPS 10UMAX |
| MAX11102AUB+ | IC ADC 12BIT SPI/SRL 10UMAX-EP |
| MAX1111CPE+ | IC ADC 8BIT LP 16-DIP |
| MAX1113CPE+ | IC ADC 8BIT LP 16-DIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX1104EUA+ | 功能描述:ADC / DAC多通道 8-Bit CODEC RoHS:否 制造商:Texas Instruments 轉換速率: 分辨率:8 bit 接口類型:SPI 電壓參考: 電源電壓-最大:3.6 V 電源電壓-最小:2 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-40 |
| MAX1104EUA+T | 功能描述:ADC / DAC多通道 8-Bit CODEC RoHS:否 制造商:Texas Instruments 轉換速率: 分辨率:8 bit 接口類型:SPI 電壓參考: 電源電壓-最大:3.6 V 電源電壓-最小:2 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-40 |
| MAX1104EUA+TW | 功能描述:ADC / DAC多通道 8-Bit CODEC +2.7V to +5.5V Single Supply RoHS:否 制造商:Texas Instruments 轉換速率: 分辨率:8 bit 接口類型:SPI 電壓參考: 電源電壓-最大:3.6 V 電源電壓-最小:2 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-40 |
| MAX1104EUA+W | 功能描述:ADC / DAC多通道 8-Bit CODEC +2.7V to +5.5V Single Supply RoHS:否 制造商:Texas Instruments 轉換速率: 分辨率:8 bit 接口類型:SPI 電壓參考: 電源電壓-最大:3.6 V 電源電壓-最小:2 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-40 |
| MAX11054 | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:4-/6-/8-Channel, 16-/14-Bit, Simultaneous-Sampling ADCs |
發布緊急采購，3分鐘左右您將得到回復。