- 您現在的位置：買賣IC網 > PDF目錄376136 > M75012 (Electronic Theatre Controls, Inc.) PHOTOELECTRIC SMOKE DETECTOR WITH INTERCONNECT PDF資料下載
參數資料
| 型號： | M75012 |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | PHOTOELECTRIC SMOKE DETECTOR WITH INTERCONNECT |
| 中文描述： | 光電感煙探測器與互連 |
| 文件頁數： | 3/10頁 |
| 文件大小： | 177K |
| 代理商： | M75012 |
3/10
2006-10-05
PHOTOELECTRIC SMOKE DETECTOR
WITH INTERCONNECT
SMOKE DETECTOR
M75012
一華半導體股份有限公司
MOSDESIGN SEMICONDUCTOR CORP.
11
LED
This open-drain NMOS output is used to directly drive a visible LED. The low-battery test does not occur
coincident with any other test or alarm signal. The LED also indicates detector status as follows (with
component values as in the typical application , all times nominal)
：
Standby
─
Pulses every 43 seconds.
Local Smoke
─
Pulses every 0.67 seconds.
Remote Alarm
─
No pulses.
Test Mode
─
Pulses every 0.67 seconds.
12
OSCC
A capacitor between this pin and VDD, along with a parallel resistor , forms part of a two-terminal
oscillator and sets the internal clock low time. With component values as shown , this nominal time is 11
ms and essentially the oscillator period.
13
OSCR
A resistor between this pin and OSCC (pin 12 ) is part of the two-terminal oscillator and sets the internal
clock high time , which is also the I
RED
pulse width. With component values as shown , this nominal time is
105
μ
s .
14
VSS
This pin is connected to the most negative supply potential ( usually ground ).
15
TRIP
This pin is connected to an external voltage which determines the low-supply alarm threshold. The trip
voltage is obtained through a resistor divider connected between the VDD and LED pins. The low-supply
alarm threshold voltage ( in volts )
≒
( 5R15/R14 ) + 5 where R15 and R14 are in the same units.
16
TEST
This pin has an internal pull-down device and is used to manually invoke a test mode. The Push-to-Test
Mode is initiated by a high logic level on this pin ( usually the depression of a normally open push-button
switch to VDD ). After one oscillator cycle, I
RED
pulse every 336 ms ( nominal ) and amplifier gain is
increased by internal selection of C1. Background reflections in the smoke chamber can be used to
simulate a smoke condition. After the third I
RED
pulse , a successful test ( three consecutive simulated
smoke conditions ) activates the horn drivers and the I/O pin. When the push-button is released , the input
returns to VSS due to the internal pull down. After one oscillator cycle , the amplifier gain returns to
normal and after three additional I
RED
pulse ( less than one second ) , the device exits this mode and returns
to standby.
相關PDF資料 |
PDF描述 |
|---|---|
| M7615 | High noise immunity, Drive either Relay, Adjustable play on duration and latch duration, On-chip voltage regulator, 20 second warm-up., CDS input cond |
| M7616 | DC PIR CONTROLLER |
| M7G9 | MEDIUM CURRENT SILICON RECTIFIERS |
| M7P1 | MEDIUM CURRENT SILICON RECTIFIERS |
| M7P5 | MEDIUM CURRENT SILICON RECTIFIERS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M75018 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:IONIZATION SMOKE DETECTOR WITH INTERCONNECT |
| M7502 | 制造商:PETERMANN 制造商全稱:PETERMANN 功能描述:HIGH RELIABILITY FOR LOW COST |
| M750-3/8B | 制造商:Thomas & Betts 功能描述:SIDE BEAM BRACKET,M.I. |
| M750-H14-01W | 制造商:Methode Electronics Inc 功能描述: |
| M75140 | 制造商:John Deere 功能描述:Natural Metri-Pack TPA Lock |
發布緊急采購，3分鐘左右您將得到回復。