- 您現在的位置：買賣IC網 > PDF目錄45038 > M37906M4C-XXXFP 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDSO42 PDF資料下載
參數資料
| 型號： | M37906M4C-XXXFP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDSO42 |
| 封裝： | 0.450 INCH, 0.80 MM PITCH, PLASTIC, SSOP-42 |
| 文件頁數： | 29/99頁 |
| 文件大?。?/td> | 1313K |
| 代理商： | M37906M4C-XXXFP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁當前第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁
58
After that, the AT86RF212 switches to receive mode and expects an acknowledgement
response, which is indicated by register subfield TRAC_STATUS (register 0x02,
TRX_STATE) set to SUCCESS_WAIT_FOR_ACK. After a period of aTurnaroundTime
+ aUnitBackoff, the transmission of the ACK frame must have started. During the entire
transaction, including frame transmit, wait for ACK, and ACK receive, the radio
transceiver status register TRX_STATUS (register 0x01, TRX_STATUS) signals
BUSY_TX_ARET.
A successful reception of the acknowledgment frame is indicated by interrupt IRQ_3
(TRX_END). The status register TRX_STATUS (register 0x01, TRX_STATUS) changes
back to TX_ARET_ON. At the same time, register TRAC_STATUS changes to
SUCCESS or to SUCCESS_DATA_PENDING if the “Frame Pending” subfield of the
acknowledgment frame was set to 1.
Figure 5-13. Exemplary Timing of a TX_ARET Transaction (without Pending Data Bit set in ACK Frame)
Frame
on
Ai
r
5.2.5 Interrupt Handling
The interrupt handling in the Extended Operating Mode is similar to the Basic Operating
Mode. Interrupts can be enabled by setting the appropriate bit in register 0x0E
(IRQ_MASK).
For RX_AACK and TX_ARET, the following interrupts inform about the status of a
frame reception and transmission:
IRQ_2 (RX_START)
IRQ_3 (TRX_END)
IRQ_5 (AMI)
For RX_AACK mode, it is recommended to enable only interrupt IRQ_3 (TRX_END).
This interrupt is issued only if the Frame Filter (see section 6.2) reports a matching
address and the FCS is valid (see section 6.3). The usage of other interrupts is
optional.
On reception of a frame, the RX_START interrupt indicates the detection of a correct
synchronization header (SHR) and a non-zero PHY header (PHR). This interrupt is
issued after the PHR. AMI indicates address match, refer to filter rules in section 6.2.
AT86RF212
8168C-MCU Wireless-02/10
相關PDF資料 |
PDF描述 |
|---|---|
| M37906M8C-XXXFP | 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDSO42 |
| M37906M6C-XXXSP | 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDIP42 |
| M37906M4C-XXXFP | 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDSO42 |
| M37906M4C-XXXSP | 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDIP42 |
| M37906M4H-XXXSP | 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PDIP42 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M37906M4C-XXXSP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:16-BIT CMOS MICROCOMPUTER |
| M37906M4H-XXXFP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:16-BIT CMOS MICROCOMPUTER |
| M37906M6C-XXXFP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:16-BIT CMOS MICROCOMPUTER |
| M37906M6C-XXXSP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:16-BIT CMOS MICROCOMPUTER |
| M37906M8C-XXXFP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:16-BIT CMOS MICROCOMPUTER |
發布緊急采購，3分鐘左右您將得到回復。