- 您現在的位置：買賣IC網 > PDF目錄98005 > M34571G6FP 4-BIT, MROM, 6 MHz, MICROCONTROLLER, PDSO24 PDF資料下載
參數資料
| 型號： | M34571G6FP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 4-BIT, MROM, 6 MHz, MICROCONTROLLER, PDSO24 |
| 封裝： | 5.30 X 10.10 MM, 0.80 MM PITCH, PLASTIC, SSOP-24 |
| 文件頁數： | 81/126頁 |
| 文件大?。?/td> | 1776K |
| 代理商： | M34571G6FP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁當前第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁
Rev.1.02
May 25, 2007
Page 58 of 124
REJ03B0179-0102
4571 Group
(12)Prescaler
Stop prescaler counting and then execute the TABPS instruction
to read its data.
Stop prescaler counting and then execute the TPSAB instruction
to write data to prescaler.
(13)Timer count source
Stop timer 1, 2 or 3 counting to change its count source.
(14)Reading the count value
Stop timer 1, 2 or 3 counting and then execute the TAB1, TAB2
or TAB3 instruction to read its data.
(15)Writing to the timer
Stop timer 1, 2 or 3 counting and then execute the T1AB, T2AB,
T3AB or T3R3L instruction to write data to timer.
(16)Writing to reload register
In order to write a data to the reload register R1 while the timer 1
is operating, execute the TR1AB instruction except a timing of
the timer 1 underflow.
In order to write a data to the reload register R3H while the timer
3 is operating, execute the T3HAB instruction except a timing of
the timer 3 underflow.
(17)PWM signal
If the timer 3 count stop timing and the timer 3 underflow timing
overlap during output of the PWM signal, a hazard may occur in
the PWM output waveform.
When “H” interval expansion function of the PWM signal is
used, set “1” or more to reload register R3H.
Set the port C output latch to “0” to output the PWM signal from
C/CNTR1 pin.
(18)Prescaler, timer 1, timer 2 and timer 3 count start
timing and count time when operation starts
Count starts from the first rising edge of the count source (2) in
Time to first underflow (3) in Figure 61 is shorter (for up to 1
period of the count source) than time among next underflow (4)
in Figure 61 by the timing to start the timer and count source
operations after count starts.
When selecting CNTR0 input as the count source of timer 1,
timer 1 operates synchronizing with the count edge (falling edge
or rising edge) of CNTR0 input selected by software.
Fig 61. Timer count start timing and count time when
operation starts
(19)Watchdog timer
The watchdog timer function is valid after system is released
from reset. When not using the watchdog timer function,
execute the DWDT instruction and the WRST instruction
continuously, and clear the WEF flag to “0” to stop the
watchdog timer function.
The contents of WDF1 flag and timer WDT are initialized at
the RAM back-up mode.
When using the watchdog timer and the RAM back-up mode,
initialize the WDF1 flag with the WRST instruction just
before the microcomputer enters the RAM back-up state.
Also, set the NOP instruction after the WRST instruction, for
the case when a skip is performed with the WRST instruction.
(20)External clock
Be careful that the maximum value of the oscillation frequency
when using the external clock differs from the value when using
the ceramic resonator (refer to the recommended operating
condition).
Also, note that the RAM back-up mode (POF instruction) cannot
be used when using the external clock.
(21)QzROM
(1) Be careful not to apply overvoltage to MCU. The contents
of QzROM may be overwritten because of overvoltage.
Take care especially at turning on the power.
(2) As for the product shipped in blank, Renesas does not
perform the writing test to user ROM area after the
assembly process though the QzROM writing test is
performed enough before the assembly process. Therefore, a
writing error of approx.0.1 % may occur. Moreover, please
note the contact of cables and foreign bodies on a socket,
etc. because a writing environment may cause some writing
errors.
(22)Notes On ROM Code Protect (QzROM product
shipped after writing)
As for the QzROM product shipped after writing, the ROM code
protect is specified according to the ROM option setup data in
the mask file which is submitted at ordering.
The ROM option setup data in the mask file is “0016” for protect
enabled or “FF16” for protect disabled.
Note that the mask file which has nothing at the ROM option
data or has the data other than “0016” and “FF16” can not be
accepted.
Count source
(3)
(4)
(1) Timer start
(2)
Count source
(When falling edge of
CNTR0 input is selected)
Timer 1 value
Timer 1 underflow signal
32
1
0
3
2
1
0
3
2
相關PDF資料 |
PDF描述 |
|---|---|
| M34584EDFP | 4-BIT, OTPROM, 6 MHz, MICROCONTROLLER, PDSO42 |
| M35047-XXXSP | 24 X 12 CHARACTERS CRT CHAR DSPL CTLR, PDIP20 |
| M35047-XXXFP | 24 X 12 CHARACTERS CRT CHAR DSPL CTLR, PDSO20 |
| M35048-001FP | 24 X 12 CHARACTERS CRT CHAR DSPL CTLR, PDSO20 |
| M35049-XXXFP | 24 X 12 CHARACTERS CRT CHAR DSPL CTLR, PDSO20 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M34571G6-XXXFP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER |
| M34571GD | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER |
| M34571GDFP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER |
| M34571GD-XXXFP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER |
| M3458 | 功能描述:電纜固定件和配件 RLTCG 3/8 NPT BLACK NO NUT RoHS:否 制造商:Heyco 類型:Cable Grips, Liquid Tight 材料:Nylon 顏色:Black 安裝方法:Cable 最大光束直徑:11.4 mm 抗拉強度: |
發布緊急采購，3分鐘左右您將得到回復。