- 您現在的位置：買賣IC網 > PDF目錄45027 > M34282M1-XXXGP 4-BIT, MROM, 4 MHz, MICROCONTROLLER, PDSO20 PDF資料下載
參數資料
| 型號： | M34282M1-XXXGP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 4-BIT, MROM, 4 MHz, MICROCONTROLLER, PDSO20 |
| 封裝： | 0.225 INCH, 0.65 MM PITCH, PLASTIC, SSOP-20 |
| 文件頁數： | 15/70頁 |
| 文件大小： | 625K |
| 代理商： | M34282M1-XXXGP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁
MITSUBISHI
ELECTRIC
22
MITSUBISHI MICROCOMPUTERS
4282 Group
SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER
LIST OF PRECAUTIONS
Noise and latch-up prevention
Connect a capacitor on the following condition to prevent noise
and latch-up;
connect a bypass capacitor (approx. 0.01
F) between pins
VDD and VSS at the shortest distance,
equalize its wiring in width and length, and
use the thickest wire.
In the One Time PROM version, port E2 is also used as VPP
pin. Connect this pin to VSS through the resistor about 5 k
which is assigned to E2/VPP pin as close as possible at the
shortest distance.
Notes on unused pins
(Note in order to set the output latch to “0” to make pins open)
After system is released from reset, a port is in a high-
impedance state until the output latch of the port is set to
“0” by software.
Accordingly, the voltage level of pins is undefined and the
excess of the supply current may occur.
To set the output latch periodically is recommended
because the value of output latch may change by noise or
a program run away (caused by noise).
(Note when connecting to VSS and VDD)
Connect the unused pins to VSS and VDD at the shortest
distance and use the thick wire against noise.
Timer
Count source
Stop timer 1 or timer 2 counting to change its count source.
Watchdog timer
Be sure that the timing to execute the WRST instruction in
order to operate WDT efficiently.
Writing to reload register R1
When writing data to reload register R1 while timer 1 is
operating, avoid a timing when timer 1 underflows.
Timer 1 count operation
When the bit 5 of the watchdog timer (WDT) is selected as
the timer 1 count source, the error of maximum ± 256
s
(at the minimum instruction execution time : 8
s) is
generated from timer 1 start until timer 1 underflow. When
programming, be careful about this error.
Stop of timer 2
Avoid a timing when timer 2 underflows to stop timer 2.
Writing to reload register R2H
When writing data to reload register R2H while timer 2 is
operating, avoid a timing when timer underflows.
Timer 2 carrier wave output function
When to expand “H” interval of carrier wave is valid, set “1”
or more to reload register R2H.
Program counter
Make sure that the program counter does not specify after the
last page of the built-in ROM.
相關PDF資料 |
PDF描述 |
|---|---|
| M34286G2-XXXGP | 4-BIT, MROM, 4 MHz, MICROCONTROLLER, PDSO20 |
| M34286G2GP | 4-BIT, MROM, 4 MHz, MICROCONTROLLER, PDSO20 |
| M34502M4-XXXFP | 4-BIT, MROM, 4.4 MHz, MICROCONTROLLER, PDSO24 |
| M34502M2-XXXFP | 4-BIT, MROM, 4.4 MHz, MICROCONTROLLER, PDSO24 |
| M34506M4-XXXFP | 4-BIT, MROM, MICROCONTROLLER, PDSO20 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M34282M2 | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER |
| M34282M2-064GP | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER |
| M34282M2-XXXGP | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER |
| M34282T5-OPT | 制造商:Renesas Electronics Corporation 功能描述:DEV OPTION BOARD FOR 4282 GROUP/PC4400 - Boxed Product (Development Kits) |
| M34283 | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER |
發布緊急采購，3分鐘左右您將得到回復。