參數資料
型號: M34280
廠商: Mitsubishi Electric Corporation
英文描述: Single-Chip 4-Bit CMOS Microcomputer for Infrared Remote Control Transmitters(用于紅外線遠程遙控發送器的4位單片機)
中文描述: 單芯片4位CMOS紅外遙控發射器(用于紅外線遠程遙控發送器的4位單片機微機)
文件頁數: 17/47頁
文件大?。?/td> 508K
代理商: M34280
MITSUBISHI
ELECTRIC
17
MITSUBISHI MICROCOMPUTERS
4280 Group
SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER for INFRARED REMOTE CONTROL TRANSMITTERS
(1) Internal state at reset
Table 6 shows port state at reset, and Figure 19 shows internal
state at reset (they are retained after system is released from
reset).
The contents of timers, registers, flags and RAM except shown
in Figure 19 are undefined, so set the initial value to them.
Program counter (PC) ..............................................................
Address 0 in page 0 is set to program counter.
Power down flag (P).................................................................
Timer 1 underflow flag (T1F) ...................................................
Timer control register V1..........................................................
Carrier wave selection register C ............................................
Pull-down control register PU0 ................................................
Logic operation selection register LO ......................................
Most significant ROM code reference enable flag (URS)
Carry flag (CY) .........................................................................
Register A.................................................................................
Register B.................................................................................
Stack pointer (SP) ....................................................................
0
0
0
0
0
0
0
0
0
0
0
0
0
1
0
0
0
0
1
1
1
0
1
0
0
0
1
0
1
1
1
1
1
1
1
Fig. 19 Internal state at reset
Table 6 Port state at reset
Name
D
0
–D
6
D
7
G
0
–G
3
, E
2
E
0
, E
1
Note: The contents of all output latch is initialized to “0.”
State at reset
“H” output
“H” output
Input port (Pull-down transistor ON)
Input circuit OFF (Pull-down transistor OFF)
State after system is released from reset
High impedance state
Input circuit OFF (Pull-down transistor OFF)
Input port (Pull-down transistor ON)
Input port (Pull-down transistor OFF)
VOLTAGE DROP DETECTION CIRCUIT
The built-in drop detection circuit is designed to detect a drop in
voltage at operating and to reset the microcomputer if the supply
voltage drops below the specified value (Typ. 1.50 V) or less.
Fig. 20 Voltage drop detection circuit operation waveform
V
DD
Reset voltage
Internal reset signal
Microcomputer starts operation
after f(X
IN
) is counted to 16384 times.
The voltage drop detection circuit is stopped and power
dissipation is reduced at the RAM back-up mode, when the
functions except the RAM and pull-down control register (PU0)
are initialized.
相關PDF資料
PDF描述
M35060-001SP CONNECTOR ACCESSORY
M35060 Character Pattern Display Control IC(字符點陣顯示控制芯片)
M35060-056SP SCREEN CHARACTER and PATTERN DISPLAY CONTROLLERS
M35060-090SP SCREEN CHARACTER and PATTERN DISPLAY CONTROLLERS
M35060-002SP CONNECTOR ACCESSORY
相關代理商/技術參數
參數描述
M34280E1FP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER for INFRARED REMOTE CONTROL TRANSMITTERS
M34280E1GP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER for INFRARED REMOTE CONTROL TRANSMITTERS
M34280M1 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER for INFRARED REMOTE CONTROL TRANSMITTERS
M34280M1-060FP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER for INFRARED REMOTE CONTROL TRANSMITTERS
M34280M1-082GP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER for INFRARED REMOTE CONTROL TRANSMITTERS