• <ins id="eddke"><sup id="eddke"><dd id="eddke"></dd></sup></ins>
    參數資料
    型號: M32170F3VWG
    廠商: Mitsubishi Electric Corporation
    英文描述: 32-BIT RISC SINGLE-CHIP MICROCOMPUTER
    中文描述: 32位RISC單片機
    文件頁數: 10/49頁
    文件大?。?/td> 561K
    代理商: M32170F3VWG
    Mitsubishi Microcomputers
    10
    2001-5-14 Rev.1.0
    SINGLE-CHIP 32-BIT CMOS MICROCOMPUTER
    32170 Group, 32174 Group
    Table 5 Description of Pin Function (1/5 )
    Type
    Pin Name
    Description
    Input/Output
    Function
    Power
    VCCE
    Power supply
    Supplies power (5 V or 3.3V) to external I/O ports.
    supply
    VCCI
    Power supply
    Supplies power (3.3 V) to the internal logic.
    VDD
    RAM power supply
    nternal RAM backup power supply (3.3 V).
    FVCC
    Flash power supply —
    Internal flash memory backup power supply (3.3 V).
    VSS
    Ground
    Connect all VSS pins to ground (GND).
    Clock
    XIN,
    Clock
    Input
    Clock input/output pins. These pins contain a PLL-based
    XOUT
    Output
    frequency multiply-by-4, so input the clock whose frequency is quarter
    the operating frequency. (XIN input = 10 MHz when CPU clock operates
    at 40 MHz)
    BCLK /
    WR
    System clock
    Output
    When this signal is System Clock(BCLK), it outputs a clock whose is twice
    that of
    external inpout clock. (BCLK output = 20 MHz when CPU clock operates at 40
    MHz). Use this clock when circuits are synchronized externally.
    When this signal is Write(WR),during external write access it indicates the valid
    data on the data bus to transfer.
    OSC-VCC
    Power supply
    Power supply to the PLL circuit. Connect OSC-VCC to the power supply(3.3V)
    OSC-VSS
    Ground
    Connect OSC-VSS to ground.
    VCNT
    ______
    RESET
    PLL control
    Input
    This pin controls the PLL circuit. Connect a resistor and capacitor to this pin.
    Reset
    Reset
    Input
    This pin resets the internal circuits.
    Mode
    MOD0
    Mode
    Input
    These pins set an operation mode.
    MOD1
    MOD0 MOD1
    Mode
    0
    0
    Single-chip mode
    0
    1
    Expanded external mode
    1
    0
    Processor mode
    0
    0
    (Boot mode) (Note)
    1
    1
    (Reserved)
    Address
    bus
    A11-A30
    Address
    bus
    Output
    20 lines of address bus (A11-A30) are provided to accommodate two
    channels of 2 MB memory space (max.) connected external to the chip.
    A31 is not output.
    In the write cycle, of the 16-bit data bus the valid byte positions to write are
    output as BHW/ BHE and BLW/ BLE. In read cycle, data on the entire 16-bit
    data bus is read. However, only the data at the valid byte positions are
    transferred to the M32R’s internal circuit.
    Data bus
    DB0-DB15
    Data bus
    Input/output
    This 16-bit data bus connects to external device.
    Note: FP pin should be “H” level in Boot Mode.
    相關PDF資料
    PDF描述
    M32174F3VWG SINGLE-CHIP 32-BIT CMOS MICROCOMPUTER
    M32174F4VWG SINGLE-CHIP 32-BIT CMOS MICROCOMPUTER
    M32174F4VFP SINGLE-CHIP 32-BIT CMOS MICROCOMPUTER
    M32170F6VFG 32-BIT RISC SINGLE-CHIP MICROCOMPUTER
    M32170F6VFP SINGLE-CHIP 32-BIT CMOS MICROCOMPUTER
    相關代理商/技術參數
    參數描述
    M32170F4VFG 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:32-BIT RISC SINGLE-CHIP MICROCOMPUTER
    M32170F4VFP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 32-BIT CMOS MICROCOMPUTER
    M32170F4VFP#U0 制造商:Renesas Electronics Corporation 功能描述:SINGLE-CHIP 32-BIT CMOS MICROCOMPUTER
    M32170F4VWG 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 32-BIT CMOS MICROCOMPUTER
    M32170F6VFP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 32-BIT CMOS MICROCOMPUTER