- 您現在的位置：買賣IC網 > PDF目錄45010 > M30102M6T-XXXFP 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP48 PDF資料下載
參數資料
| 型號： | M30102M6T-XXXFP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP48 |
| 封裝： | 7 X 7 MM, 0.50 MM PITCH, PLASTIC, LQFP-48 |
| 文件頁數： | 39/166頁 |
| 文件大?。?/td> | 2060K |
| 代理商： | M30102M6T-XXXFP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁當前第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁
Under
development
Tentative Specifications REV.E1
Specifications in this manual are tentative and subject to change.
Mitsubishi microcomputers
M30100/M30102 Group
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
Usage precaution
130
Example 2:
INT_SWITCH2:
FCLR
I
; Disable interrupts.
AND.B
#00h, 0055h
; Clear T1IC int. priority level and int. request bit.
MOV.W
MEM, R0
; Dummy read.
FSET
I
; Enable interrupts.
Example 3:
INT_SWITCH3:
PUSHC
FLG
; Push Flag register onto stack
FCLR
I
; Disable interrupts.
AND.B
#00h, 0055h
; Clear T1IC int. priority level and int. request bit.
POPC
FLG
; Enable interrupts.
Note: The reason why two NOP instructions or dummy read were inserted before the FSET I for ex. 1 &
2 is to prevent interrupt enable flag from being set, due to the effects of instruction queue, before
the rewritten value of the interrupt control register takes effect.
When an instruction to rewrite the interrupt control register is executed while the interrupt is disabled,
depending on the instruction used for rewriting, there are times the interrupt request bit is not set even if
an interrupt request for that register has been generated. If this creates a problem, please use any of the
instructions below to rewrite the register.
Instructions : AND, OR, BCLR, BSET
Changing the interrupt request bit
When attempting to clear the interrupt request bit of an interrupt control register, the interrupt request bit
is not cleared sometimes. This will depend on the instruction. If this creates problems, use the below
instructions to change the register.
Instructions : MOV
Noise
(1) Bypass Capacitor between VCC and VSS Pins
Insert a bypass capacitor (at least 0.1
F) between VCC and VSS pins as noise and latch-up counter-
measures. In addition, make sure that connecting lines are the shortest and widest possible.
(2) Port Control Registers Data Read Error
During severe noise testing, mainly power supply system noise, and introduction of external noise, the
data of port related registers may changed. As a firmware countermeasure, it is recommended to peri-
odically re-set the port registers, port direction registers and pull-up control registers. However, you
should fully examine before introducing the re-set routine as conflicts may be created between this re-
set routine and interrupt routines (i. e. ports are switched during interrupts).
(3) CNVss pin wiring
In order to improve the pin tolerance to noise, insert a pull down resistance (about 5 k
) between CNVss
and Vss, and placed as close as possible to the CNVss pin.
相關PDF資料 |
PDF描述 |
|---|---|
| M30102M3-XXXFP | 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP48 |
| M30100M2T-XXXFP | 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP32 |
| M30102M3T-XXXFP | 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP48 |
| M30100M2-XXXFP | 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP32 |
| M30100F3TFP | 16-BIT, FLASH, 16 MHz, MICROCONTROLLER, PQFP32 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M30102T-PTC | 制造商:Renesas Electronics Corporation 功能描述:DEV 48PIN .5MM QFP CNVTR FOR M30100T-PRB - Bulk |
| M30-1050046 | 功能描述:集管和線殼 FML CRIMP CONTACT 1.25MM,AWG 26-30, RL RoHS:否 產品種類:1.0MM Rectangular Connectors 產品類型:Headers - Pin Strip 系列:DF50 觸點類型:Pin (Male) 節距:1 mm 位置/觸點數量:16 排數:1 安裝風格:SMD/SMT 安裝角:Right 端接類型:Solder 外殼材料:Liquid Crystal Polymer (LCP) 觸點材料:Brass 觸點電鍍:Gold 制造商:Hirose Connector |
| M30-1060046 | 功能描述:集管和線殼 FML CRIMP CONTACT 1.25MM,AWG 26-30,LSE RoHS:否 產品種類:1.0MM Rectangular Connectors 產品類型:Headers - Pin Strip 系列:DF50 觸點類型:Pin (Male) 節距:1 mm 位置/觸點數量:16 排數:1 安裝風格:SMD/SMT 安裝角:Right 端接類型:Solder 外殼材料:Liquid Crystal Polymer (LCP) 觸點材料:Brass 觸點電鍍:Gold 制造商:Hirose Connector |
| M3010A | 制造商:Honeywell Sensing and Control 功能描述:GENERAL MARKET VRS |
| M3010A25 | 制造商:Honeywell Sensing and Control 功能描述:GENERAL MARKET VRS |
發布緊急采購，3分鐘左右您將得到回復。