參數資料
型號： LV8105W
元件分類： 運動控制電子
英文描述： BRUSHLESS DC MOTOR CONTROLLER, 0.02 A, PQFP48
封裝： 7 X 7 MM, QFP-48
文件頁數： 13/21頁
文件大小： 202K
代理商： LV8105W
LV8105W
No.A1271-20/21
14. Low-voltage protection circuit
The LV8105W includes a low-voltage protection circuit to protect against incorrect operation when the VCC power is
applied or if the power supply voltage falls below its operating level. When the VCC voltage falls under the specified
voltage (VLVSD), all the outputs will be in the off state. If the VCC voltage rises to more than the hysteresis width
(
VLVSD), the low-voltage protection function is cancelled.
15. Power supply stabilization
Since this IC is used in applications that flow the large output current, the power supply line is subject to fluctuations.
Therefore, capacitors with capacitance adequate to stabilize the power supply voltage must be connected between the
VCC pin and GND. If diodes are inserted in the power supply line to prevent the IC destruction due to reverse power
supply connection, since this makes the power supply voltage even more subject to fluctuations, even larger
capacitance will be required.
16. Ground lines
The signal system GND and the output system GND must be separated, and connected to one GND at the connector. As
the large current flows to the output system GND, this GND line must be made as short as possible.
Output system GND : GND for Rf and VCC line capacitors
Signal system GND : GND for the IC and external components
17. Integrating amplifier
The integrating amplifier integrates the speed error pulses and phase error pulses and converts them to the speed
command voltage. At that time it also sets the control loop gain and the frequency characteristics. External components
of the integrating amplifier must be placed as close to the IC as possible to reduce influence of noise.
18. FG amplifier
The FG amplifier normally makes up a filter amplifier to reject noise. Since a clamp circuit has been added at the FG
amplifier output, the output amplitude is clamped at about 3.2Vp-p, even if the amplifier gain is increased.
After the FG amplifier, the Schmitt comparator on one side hysteresis(200mV (typical)) is inserted. The Schmitt
comparator output (FGS output) becomes high level when the FG amplifier output is lower than the FGIN+ voltage,
and becomes low level when the FG amplifier output is higher to more than Schmitt width as compared with the FGIN+
voltage. Therefore, it is desirable that the amplifier gain be set so that the output amplitude is over 1.0Vp-p at the lowest
controlled speed to be used.
The capacitor connected between the FGIN+ pin and GND is required for bias voltage stabilization. This capacitor
must be connected to the GND1 pin (pin 45) with a line that is as short as possible to reduce influence of noise.
As the FG amplifier and the FGS output are operating even if the S/S pin is the stop state, it is possible to monitor the
motor rotation by the FGS output.
相關PDF資料
PDF描述
LV8414CS STEPPER MOTOR CONTROLLER, 0.6 A, PBGA32
LV8481CS STEPPER MOTOR CONTROLLER, PBGA10
LV8731V STEPPER MOTOR CONTROLLER, PDSO44
LV8743V 0.8 A SWITCHING CONTROLLER, 440 kHz SWITCHING FREQ-MAX, PDSO44
LV8743V 0.8 A SWITCHING CONTROLLER, 440 kHz SWITCHING FREQ-MAX, PDSO44
相關代理商/技術參數
參數描述
LV8105W-MPB-E 功能描述:馬達/運動/點火控制器和驅動器 RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube
LV8105W-TLM-E 功能描述:馬達/運動/點火控制器和驅動器 BRUSHLESS MOTOR RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube
LV810FI 功能描述:IC CLK BUFF 1:10 133MHZ 20-SSOP RoHS:否 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘緩沖器，驅動器 系列:- 標準包裝:1 系列:HiPerClockS™ 類型:扇出緩沖器（分配），多路復用器 電路數:1 比率 - 輸入:輸出:2:18 差分 - 輸入:輸出:是/無 輸入:CML，LVCMOS，LVPECL，LVTTL，SSTL 輸出:LVCMOS，LVTTL 頻率 - 最大:250MHz 電源電壓:2.375 V ~ 3.465 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:32-LQFP 供應商設備封裝:32-TQFP（7x7） 包裝:- 其它名稱:800-1923-6
LV810FILF 功能描述:時鐘緩沖器 RoHS:否 制造商:Texas Instruments 輸出端數量:5 最大輸入頻率:40 MHz 傳播延遲（最大值）: 電源電壓-最大:3.45 V 電源電壓-最小:2.375 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LLP-24 封裝:Reel
LV810FILFT 功能描述:時鐘驅動器及分配 RoHS:否 制造商:Micrel 乘法/除法因子:1:4 輸出類型:Differential 最大輸出頻率:4.2 GHz 電源電壓-最大: 電源電壓-最小:5 V 最大工作溫度:+ 85 C 封裝 / 箱體:SOIC-8 封裝:Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*