參數資料
型號: LTM4600
廠商: Linear Technology Corporation
英文描述: 10A High Effi ciency DC/DC レModule
中文描述: 10A條高艾菲布缺陷直流/直流レ模塊
文件頁數: 10/24頁
文件大?。?/td> 370K
代理商: LTM4600
LTM4600
10
4600fa
APPLICATIU
the module input pins in the PCB layout to minimize the
trace inductance and high frequency AC noise.
W
U
U
Output Capacitors
The LTM4600 is designed for low output voltage ripple.
The bulk output capacitors C
OUT
is chosen with low enough
effective series resistance (ESR) to meet the output voltage
ripple and transient requirements. C
OUT
can be low ESR
tantalum capacitor, low ESR polymer capacitor or ceramic
capacitor (X5R or X7R). The typical capacitance is 200μF
if all ceramic output capacitors are used. The internally
optimized loop compensation provides sufficient stability
margin for all ceramic capacitors applications. Additional
output filtering may be required by the system designer,
if further reduction of output ripple or dynamic transient
spike is required. Refer to Table 2 for an output capaci-
tance matrix for each output voltage Droop, peak to peak
deviation and recovery time during a 5A/μs transient with
a specific output capacitance.
Fault Conditions: Current Limit and Over current
Foldback
The LTM4600 has a current mode controller, which inher-
ently limits the cycle-by-cycle inductor current not only in
steady state operation, but also in transient.
To further limit current in the event of an over load condi-
tion, the LTM4600 provides foldback current limiting. If the
output voltage falls by more than 50%, then the maximum
output current is progressively lowered to about one sixth
of its full current limit value.
Soft-Start and Latchoff with the RUN/SS pin
The RUN/SS pin provides a means to shut down the
LTM4600 as well as a timer for soft-start and over-cur-
rent latchoff. Pulling the RUN/SS pin below 0.8V puts
the LTM4600 into a low quiescent current shutdown (I
Q
≤ 75μA). Releasing the pin allows an internal 1.2μA cur-
rent source to charge up the timing capacitor CSS. Inside
LTM4600, there is an internal 1000pF capacitor from
RUN/SS pin to ground. If RUN/SS pin has an external
capacitor CSS_EXT to ground, the delay before starting
is about:
When the voltage on RUN/SS pin reaches 1.5V, the
LTM4600 internal switches are operating with a clamping
of the maximum output inductor current limited by the
RUN/SS pin total soft-start capacitance. As the RUN/SS pin
voltage rises to 3V, the soft-start clamping of the inductor
current is released.
t
V
A
C
pF
DELAY
SS EXT
_
=
μ
+
1 5
1 2
.
1000
.
(
)
V
IN
to V
OUT
Stepdown Ratios
There are restrictions in the maximum V
IN
to V
OUT
step
down ratio that can be achieved for a given input voltage.
These contraints are shown in the Typical Performance
Characteristics curves labeled “V
IN
to V
OUT
Stepdown
Ratio”. Note that additional thermal de-rating may apply.
See the Thermal Considerations and Output Current De-
Rating sections of this data sheet.
相關PDF資料
PDF描述
LTM4600EV 10A High Effi ciency DC/DC レModule
LTM4600EVPBF 10A High Effi ciency DC/DC レModule
LTM4600IVPBF 10A High Effi ciency DC/DC レModule
LU3X31FT Single-Port 3 V 10/100 Ethernet Transceiver TX/FX(單端口 3 V 10M位和100M位以太網收發器)
LU3X32FT Two-Port 3 V 10/100 Ethernet Transceiver TX/FX(雙端口 3 V 10M位和100M位以太網收發器)
相關代理商/技術參數
參數描述
LTM4600_06 制造商:LINER 制造商全稱:Linear Technology 功能描述:10A High Effi ciency DC/DC μModule
LTM4600EV 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Down 4.5V to 20V uModule 104-Pin LGA
LTM4600EV#PBF 功能描述:IC DC/DC UMODULE 10A 104-LGA RoHS:是 類別:電源 - 板載 >> DC DC Converters 系列:µModule® 設計資源:VI-200, VI-J00 Design Guide, Appl Manual 標準包裝:1 系列:* 類型:隔離 輸出數:1 電壓 - 輸入(最小):66V 電壓 - 輸入(最大):160V Voltage - Output 1:12V Voltage - Output 2:- Voltage - Output 3:- 電流 - 輸出(最大):* 電源(瓦) - 制造商系列:50W 電壓 - 隔離:* 特點:* 安裝類型:通孔 封裝/外殼:9-FinMod 尺寸/尺寸:4.60" L x 1.86" W x 0.79" H(116.8mm x 47.2mm x 20.1mm) 包裝:散裝 工作溫度:-25°C ~ 85°C 效率:* 電源(瓦特)- 最大:*
LTM4600EVPBF 制造商:Linear Technology 功能描述:10A DC/DC Module LTM4600EV
LTM4600HV 制造商:LINER 制造商全稱:Linear Technology 功能描述:Low VIN, 8A DC/DC Module Regulator with Tracking, Margining, and Frequency Synchronization