參數資料
型號: LTC487CS
廠商: LINEAR TECHNOLOGY CORP
元件分類: 通用總線功能
英文描述: Quad Low Power RS485 Driver
中文描述: QUAD LINE DRIVER, PDSO16
封裝: PLASTIC, SOL-16
文件頁數: 6/8頁
文件大?。?/td> 225K
代理商: LTC487CS
LTC487
6
U
S
A
Losses in a transmission line are a complex combination
of DC conductor loss, AC losses (skin effect), leakage, and
AC losses in the dielectric. In good polyethylene cables
such as the Belden 9841, the conductor losses and dielec-
tric losses are of the same order of magnitude, leading to
relatively low overall loss (Figure 7).
O
PPLICATI
U
U
FREQUENCY (MHz)
0.1
0.1
L
1.0
10
1.0
10
100
LTC487 TA08
Figure 7. Attenuation vs Frequency for Belden 9841
When using low loss cables, Figure 8 can be used as a
guideline for choosing the maximum line length for a given
data rate. With lower quality PVC cables, the dielectric loss
factor can be 1000 times worse. PVC twisted pairs have
terrible losses at high data rates (> 100kbs) and greatly
reduce the maximum cable length. At low data rates
however, they are acceptable and much more economical.
DATA RATE (bps)
10k
10
C
100
1k
10k
100k
1M
10M
LTC487 TA09
2.5M
Figure 8. Cable Length vs Data Rate
Cable Termination
The proper termination of the cable is very important. If the
cable is not terminated with its characteristic impedance,
distorted waveforms will result. In severe cases, distorted
(false) data and nulls will occur. A quick look at the output
of the driver will tell how well the cable is terminated. It is
best to look at a driver connected to the end of the cable,
since this eliminates the possibility of getting reflections
from two directions. Simply look at the driver output while
transmitting square wave data. If the cable is terminated
properly, the waveform will look like a square wave
(Figure 9).
Rt
DRIVER
DX
RECEIVER
RX
Rt = 120
Rt = 47
Rt = 470
LTC487 TA10
PROBE HERE
Figure 9. Termination Effects
If the cable is loaded excessively (47
), the signal initially
sees the surge impedance of the cable and jumps to an
initial amplitude. The signal travels down the cable and is
reflected back out of phase because of the mistermination.
When the reflected signal returns to the driver, the ampli-
tude will be lowered. The width of the pedestal is equal to
twice the electrical length of the cable (about 1.5ns/foot).
If the cable is lightly loaded (470
), the signal reflects in
phase and increases the amplitude at the driver output. An
input frequency of 30kHz is adequate for tests out to
4000 feet of cable.
相關PDF資料
PDF描述
LTC487IN Quad Low Power RS485 Driver
LTC487IS Quad Low Power RS485 Driver
LTC5533 300MHz to 11GHz Precision Dual RF Power Detector
LTC5533EDE 300MHz to 11GHz Precision Dual RF Power Detector
LTC660 100mA CMOS Voltage Converter
相關代理商/技術參數
參數描述
LTC487CSW 功能描述:IC DVR RS485 LOW PWR QUAD 16SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 標準包裝:27 系列:- 類型:收發器 驅動器/接收器數:3/3 規程:RS232,RS485 電源電壓:4.75 V ~ 5.25 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC 包裝:管件
LTC487CSW#PBF 功能描述:IC DVR RS485 LOW PWR QUAD 16SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 產品培訓模塊:RS-232 & USB Transceiver 標準包裝:2,000 系列:- 類型:收發器 驅動器/接收器數:1/1 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SSOP(0.209",5.30mm 寬) 供應商設備封裝:16-SSOP 包裝:帶卷 (TR) 其它名稱:296-19849-2
LTC487CSW#PBF 制造商:Linear Technology 功能描述:RS485 Driver IC
LTC487CSW#TR 功能描述:IC DRIVER RS485 QUAD LP 16SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 標準包裝:27 系列:- 類型:收發器 驅動器/接收器數:3/3 規程:RS232,RS485 電源電壓:4.75 V ~ 5.25 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC 包裝:管件
LTC487CSW#TRPBF 功能描述:IC DVR RS485 LOW PWR QUAD 16SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 標準包裝:27 系列:- 類型:收發器 驅動器/接收器數:3/3 規程:RS232,RS485 電源電壓:4.75 V ~ 5.25 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC 包裝:管件