- 您現在的位置：買賣IC網 > PDF目錄44997 > LTC4352HMS#TRPBF (LINEAR TECHNOLOGY CORP) 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO12 PDF資料下載
參數資料
| 型號： | LTC4352HMS#TRPBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 電源管理 |
| 英文描述： | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO12 |
| 封裝： | LEAD FREE, PLASTIC, MSOP-12 |
| 文件頁數： | 16/16頁 |
| 文件大?。?/td> | 218K |
| 代理商： | LTC4352HMS#TRPBF |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁
LTC4352
9
4352fa
Figure 3. Start-up Waveform for Single MOSFET Application
VOLTAGE
(5V/DIV)
TIME (2.5ms/DIV)
4352 FO3
CPO
GATE
OUT
VIN, SOURCE
VCC
VIN = 5V
C2 = 0.1F
applicaTions inForMaTion
N-channelMOSFETs.Themaximumallowabledrain-source
voltage, BVDSS, must be higher than the supply voltages
as the full supply voltage can appear across the MOSFET
when the input falls to 0V.
The FAULT pin pulls low to signal an open MOSFET fault
whenever the forward voltage drop across the enhanced
MOSFET exceeds 250mV. The RDS(ON) should be small
enough to conduct the maximum load current while not
triggering such a fault (when using FAULT), and to stay
within the MOSFET’s power rating at the maximum load
current.
CPO Capacitor Selection
The recommended value of the capacitor between the
CPO and SOURCE pins is approximately 10x the input
capacitance, CISS, of the MOSFET. A larger capacitor takes
a correspondingly longer time to charge up by the internal
charge pump. A smaller capacitor suffers more voltage
drop during a fast gate turn-on event as it shares charge
with the MOSFET gate capacitance.
CPO and GATE Start-Up
In single MOSFET applications, CPO is initially pulled up
to a diode below the SOURCE pin (Figure 3). In back-to-
back MOSFET applications, CPO starts off at 0V, since
SOURCE is near ground (Figure 4). CPO starts ramping
up 10s after VCC clears its undervoltage lockout level.
Another 40s later, GATE will also start ramping up with
CPO if UV, OV and VIN – OUT conditions allow it to. The
ramp rate is decided by the CPO pull-up current into the
combined CPO and GATE pin capacitances. An internal
clamp limits the CPO voltage to 6.7V above SOURCE,
while the final GATE voltage is determined by the forward
drop servo amplifier.
MOSFET Selection
The LTC4352 drives N-channel MOSFETs to conduct the
load current. The important features of the MOSFET are
its threshold voltage, the maximum drain-source voltage
BVDSS, and the on-resistance RDS(ON).
ThegatedrivefortheMOSFETisguaranteedtobebetween
5V and 7.5V. This allows the use of logic level threshold
Figure 4. Start-up Waveform for Back-to-Back MOSFET Application
VOLTAGE
(5V/DIV)
TIME (2.5ms/DIV)
4352 FO4
CPO
GATE
OUT
VIN
VCC
VIN = 5V
C2 = 0.1F
相關PDF資料 |
PDF描述 |
|---|---|
| LTC4352HDD#PBF | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO12 |
| LTC4352HDD#TRPBF | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO12 |
| LTC4357HMS8#PBF | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 |
| LTC4357HDCB#TRMPBF | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO6 |
| LTC4357HDCB#TRPBF | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO6 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC4352IDD#PBF | 功能描述:IC IDEAL DIODE CNTRL 12-DFN RoHS:是 類別:集成電路 (IC) >> PMIC - O 圈控制器 系列:- 標準包裝:1,000 系列:- 應用:電池備份，工業/汽車，大電流開關 FET 型:- 輸出數:5 內部開關:是 延遲時間 - 開啟:100ns 延遲時間 - 關閉:- 電源電壓:3 V ~ 5.5 V 電流 - 電源:250µA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC N 包裝:帶卷 (TR) |
| LTC4352IDD#TRPBF | 功能描述:IC IDEAL DIODE CNTRL 12-DFN RoHS:是 類別:集成電路 (IC) >> PMIC - O 圈控制器 系列:- 標準包裝:1,000 系列:- 應用:電池備份，工業/汽車，大電流開關 FET 型:- 輸出數:5 內部開關:是 延遲時間 - 開啟:100ns 延遲時間 - 關閉:- 電源電壓:3 V ~ 5.5 V 電流 - 電源:250µA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC N 包裝:帶卷 (TR) |
| LTC4352IMS#PBF | 功能描述:IC IDEAL DIODE CNTRL 12-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - O 圈控制器 系列:- 標準包裝:1,000 系列:- 應用:電池備份，工業/汽車，大電流開關 FET 型:- 輸出數:5 內部開關:是 延遲時間 - 開啟:100ns 延遲時間 - 關閉:- 電源電壓:3 V ~ 5.5 V 電流 - 電源:250µA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC N 包裝:帶卷 (TR) |
| LTC4352IMS#TRPBF | 功能描述:IC IDEAL DIODE CNTRL 12-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - O 圈控制器 系列:- 標準包裝:1,000 系列:- 應用:電池備份，工業/汽車，大電流開關 FET 型:- 輸出數:5 內部開關:是 延遲時間 - 開啟:100ns 延遲時間 - 關閉:- 電源電壓:3 V ~ 5.5 V 電流 - 電源:250µA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC N 包裝:帶卷 (TR) |
| LTC4352IMSPBF | 制造商:Linear Technology 功能描述:Ideal Diode Controller Monitoring MSOP12 |
發布緊急采購，3分鐘左右您將得到回復。