- 您現在的位置：買賣IC網 > PDF目錄44996 > LTC4259CGW#PBF (LINEAR TECHNOLOGY CORP) 4-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO36 PDF資料下載
參數資料
| 型號： | LTC4259CGW#PBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 電源管理 |
| 英文描述： | 4-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO36 |
| 封裝： | 0.300 INCH, PLASTIC, SSOP-36 |
| 文件頁數： | 5/32頁 |
| 文件大?。?/td> | 324K |
| 代理商： | LTC4259CGW#PBF |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
LTC4259
13
4259i
APPLICATIO S I FOR ATIO
WU
UU
Figure 11. System Diagram
OVERVIEW
Over the years, twisted-pair Ethernet has become the most
commonly used method for local area networking. The
IEEE 802.3 group, the originator of the Ethernet standard,
has defined an extension to the standard, known as
802.3af, which allows DC power to be delivered simulta-
neously over the same cable used for data communica-
tion. This promises a whole new class of Ethernet devices,
including IP telephones, wireless access points, and PDA
charging stations, which do not require additional AC
wiring or external power transformers, a.k.a. “wall warts.”
With about 13W of power available, small data devices can
be powered by their Ethernet connection, free from AC wall
outlets. Sophisticated detection and power monitoring
techniques prevent damage to legacy data-only devices,
while still supplying power to newer, Ethernet-powered
devices over the twisted-pair cable.
A device that supplies power is called Power Sourcing
Equipment (PSE); a device that draws power from the
wire is called a Powered Device (PD). A PSE is typically
an Ethernet switch, router, hub, or other network switch-
ing equipment that is commonly found in the wiring
closets where cables converge. PDs can take many forms:
digital IP telephones, wireless network access points,
PDA or notebook computer docking stations, cell phone
chargers, and HVAC thermostats are examples of devices
that can draw power from the network.
A PSE is required to provide a nominal 48V DC between
either the signal pairs or the spare pairs (but not both) as
shown in Figure 11. The power is applied as a voltage
between two of the pairs, typically by powering the center-
taps of the isolation transformers used to couple the
differential data signals to the wire. Since Ethernet data is
transformer coupled at both ends and is sent differentially,
a voltage difference between the transmit pairs and the
receive pairs does not affect the data. A 10/100base-T
Ethernet connection only uses 2 of the 4 pairs in the cable.
The unused or spare pairs can be powered directly, as
shown in Figure 11, without affecting the data. However,
1000base-T uses all 4 pairs and power must be connected
to the transformer center taps if compatibility with
1000base-T is required.
The LTC4259 provides a complete solution for detection
and powering of PD devices in an IEEE 802.3af compliant
system. The LTC4259 consists of four independent ports,
each with the ability to detect, classify, and provide iso-
lated –48V power to a PD device connected to it. The
LTC4259 senses removal of a PD with IEEE 802.3af
compliant AC or DC methods and turns off –48V power
when the PD is removed. A global control circuit takes care
of system configuration and timing, and uses an I2C
interface to communicate with the host system.
4259 F11
PHY
(NETWORK
PHYSICAL
LAYER
CHIP)
PHY
(NETWORK
PHYSICAL
LAYER
CHIP)
SMAJ58A
58V
≤0.1F
SMAJ58A
58V
≤0.1F
SIGNAL PAIR
VEE
SENSE GATE OUT
VDD
INT
SCL
SDAIN
SDAOUT
BAV19WS
10k
1k
×4
0.5
IRFM120A
S1B
SPARE PAIR
1/4
LTC4259
DGND
AGND
DETECT
I2C
3.3V
INTERRUPT
–48V
1N4002
CAT 5
20
MAX
ROUNDTRIP
0.05
F MAX
RJ45
PSE
PD
RCLASS
–48VIN
PWRGD
–48VOUT
LTC4257
GND
DC/DC
CONVERTER
5
F ≤ CIN
≤ 300F
+
–
VOUT
GND
0.22
F
100V
×4
相關PDF資料 |
PDF描述 |
|---|---|
| LTC4259CGW | 4-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO36 |
| LTC4267CGN-1#TR | 1 A SWITCHING CONTROLLER, 240 kHz SWITCHING FREQ-MAX, PDSO16 |
| LTC4267IGN-1 | 1 A SWITCHING CONTROLLER, 240 kHz SWITCHING FREQ-MAX, PDSO16 |
| LTC4267CGN-1 | 1 A SWITCHING CONTROLLER, 240 kHz SWITCHING FREQ-MAX, PDSO16 |
| LTC4270BIUKG#TRPBF | SPECIALTY ANALOG CIRCUIT, PQCC52 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC4260 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:UV, OV and Reverse Supply Protection Controller Low Operating Current: 125μA |
| LTC4260CGN | 制造商:Linear Technology 功能描述:Hot Swap Controller 1-CH 80V 24-Pin SSOP N |
| LTC4260CGN#PBF | 功能描述:IC CTLR HOT SWAP I2C 24-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:119 系列:- 類型:熱交換控制器 應用:通用型，PCI Express? 內部開關:無 電流限制:- 電源電壓:3.3V，12V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:80-TQFP 供應商設備封裝:80-TQFP（12x12） 包裝:托盤 產品目錄頁面:1423 (CN2011-ZH PDF) |
| LTC4260CGN#TR | 制造商:Linear Technology 功能描述:Hot Swap Controller 1-CH 80V 24-Pin SSOP N T/R |
| LTC4260CGN#TRPBF | 功能描述:IC HOT SWAP CNTRL I2C 24-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:119 系列:- 類型:熱交換控制器 應用:通用型，PCI Express? 內部開關:無 電流限制:- 電源電壓:3.3V，12V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:80-TQFP 供應商設備封裝:80-TQFP（12x12） 包裝:托盤 產品目錄頁面:1423 (CN2011-ZH PDF) |
發布緊急采購，3分鐘左右您將得到回復。