- 您現在的位置：買賣IC網 > PDF目錄44995 > LTC4012IUF-1#TRPBF (LINEAR TECHNOLOGY CORP) SWITCHING CONTROLLER, 633 kHz SWITCHING FREQ-MAX, PQCC20 PDF資料下載
參數資料
| 型號： | LTC4012IUF-1#TRPBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING CONTROLLER, 633 kHz SWITCHING FREQ-MAX, PQCC20 |
| 封裝： | 4 X 4 MM, 0.75 MM HEIGHT, LEAD FREE, PLASTIC, MO-220WGGD-1, QFN-20 |
| 文件頁數： | 7/28頁 |
| 文件大小： | 381K |
| 代理商： | LTC4012IUF-1#TRPBF |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
4012fa
LTC4012/
LTC4012-1/LTC4012-2
The ITH output of the error amplifier is a scaled control
voltage for one input of the PWM comparator CC. ITH
sets a peak inductor current threshold, sensed by R1, to
maintain the desired average current through RSENSE. The
currentcomparatoroutputdoesthisbyswitchingthestate
of the RS latch at the appropriate time.
At the beginning of each oscillator cycle, the PWM
clock sets the RS latch and turns on the external top-
side NFET (bottom-side synchronous NFET off) to
refresh the current carried by the external inductor L1.
The inductor current and voltage across RSENSE begin
to rise linearly. CA buffers this instantaneous voltage
rise and applies it to CC with gain supplied by R1.
When the voltage across R1 exceeds the peak level set by
the ITH output of EA, the top FET turns off and the bottom
FET turns on. The inductor current then ramps down lin-
early until the next rising PWM clock edge. This closes the
loop and sources the correct inductor current to maintain
the desired parameter (charge current, battery voltage,
or input current). To produce a near constant frequency,
the PWM oscillator implements the equation:
t
CLP BAT
CLP
kHz
OFF =
–
550
Repetitive, closed-loop waveforms for stable PWM opera-
tion appear in Figure 2.
PWM Watchdog Timer
Asinputandoutputconditionsvary,theLTC4012mayneed
toutilizePWMdutycyclesapproaching100%.Inthiscase,
operating frequency may be reduced well below 550kHz.
An internal watchdog timer observes the activity on the
TGATEpin.IfTGATEisonformorethan40s,thewatchdog
activates and forces the bottom NFET on (top NFET off)
for about 100ns. This avoids a potential source of audible
noise when using ceramic input or output capacitors and
prevents the boost supply capacitor for the top gate driver
from discharging. In low drop out operation, the actual
charge current may not be able to reach the programmed
full-scale value due to the watchdog function.
Overvoltage Protection
The LTC4012 also contains overvoltage detection that
preventstransientbatteryvoltageovershootsofmorethan
about 6% above the programmed output voltage. When
batteryovervoltageisdetected,bothexternalMOSFETsare
turned off until the overvoltage condition clears, at which
time a new soft start sequence begins. This is useful for
properlychargingbatterypacksthatuseaninternalswitch
to disconnect themselves for performing functions such
as calibration or pulse mode charging.
Reverse Charge Current Protection (Anti-Boost)
Because the LTC4012 always attempts to operate syn-
chronously in full continuous mode (to avoid audible
noise from ceramic capacitors), reverse average charge
current can occur during some invalid operating condi-
tions. INFET PowerPath control avoids boosting a lightly
loaded system supply during reverse operation. However,
under heavier system loads, CLP may not boost above
DCIN, even though reverse average current is flowing. In
this case a second circuit monitors indication of reverse
average current on PROG.
If either of these circuits detects boost operation, The
LTC4012 turns off both external MOSFETs until the reverse
current condition clears. At that point, a new soft-start
sequence begins.
operation
相關PDF資料 |
PDF描述 |
|---|---|
| LTC4012IUF#PBF | SWITCHING CONTROLLER, 633 kHz SWITCHING FREQ-MAX, PQCC20 |
| LTC4065EDC-4.4#PBF | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO6 |
| LTC4070IDDB#TRPBF | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 |
| LTC4070EMS8E#TRPBF | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 |
| LTC4070EDDB#TRPBF | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC4012IUF-2#PBF | 功能描述:IC BATT CHRGR MC HI-EFF 20-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 功能:電池監控器 電池化學:堿性，鋰離子，鎳鎘，鎳金屬氫化物 電源電壓:1 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-6 包裝:帶卷 (TR) |
| LTC4012IUF-2#TRPBF | 功能描述:IC CTLR BATT CHARGER CC/CV 20QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 功能:電池監控器 電池化學:堿性，鋰離子，鎳鎘，鎳金屬氫化物 電源電壓:1 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-6 包裝:帶卷 (TR) |
| LTC4012IUF-3#PBF | 功能描述:IC BATT CHRGR MC HI-EFF 20-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 功能:電池監控器 電池化學:堿性，鋰離子，鎳鎘，鎳金屬氫化物 電源電壓:1 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-6 包裝:帶卷 (TR) |
| LTC4012IUF-3#TRPBF | 功能描述:IC CTLR BATT CHARGER CC/CV 20QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 功能:電池監控器 電池化學:堿性，鋰離子，鎳鎘，鎳金屬氫化物 電源電壓:1 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-6 包裝:帶卷 (TR) |
| LTC4012IUF-3-PBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:High Efficiency, Multi-Chemistry Battery Charger with PowerPath Control |
發布緊急采購，3分鐘左右您將得到回復。