- 您現在的位置：買賣IC網 > PDF目錄30771 > LTC3867IUF#PBF (LINEAR TECHNOLOGY CORP) 0.1 A SWITCHING CONTROLLER, 1200 kHz SWITCHING FREQ-MAX, PQCC24 PDF資料下載
參數資料
| 型號： | LTC3867IUF#PBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 0.1 A SWITCHING CONTROLLER, 1200 kHz SWITCHING FREQ-MAX, PQCC24 |
| 封裝： | 4 X 4 MM, LEAD FREE, PLASTIC, MO-220WGGD, QFN-24 |
| 文件頁數： | 4/36頁 |
| 文件大?。?/td> | 380K |
| 代理商： | LTC3867IUF#PBF |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
LTC3867
12
3867f
Light Load Current Operation (Burst Mode Operation,
Pulse-Skipping or Continuous Conduction)
The LTC3867 can be enabled to enter high efficiency Burst
Modeoperation,constant-frequencypulse-skippingmode
or forced continuous conduction mode. To select forced
continuous operation, tie the MODE pin to SGND. To select
pulse-skipping mode of operation, tie the MODE/PLLIN
pin to INTVCC. To select Burst Mode operation, float the
MODE/PLLIN pin. When the controller is enabled for Burst
Mode operation, the peak current in the inductor is set to
approximately one-third of the maximum sense voltage
even though the voltage on the ITH pin indicates a lower
value. If the average inductor current is higher than the
load current, the error amplifier, EA, will decrease the
voltage on the ITH pin. When the ITH voltage drops below
0.5V, the internal sleep signal goes high (enabling “sleep”
mode) and both external MOSFETs are turned off.
In sleep mode, the load current is supplied by the output
capacitor. As the output voltage decreases, the EA’s output
begins to rise. When the output voltage drops enough, the
sleep signal goes low, and the controller resumes normal
operation by turning on the top external MOSFET on the
next cycle of the internal oscillator. When the controller
is enabled for Burst Mode operation, the inductor current
is not allowed to reverse. The reverse current comparator
(IREV) turns off the bottom external MOSFET just before
the inductor current reaches zero, preventing it from re-
versing and going negative. Thus, the controller operates
in discontinuous operation.
In forced continuous operation, the inductor current is
allowed to reverse at light loads or under large transient
conditions. The peak inductor current is determined by
the voltage on the ITH pin, just as in normal operation. In
this mode, the efficiency at light loads is lower than in
Burst Mode operation. However, continuous mode has the
advantages of lower output ripple and less interference
with audio circuitry.
When the MODE/PLLIN pin is connected to INTVCC, the
LTC3867 operates in PWM pulse skipping mode at light
loads. At very light loads, the current comparator, ICMP,
mayremaintrippedforseveralcyclesandforcetheexternal
top MOSFET to stay off for the same number of cycles (i.e.,
skipping pulses). The inductor current is not allowed to
reverse (discontinuous operation). This mode, like forced
continuous operation, exhibits low output ripple as well as
low audio noise and reduced RF interference as compared
to Burst Mode operation. It provides higher low current
efficiency than forced continuous mode, but not nearly as
high as Burst Mode operation.
Frequency Selection and Phase-Locked Loop
(FREQ and MODE/PLLIN Pins)
Theselectionofswitchingfrequencyisatrade-offbetween
efficiency and component size. Low frequency opera-
tion increases efficiency by reducing MOSFET switching
losses, but requires larger inductance and/or capacitance
to maintain low output ripple voltage.
If the MODE/PLLIN pin is not being driven by an external
clock source, the FREQ pin can be used to program the
controller’s operating frequency from 200kHz to 1.2MHz.
There is a precision 20A current flowing out of the FREQ
pin so that the user can program the controller’s switch-
ing frequency with a single resistor to SGND. A curve
is provided later in the Applications Information section
showing the relationship between the voltage on the FREQ
pin and switching frequency.
A phase-locked loop (PLL) is available on the LTC3867
to synchronize the internal oscillator to an external clock
source that is connected to the MODE/PLLIN pin. The PLL
loop filter network is integrated inside the LTC3867. The
phase-locked loop is capable of locking any frequency
withintherangeof250kHzto1.1MHz.Thefrequencysetting
resistor should always be present to set the controller’s
initial switching frequency before locking to the external
clock. The controller operates in forced continuous mode
when it is synchronized.
Sensing the Output Voltage with a
Differential Amplifier
The LTC3867 includes a low offset, high input impedance,
unity-gain, high bandwidth differential amplifier for ap-
plications that require true remote sensing. Sensing the
OPERATION
相關PDF資料 |
PDF描述 |
|---|---|
| LTC4000IUFD#PBF | 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PQCC28 |
| LTC4000EUFD#PBF | 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PQCC28 |
| LTC4000EUFD#TRPBF | 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PQCC28 |
| LTC4000IUFD#TRPBF | 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PQCC28 |
| LTC4075XEDD | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO10 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3868EGN-1#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3868EGN-1#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3868EUFD-1#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 特色產品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 標準包裝:1 系列:PowerWise® PWM 型:電壓模式 輸出數:1 頻率 - 最大:1MHz 占空比:81% 電源電壓:4.5 V ~ 18 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-5°C ~ 125°C 封裝/外殼:32-WFQFN 裸露焊盤 包裝:Digi-Reel® 產品目錄頁面:1303 (CN2011-ZH PDF) 其它名稱:LM3754SQDKR |
| LTC3868EUFD-1#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3868EUH#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 特色產品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 標準包裝:1 系列:PowerWise® PWM 型:電壓模式 輸出數:1 頻率 - 最大:1MHz 占空比:81% 電源電壓:4.5 V ~ 18 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-5°C ~ 125°C 封裝/外殼:32-WFQFN 裸露焊盤 包裝:Digi-Reel® 產品目錄頁面:1303 (CN2011-ZH PDF) 其它名稱:LM3754SQDKR |
發布緊急采購，3分鐘左右您將得到回復。