參數資料
型號： LTC3865IFE#TRPBF
廠商： LINEAR TECHNOLOGY CORP
元件分類： 穩壓器
英文描述： DUAL SWITCHING CONTROLLER, 880 kHz SWITCHING FREQ-MAX, PDSO38
封裝： 4.40 MM, LEAD FREE, PLASTIC, TSSOP-38
文件頁數： 4/38頁
文件大?。?/td> 400K
代理商： LTC3865IFE#TRPBF
LTC3865/LTC3865-1
12
3865fb
OPERATION
Main Control Loop
The LTC3865/LTC3865-1 are constant-frequency, current
mode step-down controllers with two channels operating
180 degrees out-of-phase. During normal operation, each
top MOSFET is turned on when the clock for that channel
sets the RS latch, and turned off when the main current
comparator, ICMP, resets the RS latch. The peak inductor
current at which ICMP resets the RS latch is controlled
by the voltage on the ITH pin, which is the output of each
error amplier, EA (refer to the Functional Diagram). VFB
is the voltage feedback signal, which is compared to the
internal reference voltage by the EA. When the load current
increases, it causes a slight decrease in feedback voltage
relative to the 0.6V reference, which in turn causes the
ITH voltage to increase until the average inductor current
matches the new load current. After the top MOSFET has
turned off, the bottom MOSFET is turned on until either
the inductor current starts to reverse, as indicated by the
reverse current comparator IREV, or the beginning of the
next cycle.
INTVCC/EXTVCC Power
Power for the top and bottom MOSFET drivers and most
other internal circuitry is derived from the INTVCC pin.
When the EXTVCC pin is left open or tied to a voltage less
than 4.7V, an internal 5V linear regulator supplies INTVCC
power from VIN. If EXTVCC is taken above 4.7V, the 5V
regulator is turned off and an internal switch is turned
on connecting EXTVCC. Using the EXTVCC pin allows the
INTVCC power to be derived from a high efciency external
source such as one of the LTC3865/LTC3865-1 switching
regulator outputs.
Each top MOSFET driver is biased from the oating
bootstrap capacitor, CB, which normally recharges during
each off cycle through an external diode when the top
MOSFET turns off. If the input voltage VIN decreases to
a voltage close to VOUT, the loop may enter dropout and
attempt to turn on the top MOSFET continuously. The
dropout detector detects this and forces the top MOSFET
off for about one-twelfth of the clock period every third
cycle to allow CB to recharge. However, it is recommended
that a load be present during the drop-out transition to
ensure CB is recharged.
Shutdown and Start-Up (RUN1, RUN2 and TK/SS1,
TK/SS2 Pins)
The two channels of the LTC3865/LTC3865-1 can be
independently shut down using the RUN1 and RUN2 pins.
Pulling either of these pins below 1.22V shuts down the
main control loop for that controller. Pulling both pins
low disables both controllers and most internal circuits,
including the INTVCC regulator. Releasing either RUN pin
allows an internal 1μA current to pull up the pin and enable
that controller. Alternatively, the RUN pin may be externally
pulled up or driven directly by logic. Be careful not to exceed
the absolute maximum rating of 6V on this pin.
The start-up of each controller’s output voltage VOUT is
controlled by the voltage on the TK/SS1 and TK/SS2 pins.
When the voltage on the TK/SS pin is less than the 0.6V
internal reference, the LTC3865 regulates the VFB voltage
to the TK/SS pin voltage instead of the 0.6V reference.
This allows the TK/SS pin to be used to program a soft-
start by connecting an external capacitor from the TK/SS
pin to SGND. An internal 1.3μA pull-up current charges
this capacitor, creating a voltage ramp on the TK/SS pin.
As the TK/SS voltage rises linearly from 0V to 0.6V (and
beyond), the output voltage, VOUT, rises smoothly from
zero to its nal value. Alternatively the TK/SS pin can
be used to cause the start-up of VOUT to “track” that of
another supply. Typically, this requires connecting to the
TK/SS pin an external resistor divider from the other sup-
ply to ground (see the Applications Information section).
When the corresponding RUN pin is pulled low to disable
a controller, or when INTVCC drops below its undervoltage
lockout threshold of 3.3V, the TK/SS pin is pulled low by
an internal MOSFET. When in undervoltage lockout, both
controllers are disabled and the external MOSFETs are
held off.
Light Load Current Operation (Burst Mode Operation,
Pulse-Skipping or Continuous Conduction)
The LTC3865/LTC3865-1 can be enabled to enter high
efciency Burst Mode operation, constant-frequency pulse-
skipping mode, or forced continuous conduction mode. To
select forced continuous operation, tie the MODE/PLLIN
相關PDF資料
PDF描述
LTC3865EUH-1#PBF DUAL SWITCHING CONTROLLER, 880 kHz SWITCHING FREQ-MAX, PQCC32
LTC3865IUH#TRPBF DUAL SWITCHING CONTROLLER, 880 kHz SWITCHING FREQ-MAX, PQCC32
LTC3869IUFD#TRPBF SWITCHING CONTROLLER, PQCC28
LTC3869IUFD#PBF SWITCHING CONTROLLER, PQCC28
LTC3869EUFD#PBF SWITCHING CONTROLLER, PQCC28
相關代理商/技術參數
參數描述
LTC3865IUH#PBF 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3865IUH#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3865IUH-1#PBF 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3865IUH-1#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3866EFE#PBF 功能描述:IC REG CTRLR BUCK PWM CM 24TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,000 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:1MHz 占空比:50% 電源電壓:9 V ~ 10 V 降壓:無 升壓:是 回掃:是 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:8-TSSOP（0.173"，4.40mm 寬） 包裝:帶卷 (TR)
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*