- 您現在的位置：買賣IC網 > PDF目錄30771 > LTC3862HGN#PBF (LINEAR TECHNOLOGY CORP) DUAL SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO24 PDF資料下載
參數資料
| 型號： | LTC3862HGN#PBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | DUAL SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO24 |
| 封裝： | 0.150 INCH, LEAD FREE, PLASTIC, SSOP-24 |
| 文件頁數： | 9/40頁 |
| 文件大?。?/td> | 613K |
| 代理商： | LTC3862HGN#PBF |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁
LTC3862
17
3862fb
OPERATION
The LTC3862 uses a constant frequency architecture that
can be programmed over a 75kHz to 500kHz range using
a single resistor from the FREQ pin to ground. Figure 6
illustrates the relationship between the FREQ pin resistance
and the operating frequency.
The operating frequency of the LTC3862 can be approxi-
mated using the following formula:
RFREQ = 5.5096E9(fOSC)–0.9255
A phase-lock loop is available on the LTC3862 to syn-
chronize the internal oscillator to an external clock source
connected to the SYNC pin. Connect a series RC network
from the PLLFLTR pin to SGND to compensate PLL’s
feedback loop. Typical compensation components are a
0.01μF capacitor in series with a 10k resistor. The PLLFLTR
pin is both the output of the phase detector and the input
to the voltage controlled oscillator (VCO). The LTC3862
phase detector adjusts the voltage on the PLLFLTR pin
to align the rising edge of GATE1 to the leading edge of
the external clock signal, as shown in Figure 7. The ris-
ing edge of GATE2 will depend upon the voltage on the
PHASEMODE pin. The capture range of the LTC3862’s PLL
is 50kHz to 650kHz.
Because the operating frequency of the LTC3862 can be
programmed using an external resistor, in synchronized
applications, it is recommended that the free-running fre-
quency (as dened by the external resistor) be set to the
same value as the synchronized frequency. This results in
a start-up of the IC at approximately the same frequency
as the external clock, so that when the sync signal comes
alive, no discontinuity at the output will be observed. It also
ensures that the operating frequency remains essentially
constant in the event the sync signal is lost. The SYNC
pin has an internal 50k resistor to ground.
Using the CLKOUT and PHASEMODE Pins
in Multi-Phase Applications
TheLTC3862featurestwopins(CLKOUTandPHASEMODE)
that allow multiple ICs to be daisy-chained together for
higher current multi-phase applications. For a 3- or 4-phase
FREQUENCY (kHz)
100
R
FREQ
(kΩ)
300
1000
3862 F06
10
100
200
1000
900
800
700
600
500
400
0
Figure 6. FREQ Pin Resistor Value vs Frequency
Figure 7. Synchronization of the LTC3862
to an External Clock Using the PLL
SYNC
10V/DIV
GATE1
10V/DIV
GATE2
10V/DIV
CLKOUT
10V/DIV
2μs/DIV
VIN = 12V
VOUT = 48V 1A
PHASEMODE = SGND
3862 F07
design, the CLKOUT signal of the master controller is con-
nected to the SYNC input of the slave controller in order
to synchronize additional power stages for a single high
current output. The PHASEMODE pin is used to adjust the
phase relationship between channel 1 and channel 2, as well
as the phase relationship between channel 1 and CLKOUT,
as summarized in Table 1. The phases are calculated rela-
tive to the zero degrees, dened as the rising edge of the
GATE1 output. In a 6-phase application the CLKOUT pin
of the master controller connects to the SYNC input of the
2nd controller and the CLKOUT pin of the 2nd controller
connects to the SYNC pin of the 3rd controller.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3862IGN#PBF | DUAL SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO24 |
| LTC3867IUF#PBF | 0.1 A SWITCHING CONTROLLER, 1200 kHz SWITCHING FREQ-MAX, PQCC24 |
| LTC4000IUFD#PBF | 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PQCC28 |
| LTC4000EUFD#PBF | 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PQCC28 |
| LTC4000EUFD#TRPBF | 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PQCC28 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3862HUH#PBF | 功能描述:IC REG CTRLR BST PWM CM 24-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 特色產品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 標準包裝:1 系列:PowerWise® PWM 型:電壓模式 輸出數:1 頻率 - 最大:1MHz 占空比:81% 電源電壓:4.5 V ~ 18 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-5°C ~ 125°C 封裝/外殼:32-WFQFN 裸露焊盤 包裝:Digi-Reel® 產品目錄頁面:1303 (CN2011-ZH PDF) 其它名稱:LM3754SQDKR |
| LTC3862HUH#TRPBF | 功能描述:IC REG CTRLR BST PWM CM 24-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC3862HUH-1#PBF | 功能描述:IC REG CTRLR BST PWM CM 24-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC3862HUH-1#TRPBF | 功能描述:IC REG CTRLR BST PWM CM 24-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC3862HUH-2#PBF | 功能描述:IC REG CTRLR BST PWM CM 24-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
發布緊急采購，3分鐘左右您將得到回復。