- 您現在的位置：買賣IC網 > PDF目錄30771 > LTC3862EGN#PBF (LINEAR TECHNOLOGY CORP) DUAL SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO24 PDF資料下載
參數資料
| 型號： | LTC3862EGN#PBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | DUAL SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO24 |
| 封裝： | 0.150 INCH, LEAD FREE, PLASTIC, SSOP-24 |
| 文件頁數： | 4/40頁 |
| 文件大?。?/td> | 613K |
| 代理商： | LTC3862EGN#PBF |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁
LTC3862
12
3862fb
OPERATION
The Control Loop
The LTC3862 uses a constant frequency, peak current
mode step-up architecture with its two channels operat-
ing 180 degrees out of phase. During normal operation,
each external MOSFET is turned on when the clock for
that channel sets the PWM latch, and is turned off when
the main current comparator, ICMP, resets the latch. The
peak inductor current at which ICMP trips and resets the
latch is controlled by the voltage on the ITH pin, which is
the output of the error amplier, EA. The error amplier
compares the output feedback signal at the VFB pin to the
internal 1.223V reference and generates an error signal
at the ITH pin. When the load current increases it causes
a slight decrease in VFB relative to the reference voltage,
which causes the EA to increase the ITH voltage until the
average inductor current matches the new load current.
After the MOSFET is turned off, the inductor current ows
through the boost diode into the output capacitor and load,
until the beginning of the next clock cycle.
Cascaded LDOs Supply Power to the Gate Driver and
Control Circuitry
The LTC3862 contains two cascaded PMOS output stage
low dropout voltage regulators (LDOs), one for the gate
drive supply (INTVCC) and one for the low voltage analog
and digital control circuitry (3V8). A block diagram of this
power supply arrangement is shown in Figure 1.
The Gate Driver Supply LDO (INTVCC)
The 5V output (INTVCC) of the rst LDO is powered from
VIN and supplies power to the power MOSFET gate driv-
ers. The INTVCC pin should be bypassed to PGND with a
minimum of 4.7μF of ceramic capacitance (X5R or better),
placed as close as possible to the IC pins. If two power
MOSFETs are connected in parallel for each channel in
order to increase the output power level, or if a single
MOSFET with a QG greater than 50nC is used, then it is
recommended that the bypass capacitance be increased
to a minimum of 10μF.
An undervoltage lockout (UVLO) circuit senses the INTVCC
regulator output in order to protect the power MOSFETs
from operating with inadequate gate drive. For the LTC3862
the rising UVLO threshold is typically 3.3V and the hyster-
esis is typically 400mV. The LTC3862 was optimized for
logic-level power MOSFETs and applications where the
output voltage is less than 50V to 60V. For applications
requiring standard threshold power MOSFETs, please refer
to the LTC3862-1 data sheet.
–
+
SGND
R2
R1
1.223V
LTC3862
INTVCC
3V8
GATE
–
+
SGND
R4
R3
1.223V
P-CH
ANALOG
CIRCUITS
LOGIC
INTVCC
VIN
CIN
CVCC
C3V8
3862 F01
PGND
3V8
SGND
NOTE: PLACE CVCC AND C3V8 CAPACITORS AS CLOSE AS POSSIBLE TO DEVICE PINS
Figure 1. Cascaded LDOs Provide Gate Drive and Control Circuitry Power
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3862EUH#TRPBF | DUAL SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, QCC24 |
| LTC3862HGN#TRPBF | DUAL SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO24 |
| LTC3862IUH#TRPBF | DUAL SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, QCC24 |
| LTC3862HGN#PBF | DUAL SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO24 |
| LTC3862IGN#PBF | DUAL SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO24 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3862EUH#PBF | 功能描述:IC REG CTRLR BST PWM CM 24-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3862EUH#TRPBF | 功能描述:IC REG CTRLR BST PWM CM 24-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3862EUH-1#PBF | 功能描述:IC REG CTRLR BST PWM CM 24-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3862EUH-1#TRPBF | 功能描述:IC REG CTRLR BST PWM CM 24-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3862EUH-2#PBF | 功能描述:IC REG CTRLR BST PWM CM 24-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。