參數資料
型號： LTC3856IFE#PBF
廠商： LINEAR TECHNOLOGY CORP
元件分類： 穩壓器
英文描述： SWITCHING CONTROLLER, PDSO38
封裝： 4.4 MM, LEAD FREE, PLASTIC, TSSOP-38
文件頁數： 19/40頁
文件大?。?/td> 2222K
代理商： LTC3856IFE#PBF
LTC3856
3856f
applicaTions inForMaTion
Soft-Start and Tracking
The LTC3856 has the ability to either soft-start by itself
with a capacitor or track the output of another external
supply. When the controller is configured to soft-start by
itself, a capacitor should be connected to its TK/SS pin.
The controller is in the shutdown state if its RUN pin volt-
age is below 1.22V and its TK/SS pin is actively pulled to
ground in this shutdown state.
Once the RUN pin voltage is above 1.22V, the controller
powers up. A soft-start current of 1.25A then starts to
charge the TK/SS soft-start capacitor. Note that soft-start
or tracking is achieved not by limiting the maximum
output current of the controller but by controlling the
output ramp voltage according to the ramp rate on the
TK/SS pin. Current foldback is disabled during this phase
to ensure smooth soft-start or tracking. The soft-start or
tracking range is defined to be the voltage range from 0V
to 0.6V on the TK/SS pin. The total soft-start time can be
calculated as:
t
C
A
SOFTSTART
SS
= 0 6
1 25
.
.
Regardless of the mode selected by the MODE pin, the
controlleralwaysstartsindiscontinuousmodeuptoTK/SS
= 0.5V. Between TK/SS = 0.5V and 0.54V, it will operate in
forced continuous mode and revert to the selected mode
once TK/SS > 0.54V. The output ripple is minimized dur-
ing the 40mV forced continuous mode window ensuring
a clean PGOOD signal.
When the channel is configured to track another supply,
the feedback voltage of the other supply is duplicated by a
resistordividerandappliedtotheTK/SSpin.Therefore,the
voltageramprateonthispinisdeterminedbytheramprate
of the other supply’s voltage. Note that the small soft-start
capacitor charging current is always flowing, producing a
small offset error. To minimize this error, select the track-
ing resistive divider value to be small enough to make this
error negligible. In order to track down another channel or
supply after the soft-start phase expires, the LTC3856 is
forced into continuous mode of operation as soon as VFB
is below the undervoltage threshold of 0.54V regardless of
thesettingontheMODEpin.However,theLTC3856should
always be set in forced continuous mode tracking down
when there is no load. After TK/SS drops below 0.1V, the
controller operates in discontinuous mode.
The LTC3856 allows the user to program how its output
ramps up and down by means of the TK/SS pins. Through
these pins, the output can be set up to either coincidentally
or ratiometrically track another supply’s output, as shown
in Figure 11. In the following discussions, VOUT1 refers
to the LTC3856’s output as a master and VOUT2 refers to
another supply output as a slave. To implement the coinci-
dent tracking in Figure 11a, connect an additional resistive
divider to VOUT1andconnectitsmid-pointtotheTK/SSpin
of the slave controller. The ratio of this divider should be
the same as that of the slave controller’s feedback divider
shown in Figure 12a. In this tracking mode, VOUT1 must
be set higher than VOUT2. To implement the ratiometric
tracking in Figure 11b, the ratio of the VOUT2dividershould
be exactly the same as the master controller’s feedback
divider shown in Figure 12b . By selecting different resis-
tors, the LTC3856 can achieve different modes of tracking
including the two in Figure 11.
So, which mode should be programmed? While either
mode in Figure 11 satisfies most practical applications,
some trade-offs exist. The ratiometric mode saves a pair
of resistors, but the coincident mode offers better output
regulation. Under ratiometric tracking, when the master
controller’s output experiences dynamic excursion (under
load transient, for example), the slave controller output
will be affected as well. For better output regulation, use
the coincident tracking mode instead of ratiometric.
INTVCC (LDO) and EXTVCC
The LTC3856 features a true PMOS LDO that supplies
power to INTVCC from the VIN supply. INTVCC powers
the gate drivers and much of the LTC3856’s internal cir-
cuitry. The LDO regulates the voltage at the INTVCC pin
to 5V when VIN is greater than 5.5V. EXTVCC connects
to INTVCC through a P-channel MOSFET and can supply
the needed power when its voltage is higher than 4.7V.
Each of these can supply a peak current of 100mA and
must be bypassed to ground with a minimum of 4.7F
ceramic capacitor or other low ESR capacitor. No matter
what type of bulk capacitor is used, an additional 0.1F
ceramic capacitor placed directly adjacent to the INTVCC
and PGND pins is highly recommended. Good bypassing
相關PDF資料
PDF描述
LTC3856EFE#PBF SWITCHING CONTROLLER, PDSO38
LTC3856IUH#TRPBF SWITCHING CONTROLLER, PQCC38
LTC3856EFE#TRPBF SWITCHING CONTROLLER, PDSO38
LTC3860IUH#PBF DUAL SWITCHING CONTROLLER, 1250 kHz SWITCHING FREQ-MAX, PQCC32
LTC3862HUH#TRPBF DUAL SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, QCC24
相關代理商/技術參數
參數描述
LTC3856IUH#PBF 功能描述:IC REG CTRLR BUCK PWM CM 32WFQFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3856IUH#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 38-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3857EGN-1#PBF 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 特色產品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 標準包裝:1 系列:PowerWise® PWM 型:電壓模式 輸出數:1 頻率 - 最大:1MHz 占空比:81% 電源電壓:4.5 V ~ 18 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-5°C ~ 125°C 封裝/外殼:32-WFQFN 裸露焊盤 包裝:Digi-Reel® 產品目錄頁面:1303 (CN2011-ZH PDF) 其它名稱:LM3754SQDKR
LTC3857EGN-1#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX
LTC3857EUH#PBF 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 特色產品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 標準包裝:1 系列:PowerWise® PWM 型:電壓模式 輸出數:1 頻率 - 最大:1MHz 占空比:81% 電源電壓:4.5 V ~ 18 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-5°C ~ 125°C 封裝/外殼:32-WFQFN 裸露焊盤 包裝:Digi-Reel® 產品目錄頁面:1303 (CN2011-ZH PDF) 其它名稱:LM3754SQDKR
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*