參數資料
型號： LTC3856EFE#PBF
廠商： LINEAR TECHNOLOGY CORP
元件分類： 穩壓器
英文描述： SWITCHING CONTROLLER, PDSO38
封裝： 4.4 MM, LEAD FREE, PLASTIC, TSSOP-38
文件頁數： 9/40頁
文件大?。?/td> 2222K
代理商： LTC3856EFE#PBF
LTC3856
3856f
applicaTions inForMaTion
sheet for information about parasitic inductance. In the
absence of data, measure the voltage drop directly across
the sense resistor to extract the magnitude of the ESL step
and use Equation 1 to determine the ESL. However, do not
overfilter. Keep the RC time constant, less than or equal
to the inductor time constant to maintain a high enough
ripple voltage of
VSENSE. The equation generally applies
to high density/high current applications where IMAX >
10A and low values of inductors are used. For applications
where IMAX < 10A, set RF to 10Ω and CF to 1000pF. This
will provide a good starting point. The filter components
need to be placed close to the IC. The positive and nega-
tive sense traces need to be routed as a differential pair
and Kelvin connected to the sense resistor.
Inductor DCR Sensing
For applications requiring the highest possible efficiency
at high load currents, the LTC3856 is capable of sensing
the voltage drop across the inductor DCR, as shown in
Figure 2b. The DCR of the inductor represents the small
amount of DC winding resistance of the copper, which
can be less than 1mΩ for today’s low value, high current
inductors. In a high current application requiring such an
inductor, conduction loss through a sense resistor would
costseveralpointsofefficiencycomparedtoDCRsensing.
If the external R1|| R2 C1 time constant is chosen to be
exactly equal to the L/DCR time constant, the voltage drop
across the external capacitor is equal to the drop across
theinductorDCRmultipliedbyR2/(R1+R2).R2scalesthe
voltage across the sense terminals for applications where
the DCR is greater than the target sense resistor value.
To properly dimension the external filter components, the
DCR of the inductor must be known. It can be measured
using a good RLC meter, but the DCR tolerance is not
always the same and varies with temperature; consult the
manufacturers’ data sheets for detailed information.
Using the inductor ripple current value from the Inductor
Value Calculation and Output Ripple Current section, the
target sense resistor value is:
R
V
I
SENSE EQUIV
SENSE MAX
MAX
L
(
)
(
)
(
)
=
+
2
To ensure that the application will deliver full load current
over the full operating temperature range, choose the
minimum value for the maximum current sense threshold
(VSENSE(MAX))intheElectricalCharacteristicstable(25mV,
45mV or 68mV, depending on the state of the ILIM pin).
Next, determine the DCR of the inductor. Where provided,
use the manufacturer’s maximum value, usually given at
20°C. Increase this value to account for the temperature
coefficient of resistance, which is approximately 0.4%/°C.
A conservative value for TL(MAX) is 100°C. To scale the
maximum inductor DCR to the desired sense resistor
value, use the divider ratio:
R
DCR
at T
D
SENSE EQUIV
MAX
L MAX
=
(
)
(
)
C1 is usually selected to be in the range of 0.047F to
0.47F. This forces R1|| R2 to around 2k, reducing error
that might have been caused by the SENSE+ pins’ ±1A
current. TL(MAX) is the maximum inductor temperature.
The equivalent resistance R1|| R2 is scaled to the room
temperature inductance and maximum DCR:
R R
L
DCR at
C C
1 2
20
1
||
(
)
=
°
The sense resistor values are:
R
R R
R
R R
R
D
1
1 2
2
1
=
||
;
相關PDF資料
PDF描述
LTC3856IUH#TRPBF SWITCHING CONTROLLER, PQCC38
LTC3856EFE#TRPBF SWITCHING CONTROLLER, PDSO38
LTC3860IUH#PBF DUAL SWITCHING CONTROLLER, 1250 kHz SWITCHING FREQ-MAX, PQCC32
LTC3862HUH#TRPBF DUAL SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, QCC24
LTC3862IFE#PBF DUAL SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO24
相關代理商/技術參數
參數描述
LTC3856EUH#PBF 功能描述:IC REG CTRLR BUCK PWM CM 32WFQFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3856EUH#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 38-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3856IFE#PBF 功能描述:IC REG CTRLR BUCK PWM CM 38TFSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX
LTC3856IFE#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 38TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX
LTC3856IUH#PBF 功能描述:IC REG CTRLR BUCK PWM CM 32WFQFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*