參數資料
型號： LTC3851IMSE-1#PBF
廠商： LINEAR TECHNOLOGY CORP
元件分類： 穩壓器
英文描述： 0.05 A SWITCHING CONTROLLER, 530 kHz SWITCHING FREQ-MAX, PDSO16
封裝： LEAD FREE, PLASTIC, MSOP-16
文件頁數： 4/28頁
文件大?。?/td> 352K
代理商： LTC3851IMSE-1#PBF
LTC3851-1
12
38511fa
APPLICATIONS INFORMATION
The Typical Application on the rst page of this data sheet
is a basic LTC3851-1 application circuit. The LTC3851-1
can be congured to use either DCR (inductor resistance)
sensing or low value resistor sensing. The choice of the
two current sensing schemes is largely a design trade-off
between cost, power consumption and accuracy. DCR
sensing is becoming popular because it saves expensive
current sensing resistors and is more power efcient,
especially in high current applications. However, current
sensing resistors provide the most accurate current limits
for the controller. Other external component selection
is driven by the load requirement, and begins with the
selection of RSENSE (if RSENSE is used) and the inductor
value. Next, the power MOSFETs and Schottky diodes are
selected. Finally, input and output capacitors are selected.
The circuit shown on the rst page can be congured for
operation up to 40V at VIN.
SENSE+ and SENSE– Pins
The SENSE+ and SENSE– pins are the inputs to the current
comparators. The common mode input voltage range of
the current comparators is 0V to 5.5V. Both SENSE pins
are high impedance inputs with small base currents of
less than 1μA. When the SENSE pins ramp up from 0V
to 1.4V, the small base currents ow out of the SENSE
pins. When the SENSE pins ramp down from 5V to 1.1V,
the small base currents ow into the SENSE pins. The
high impedance inputs to the current comparators allow
accurate DCR sensing. However, care must be taken not
to oat these pins during normal operation.
Low Value Resistors Current Sensing
A typical sensing circuit using a discrete resistor is shown
in Figure 1. RSENSE is chosen based on the required output
current.
The current comparator has a maximum threshold,
VMAX = 50mV. The current comparator threshold sets the
maximum peak of the inductor current, yielding a maximum
average output current, IMAX, equal to the peak value less
half the peak-to-peak ripple current, ΔIL. Allowing a margin
of 20% for variations in the IC and external component
values yields:
R
V
II
SENSE
MAX
L
=
+
08
2
.
/
Δ
Inductor DCR Sensing
For applications requiring the highest possible efciency,
the LTC3851-1 is capable of sensing the voltage drop
across the inductor DCR, as shown in Figure 2. The
DCR of the inductor represents the small amount of
DC winding resistance of the copper, which can be less
than 1mΩ for today’s low value, high current inductors.
If the external R1||R2 C1 time constant is chosen to
be exactly equal to the L/DCR time constant, the voltage
drop across the external capacitor is equal to the voltage
drop across the inductor DCR multiplied by R2/(R1 + R2).
Therefore, R2 may be used to scale the voltage across the
sense terminals when the DCR is greater than the target
sense resistance. Check the manufacturer’s data sheet
for specications regarding the inductor DCR, in order
to properly dimension the external lter components.
The DCR of the inductor can also be measured using a
good RLC meter.
Figure 1. Using a Resistor to Sense Current with the LTC3851-1
VIN
INTVCC
BOOST
TG
SW
BG
GND
FILTER COMPONENTS
PLACED NEAR SENSE PINS
SENSE+
SENSE–
LTC3851-1
VOUT
RSENSE
38511 F01
相關PDF資料
PDF描述
LTC3851IMSE#TRPBF 0.05 A SWITCHING CONTROLLER, 790 kHz SWITCHING FREQ-MAX, PDSO16
LTC3851IMSE#PBF 0.05 A SWITCHING CONTROLLER, 790 kHz SWITCHING FREQ-MAX, PDSO16
LTC3851IUD#TRPBF 0.05 A SWITCHING CONTROLLER, 790 kHz SWITCHING FREQ-MAX, PQCC16
LTC3851IGN#TRPBF 0.05 A SWITCHING CONTROLLER, 790 kHz SWITCHING FREQ-MAX, PDSO16
LTC3851EUD#TRPBF 0.05 A SWITCHING CONTROLLER, 790 kHz SWITCHING FREQ-MAX, PQCC16
相關代理商/技術參數
參數描述
LTC3851IUD#PBF 功能描述:IC REG CTRLR BUCK PWM CM 16-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3851IUD#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 16-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3852EUDD#PBF 功能描述:IC REG CTRLR DOUBLER PWM 24-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 特色產品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 標準包裝:1 系列:PowerWise® PWM 型:電壓模式 輸出數:1 頻率 - 最大:1MHz 占空比:81% 電源電壓:4.5 V ~ 18 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-5°C ~ 125°C 封裝/外殼:32-WFQFN 裸露焊盤 包裝:Digi-Reel® 產品目錄頁面:1303 (CN2011-ZH PDF) 其它名稱:LM3754SQDKR
LTC3852EUDD#TRPBF 功能描述:IC REG CTRLR DOUBLER PWM 24-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3852IUDD#PBF 功能描述:IC REG CTRLR DOUBLER PWM 24-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*