<tfoot id="67q7q"><sup id="67q7q"><tfoot id="67q7q"></tfoot></sup></tfoot>
<nobr id="67q7q"><noframes id="67q7q">
  • <pre id="67q7q"><menu id="67q7q"></menu></pre>
    參數資料
    型號: LTC3787EUFD#PBF
    廠商: LINEAR TECHNOLOGY CORP
    元件分類: 穩壓器
    英文描述: SWITCHING CONTROLLER, 585 kHz SWITCHING FREQ-MAX, PQCC28
    封裝: 4 X 5 MM, LEAD FREE, PLASTIC, MO-220, QFN-28
    文件頁數: 5/36頁
    文件大?。?/td> 363K
    代理商: LTC3787EUFD#PBF
    LTC3787
    13
    3787fb
    OPERATION
    In forced continuous operation or when clocked by an
    external clock source to use the phase-locked loop (see
    the Frequency Selection and Phase-Locked Loop section),
    the inductor current is allowed to reverse at light loads or
    under large transient conditions. The peak inductor cur-
    rent is determined by the voltage on the ITH pin, just as
    in normal operation. In this mode, the efficiency at light
    loads is lower than in Burst Mode operation. However,
    continuous operation has the advantages of lower output
    voltage ripple and less interference to audio circuitry, as
    it maintains constant-frequency operation independent
    of load current.
    When the PLLIN/MODE pin is connected for pulse-skipping
    mode, the LTC3787 operates in PWM pulse-skipping mode
    at light loads. In this mode, constant-frequency operation
    is maintained down to approximately 1% of designed
    maximum output current. At very light loads, the current
    comparator ICMP may remain tripped for several cycles
    and force the external bottom MOSFET to stay off for
    the same number of cycles (i.e., skipping pulses). The
    inductor current is not allowed to reverse (discontinuous
    operation). This mode, like forced continuous operation,
    exhibits low output ripple as well as low audio noise and
    reduced RF interference as compared to Burst Mode
    operation. It provides higher low current efficiency than
    forced continuous mode, but not nearly as high as Burst
    Mode operation.
    Frequency Selection and Phase-Locked Loop
    (FREQ and PLLIN/MODE Pins)
    The selection of switching frequency is a trade-off between
    efficiency and component size. Low frequency opera-
    tion increases efficiency by reducing MOSFET switching
    losses, but requires larger inductance and/or capacitance
    to maintain low output ripple voltage.
    The switching frequency of the LTC3787’s controllers can
    be selected using the FREQ pin.
    If the PLLIN/MODE pin is not being driven by an external
    clock source, the FREQ pin can be tied to SGND, tied to
    INTVCC, or programmed through an external resistor. Tying
    FREQ to SGND selects 350kHz while tying FREQ to INTVCC
    selects 535kHz. Placing a resistor between FREQ and SGND
    allows the frequency to be programmed between 50kHz
    and 900kHz, as shown in Figure 6.
    A phase-locked loop (PLL) is available on the LTC3787
    to synchronize the internal oscillator to an external clock
    source that is connected to the PLLIN/MODE pin. The
    LTC3787’s phase detector adjusts the voltage (through
    an internal lowpass filter) of the VCO input to align the
    turn-on of the first controller’s external bottom MOSFET
    to the rising edge of the synchronizing signal. Thus, the
    turn-on of the second controller’s external bottom MOSFET
    is 180 or 240 degrees out-of-phase to the rising edge of
    the external clock source.
    The VCO input voltage is prebiased to the operating fre-
    quency set by the FREQ pin before the external clock is
    applied. If prebiased near the external clock frequency,
    the PLL loop only needs to make slight changes to the
    VCO input in order to synchronize the rising edge of the
    external clock’s to the rising edge of BG1. The ability to
    prebias the loop filter allows the PLL to lock-in rapidly
    without deviating far from the desired frequency.
    The typical capture range of the LTC3787’s PLL is from
    approximately 55kHz to 1MHz, and is guaranteed to lock
    to an external clock source whose frequency is between
    75kHz and 850kHz.
    The typical input clock thresholds on the PLLIN/MODE
    pin are 1.6V (rising) and 1.2V (falling).
    PolyPhase Applications (CLKOUT and PHASMD Pins)
    The LTC3787 features two pins, CLKOUT and PHASMD,
    that allow other controller ICs to be daisychained with
    the LTC3787 in PolyPhase applications. The clock output
    signal on the CLKOUT pin can be used to synchronize
    additional power stages in a multiphase power supply
    solution feeding a single, high current output or multiple
    separate outputs. The PHASMD pin is used to adjust the
    phase of the CLKOUT signal as well as the relative phases
    between the two internal controllers, as summarized in
    Table 1. The phases are calculated relative to the zero
    degrees phase being defined as the rising edge of the
    bottom gate driver output of controller 1 (BG1). Depend-
    ing on the phase selection, a PolyPhase application with
    相關PDF資料
    PDF描述
    LTC3787IGN#PBF SWITCHING CONTROLLER, 585 kHz SWITCHING FREQ-MAX, PDSO28
    LTC3788EUH#TRPBF DUAL SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PQCC32
    LTC3788EUH#PBF DUAL SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PQCC32
    LTC3788IUH#PBF DUAL SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PQCC32
    LTC3788IGN-1#PBF DUAL SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PDSO28
    相關代理商/技術參數
    參數描述
    LTC3787HGN#PBF 功能描述:IC REG CTRLR BST PWM CM 28-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX
    LTC3787HGN#TRPBF 功能描述:IC REG CTRLR BST PWM CM 28-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX
    LTC3787HUFD#PBF 功能描述:IC REG CTRLR BST PWM CM 28-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX
    LTC3787HUFD#TRPBF 功能描述:IC REG CTRLR BST PWM CM 28-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX
    LTC3787IGN#PBF 功能描述:IC REG CTRLR BST PWM CM 28-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX