參數資料
型號： LTC3783IFE#TR
廠商： LINEAR TECHNOLOGY CORP
元件分類： 穩壓器
英文描述： 1 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
封裝： 4.40 MM, PLASTIC, TSSOP-16
文件頁數： 7/24頁
文件大?。?/td> 250K
代理商： LTC3783IFE#TR
LTC3783
15
3783fb
OPERATION
Boost Converter: Inductor Selection
Given an operating input voltage range, and having chosen
the operating frequency and ripple current in the inductor,
the inductor value can be determined using the following
equation:
L
V
If
D
where
I
IN MIN
L
MAX
L
OUT
=
Δ
Δ=
()
(
:
χ
M
MAX
D
)
–
1
Remember that most boost converters are not short-circuit
protected. Under a shorted output condition, the inductor
current is limited only by the input supply capability. For
applications requiring a step-up converter that is short-
circuit protected, please refer to the applications section
covering SEPIC converters.
The minimum required saturation current of the inductor
can be expressed as a function of the duty cycle and the
load current, as follows:
I
D
L SAT
OUT MAX
MAX
()
–
>+
1
21
χ
The saturation current rating for the inductor should be
checked at the minimum input voltage (which results in the
highest inductor current) and maximum output current.
Boost Converter: Operating in Discontinuous Mode
Discontinuous mode operation occurs when the load cur-
rent is low enough to allow the inductor current to run out
during the off-time of the switch, as shown in Figure 7.
Once the inductor current is near zero, the switch and diode
capacitances resonate with the inductance to form damped
ringing at 1MHz to 10MHz. If the off-time is long enough,
the drain voltage will settle to the input voltage.
Depending on the input voltage and the residual energy in
the inductor, this ringing can cause the drain of the power
MOSFET to go below ground where it is clamped by the body
diode. This ringing is not harmful to the IC and it has not
been shown to contribute signicantly to EMI. Any attempt
to damp it with a snubber will degrade the efciency.
Boost Converter: Power MOSFET Selection
The power MOSFET can serve two purposes in the LTC3783:
it represents the main switching element in the power path,
and its RDS(ON) can represent the current sensing element
for the control loop. Important parameters for the power
MOSFET include the drain-to-source breakdown voltage
BVDSS, the threshold voltage VGS(TH), the on-resistance
RDS(ON) versus gate-to-source voltage, the gate-to-source
and gate-to-drain charges QGS and QGD, respectively, the
maximum drain current ID(MAX) and the MOSFET’s thermal
resistances
θJC and θJA.
The gate drive voltage is set by the 7V INTVCC low drop
regulator. Consequently, 6V rated MOSFETs are required
in most high voltage LTC3783 applications. If low input
voltage operation is expected (e.g., supplying power
from a lithium-ion battery or a 3.3V logic supply), then
sublogic-level threshold MOSFETs should be used. Pay
close attention to the BVDSSspecicationsfortheMOSFETs
relative to the maximum actual switch voltage in the ap-
plication. Many logic-level devices are limited to 30V or
less, and the switch node can ring during the turn-off of
the MOSFET due to layout parasitics. Check the switching
waveforms of the MOSFET directly across the drain and
source terminals using the actual PC board layout for
excessive ringing.
OUTPUT
VOLTAGE
200mV/DIV
INDUCTOR
CURRENT
1A/DIV
1μs/DIV
3783 F07
MOSFET
DRAIN
VOLTAGE
20V/DIV
Figure 7. Discontinuous Mode Waveforms
相關PDF資料
PDF描述
LTC3783IDHD#TR 1 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
LTC3783IFE 1 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
LTC3785IUF#PBF 3 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PQCC24
LTC3785EUF 3 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PQCC24
LTC3786IMSE#TRPBF SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PDSO16
相關代理商/技術參數
參數描述
LTC3785EUF#PBF 功能描述:IC REG CTRLR BST PWM VM 24-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 特色產品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 標準包裝:1 系列:PowerWise® PWM 型:電壓模式 輸出數:1 頻率 - 最大:1MHz 占空比:81% 電源電壓:4.5 V ~ 18 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-5°C ~ 125°C 封裝/外殼:32-WFQFN 裸露焊盤 包裝:Digi-Reel® 產品目錄頁面:1303 (CN2011-ZH PDF) 其它名稱:LM3754SQDKR
LTC3785EUF#TRPBF 功能描述:IC REG CTRLR BST PWM VM 24-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3785EUF-1#PBF 功能描述:IC REG CTRLR BST PWM VM 24-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LTC3785EUF-1#TRPBF 功能描述:IC REG CTRLR BST PWM VM 24-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX
LTC3785EUFPBF 制造商:Linear Technology 功能描述:10V Synch Buck-Boost Controller LTC3785
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*