- 您現在的位置：買賣IC網 > PDF目錄44992 > LTC3772BETS8#PBF (LINEAR TECHNOLOGY CORP) 1 A SWITCHING CONTROLLER, 650 kHz SWITCHING FREQ-MAX, PDSO8 PDF資料下載
參數資料
| 型號： | LTC3772BETS8#PBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 1 A SWITCHING CONTROLLER, 650 kHz SWITCHING FREQ-MAX, PDSO8 |
| 封裝： | 1 MM HEIGHT, LEAD FREE, PLASTIC, MO-193, TSOT-23, 8 PIN |
| 文件頁數： | 2/20頁 |
| 文件大?。?/td> | 318K |
| 代理商： | LTC3772BETS8#PBF |
第1頁當前第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁
10
LTC3772B
3772bfa
The basic LTC3772B application circuit is shown on the front
page of this data sheet. The load requirement drives the
selection of external components: the power MOSFET,
inductor and output diode, as well as the input bypass
capacitor CIN and output bypass capacitor COUT.
Power MOSFET Selection
An external P-channel power MOSFET must be selected for
use with the LTC3772B. The main selection criteria for the
power MOSFET are the threshold voltage VGS(TH), the “on”
resistance RDS(ON), reverse transfer capacitance CRSS and
total gate charge.
Since the LTC3772B is designed for operation down to low
input voltages, a sublogic level threshold MOSFET (RDS(ON)
guaranteed at VGS = 2.5V) is required for applications that
work close to this voltage. When these MOSFETs are used,
make sure that the input supply to the LTC3772B is less than
the absolute maximum VGS rating.
The P-channel MOSFET’s on-resistance is chosen based on
the required load current. The maximum average output
load current IOUT(MAX) is equal to the peak inductor current
minus half the peak-to-peak ripple current IRIPPLE. The
LTC3772B’s current comparator monitors the drain-to-
source voltage VDS of the P-channel MOSFET, which is
sensed between the VIN and SW pins. The peak inductor
current is limited by the current threshold, set by the volt-
age on the ITH pin of the current comparator. The voltage
on the ITH pin is internally clamped, which limits the maxi-
mum current sense threshold
VSENSE(MAX) to approxi-
mately 138mV when IPRG is floating (70mV when IPRG is
tied low; 208mV when IPRG is tied high).
The output current that the LTC3772B can provide is given by:
I
V
R
I
OUT MAX
SENSE MAX
DS ON
RIPPLE
()
–
=
2
A reasonable starting point is setting ripple current IRIPPLE
to be 40% of IOUT(MAX). Rearranging the above equation
yields:
R
V
I
DS ON MAX
SENSE MAX
OUT MAX
()(
)
()
=
5
6
for Duty Cycle < 20%.
However, for operation above 20% duty cycle, slope com-
pensation has to be taken into consideration to select the
appropriate value of RDS(ON)fortherequiredamountofload
current:
R
VSF
I
DS ON MAX
SENSE MAX
OUT MAX
()(
)
()
–
=
5
6
where SF is a factor whose value is obtained from the curve
in Figure 1.
These must be further derated to take into account the
significant variation in on-resistance with temperature. The
following equation is a good guide for determining the
required RDS(ON)MAX at 25°C (manufacturer’s specifica-
tion), allowing some margin for variations in the LTC3772B
and external component values:
R
VSF
I
DS ON MAX
SENSE MAX
OUT MAX
T
()(
)
()
.
–
=
5
6
09
ρ
The
ρT is a normalizing term accounting for the tempera-
ture variation in on-resistance, which is typically about
0.4%/
°C, as shown in Figure 2. Junction to case tempera-
ture TJC is about 10°C in most applications. For a maximum
ambient temperature of 70
°C,usingρ80°C1.3intheabove
equation is a reasonable choice.
The required minimum RDS(ON) of the MOSFET is also
governed by its allowable power dissipation. For applica-
tions that may operate the LTC3772B in dropout–i.e., 100%
APPLICATIO S I FOR ATIO
WU
UU
Figure 2. RDS(ON) vs Temperature
JUNCTION TEMPERATURE (
C)
–50
ρ
TNORMALIZED
ON
RESISTANCE
1.0
1.5
150
0.5
0
50
100
2.0
3772B F02
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3772ETS8#PBF | 1 A SWITCHING CONTROLLER, 650 kHz SWITCHING FREQ-MAX, PDSO8 |
| LTC3783IDHD | 1 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
| LTC3783IFE#TR | 1 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
| LTC3783IDHD#TR | 1 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
| LTC3783IFE | 1 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3772EDDB#PBF | 制造商:Linear Technology 功能描述:DC DC Cntrlr Single-OUT Step Down 2.75V to 9.8V Input 8-Pin DFN EP |
| LTC3772EDDB#TRMPBF | 功能描述:IC REG CTRLR BUCK PWM CM 8-DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3772EDDB#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 8-DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3772ETS8 | 制造商:Linear Technology 功能描述:DC DC Cntrlr Single-OUT Step Down 2.75V to 9.8V Input 8-Pin TSOT-23 |
| LTC3772ETS8#PBF | 制造商:Linear Technology 功能描述:DC DC Cntrlr Single-OUT Step Down 2.75V to 9.8V Input 8-Pin TSOT-23 |
發布緊急采購，3分鐘左右您將得到回復。