- 您現在的位置：買賣IC網 > PDF目錄44992 > LTC3731HUH#TRPBF (LINEAR TECHNOLOGY CORP) 5 A SWITCHING CONTROLLER, 750 kHz SWITCHING FREQ-MAX, PQCC32 PDF資料下載
參數資料
| 型號： | LTC3731HUH#TRPBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 5 A SWITCHING CONTROLLER, 750 kHz SWITCHING FREQ-MAX, PQCC32 |
| 封裝： | 5 X 5 MM, LEAD FREE, PLASTIC, MO-220WHHD, QFN-32 |
| 文件頁數： | 10/34頁 |
| 文件大小： | 427K |
| 代理商： | LTC3731HUH#TRPBF |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁
LTC3731H
3731Hfb
applicaTions inForMaTion
An internal 1.5A current source charges up the CSS
capacitor. When the voltage on RUN/SS reaches 1.5V, the
controller is permitted to start operating. As the voltage on
RUN/SS increases from 1.5V to 3.5V, the internal current
limitisincreasedfrom20mV/RSENSEto75mV/RSENSE.The
output current limit ramps up slowly, taking an additional
1s/F to reach full current. The output current thus ramps
up slowly, eliminating the starting surge current required
from the input power supply. If RUN/SS has been pulled
all the way to ground, there is a delay before starting of
approximately:
t
V
A
C
s F C
t
V
A
C
s F C
DELAY
SS
IRAMP
SS
=
=
(
)
=
=
(
)
1 5
1
3
1 5
1
.
/
.
/
By pulling the RUN/SS controller pin below 0.4V the
IC is put into low current shutdown (IQ < 100A). The
RUN/SS pin can be driven directly from logic as shown
in Figure 7. Diode, D1, in Figure 7 reduces the start delay
but allows CSS to ramp up slowly, providing the soft-start
function. The RUN/SS pin has an internal 6V Zener clamp
(see the Functional Diagram).
Fault Conditions: Overcurrent Latchoff
The RUN/SS pins also provide the ability to latch off the
controllers when an overcurrent condition is detected. The
RUN/SS capacitor is used initially to turn on and limit the
inrush current of all three output stages. After the con-
trollers have been started and been given adequate time
to charge up the output capacitor and provide full load
current, the RUN/SS capacitor is used for a short-circuit
timer. If the output voltage falls to less than 70% of its
nominal value, the RUN/SS capacitor begins discharging
on the assumption that the output is in an overcurrent
condition. If the condition lasts for a long enough period,
as determined by the size of the RUN/SS capacitor, the
discharge current, and the circuit trip point, the controller
will be shut down until the RUN/SS pin voltage is recycled.
If the overload occurs during start-up, the time can be
approximated by:
tLO1 >> (CSS 0.6V)/(1.5A) = 4 105 (CSS)
If the overload occurs after start-up, the voltage on the
RUN/SS capacitor will continue charging and will provide
additional time before latching off:
tLO2 >> (CSS 3V)/(1.5A) = 2 106 (CSS)
This built-in overcurrent latchoff can be overridden by
providing a pull-up resistor to the RUN/SS pin from VCC
as shown in Figure 7. When VCC is 5V, a 200k resistance
will prevent the discharge of the RUN/SS capacitor dur-
ing an overcurrent condition but also shortens the soft-
start period, so a larger RUN/SS capacitor value may be
required.
Why should you defeat overcurrent latchoff? During the
prototyping stage of a design, there may be a problem with
noise pick-up or poor layout causing the protection circuit
to latch off the controller. Defeating this feature allows
troubleshooting of the circuit and PC layout. The internal
foldback current limiting still remains active, thereby pro-
tecting the power supply system from failure. A decision
can be made after the design is complete whether to rely
solely on foldback current limiting or to enable the latchoff
feature by removing the pull-up resistor.
The value of the soft-start capacitor CSS may need to be
scaled with output current, output capacitance and load
current characteristics. The minimum soft-start capaci-
tance is given by:
CSS > (COUT)(VOUT) (10–4) (RSENSE)
The minimum recommended soft-start capacitor of
CSS = 0.1F will be sufficient for most applications.
RUN/SS PIN
3.3V OR 5V
RUN/SS PIN
5V
VCC
RSS
CSS
3731H F07
D1
SHDN
Figure 7. RUN/SS Pin Interfacing
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3731HUH#PBF | 5 A SWITCHING CONTROLLER, 750 kHz SWITCHING FREQ-MAX, PQCC32 |
| LTC3772BETS8#PBF | 1 A SWITCHING CONTROLLER, 650 kHz SWITCHING FREQ-MAX, PDSO8 |
| LTC3772ETS8#PBF | 1 A SWITCHING CONTROLLER, 650 kHz SWITCHING FREQ-MAX, PDSO8 |
| LTC3783IDHD | 1 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
| LTC3783IFE#TR | 1 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3731IG | 制造商:Linear Technology 功能描述:LDO Cntrlr SYNC BUCK REG 0.6V to 6V 36-Pin SSOP |
| LTC3731IG#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC3731IG#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC3731IUH | 制造商:Linear Technology 功能描述:LDO Cntrlr SYNC BUCK REG 0.6V to 6V 32-Pin QFN EP |
| LTC3731IUH#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
發布緊急采購，3分鐘左右您將得到回復。