- 您現在的位置：買賣IC網 > PDF目錄44992 > LTC3618IFE#PBF (LINEAR TECHNOLOGY CORP) 8 A DUAL SWITCHING CONTROLLER, 2700 kHz SWITCHING FREQ-MAX, PDSO24 PDF資料下載
參數資料
| 型號： | LTC3618IFE#PBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 8 A DUAL SWITCHING CONTROLLER, 2700 kHz SWITCHING FREQ-MAX, PDSO24 |
| 封裝： | 4.40 MM, LEAD FREE, PLASTIC, TSSOP-24 |
| 文件頁數： | 11/24頁 |
| 文件大?。?/td> | 603K |
| 代理商： | LTC3618IFE#PBF |
LTC3618
19
3618f
2. I2R losses are calculated from the resistances of the
internal switches, RSW, and external inductor RL. In
continuous mode the average output current owing
through inductor L is “chopped” between the main
switch and the synchronous switch. Thus, the series
resistance looking into the SW pin is a function of both
top and bottom MOSFET RDS(ON) and the duty cycle
(DC), as follows:
RSW = (RDS(ON)TOP)(DC) + (RDS(ON)BOT)(1 – DC)
The RDS(ON) for both the top and bottom MOSFETs can
be obtained from the Typical Performance Characteristics
curves. To obtain I2R losses, simply add RSW to RL and
multiply the result by the square of the average output
current.
Other losses, including CINandCOUTESRdissipativelosses
and inductor core losses, generally account for less than
2% of the total loss.
Thermal Considerations
In most applications, the LTC3618 does not dissipate
much heat due to its high efciency. However, in ap-
plications where the LTC3618 is running at high ambient
temperature with low supply voltage and high duty cycles,
such as in dropout, the heat dissipated may exceed the
maximum junction temperature of the part. If the junction
temperature reaches approximately 160°C, all four power
switches will be turned off and the SW node will become
high impedance.
To prevent the LTC3618 from exceeding the maximum
junction temperature, the user will need to do some ther-
mal analysis to determine whether the power dissipated
exceeds the maximum junction temperature of the part.
The temperature rise is given by:
TRISE = PD θJA
where PD is the power dissipated by the regulator, and
θJA is the thermal resistance from the junction of the die
to the ambient temperature. The junction temperature,
TJ, is given by:
TJ = TA + TRISE
where TA is the ambient temperature.
As an example, consider this case: the LTC3618 is in
dropout at an input voltage of 3.3V with a load current for
each channel of 2A at an ambient temperature of 70°C.
Assuming a 20°C rise in junction temperature, to 90°C,
results in an RDS(ON) of 0.086mΩ (see the graph in the
Typical Performance Characteristics section). Therefore,
the power dissipated by the part is:
PD = (I12 + I22) RDS(ON) = 0.69W
For the QFN package, the
θJA is 37°C/W.
Therefore, the junction temperature of the regulator op-
erating at 70°C ambient temperature is approximately:
TJ = 0.69W 37°C/W + 70°C = 95°C
Note that for very low input voltage, the junction tem-
perature will be higher due to increased switch resistance
RDS(ON). It is not recommended to use full load current at
high ambient temperature and low input voltage.
To maximize the thermal performance of the LTC3618, the
exposed pad should be soldered to a ground plane. See
the PC Board Layout Checklist.
Design Example
As a design example, consider using the LTC3618 in an
application with the following specications:
VIN = 3.3V to 5.5V
VDDQ = 1.8V
VTT = 0.9V
IOUT1(MAX) = 3A
IOUT2(MAX) = 3A
IOUT1(MIN) = 200mA
f = 2.25MHz
First, calculate the timing resistor:
RRT =
4 1011
Ω Hz
2.25MHz
= 178k
APPLICATIONS INFORMATION
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3618EFE#TRPBF | 8 A DUAL SWITCHING CONTROLLER, 2700 kHz SWITCHING FREQ-MAX, PDSO24 |
| LTC3620EDC#PBF | SWITCHING REGULATOR, 50 kHz SWITCHING FREQ-MAX, PDSO8 |
| LTC3620EDC#TRMPBF | SWITCHING REGULATOR, 50 kHz SWITCHING FREQ-MAX, PDSO8 |
| LTC3620EDC-1#PBF | SWITCHING REGULATOR, 50 kHz SWITCHING FREQ-MAX, PDSO8 |
| LTC3620EDC-1#TRPBF | SWITCHING REGULATOR, 50 kHz SWITCHING FREQ-MAX, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3618IUF#PBF | 功能描述:IC REG DUAL SYNC 3A BUCK 24QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 標準包裝:43 系列:- 應用:控制器，Intel VR11 輸入電壓:5 V ~ 12 V 輸出數:1 輸出電壓:0.5 V ~ 1.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-VFQFN 裸露焊盤 供應商設備封裝:48-QFN（7x7） 包裝:管件 |
| LTC3618IUF#TRPBF | 功能描述:IC REG DUAL SYNC 3A BUCK 24QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 標準包裝:43 系列:- 應用:控制器，Intel VR11 輸入電壓:5 V ~ 12 V 輸出數:1 輸出電壓:0.5 V ~ 1.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-VFQFN 裸露焊盤 供應商設備封裝:48-QFN（7x7） 包裝:管件 |
| LTC3619BEDD#PBF | 功能描述:IC REG BUCK SYNC ADJ DL 10DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2 |
| LTC3619BEDD#PBF | 制造商:Linear Technology 功能描述:IC SYNC STEP-DOWN DC/DC CONVERTER DFN-10 |
| LTC3619BEDD#TRPBF | 功能描述:IC REG BUCK SYNC ADJ DL 10DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式，混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC |
發布緊急采購，3分鐘左右您將得到回復。