參數資料
型號: LTC3569EFE#TRPBF
廠商: LINEAR TECHNOLOGY CORP
元件分類: 穩壓器
英文描述: 2.5 A SWITCHING REGULATOR, 3000 kHz SWITCHING FREQ-MAX, PDSO16
封裝: 4.40 MM, LEAD FREE, PLASTIC, TSSOP-16
文件頁數: 4/26頁
文件大?。?/td> 468K
代理商: LTC3569EFE#TRPBF
LTC3569
12
3569fd
OPERATION
600mA; two independent regulators at 1.2A each, where
regulator 3 is placed in slave mode to regulator 2 and
regulator 1 operates independently; or one 1.8A regula-
tor and a second 600mA regulator, where regulator 2 is
placed in slave mode to regulator 1, and regulator 3 is
independent.
When regulator 2 is operating as a slave, pull pins EN2 and
FB2 up to SVIN to enable the slave power stage. Likewise
when regulator 3 is operated as a slave, pull pins EN3 and
FB3 up to SVIN to enable the slave power stage. If the EN
pin of the slave device is pulled low, then the slave power
stage is disabled and that SW pin is Hi-Z.
Shutdown and Soft-Start
ThemaincontrolloopisshutdownafterpullingtheENxpin
to ground and waiting for the tOFF delay period to expire.
When in shutdown, but not in slave mode, a 2k resistor
to PGND discharges the output capacitor. When all three
regulators are turned off the LTC3569 enters low power
shutdown where all functions are disabled, and quiescent
current drops to below 1A.
A soft-start is enabled when any buck is initially turned
on, or following a thermal shutdown. Soft-start ramps the
programmedinternalreferenceatarateofabout0.75V/ms.
The output voltage follows the internal reference voltage
ramp throughout the soft-start period. While in soft-start,
the LTC3569 is forced into pulse-skipping mode until the
PGOOD flag indicates that the output voltage is nearing
the programmed regulation voltage. Once the PGOOD flag
has tripped, if the MODE pin is high the regulator then
operates in Burst Mode, otherwise the LTC3569 continues
to operate in pulse-skipping mode.
Thermal Protection
If the die junction temperature exceeds 150°C, a thermal
shutdown circuit disables all functions in the LTC3569,
and the SW nodes will be pulled low with 2k pull-downs.
After the die temperature drops below 125°C the LTC3569
restartswithoutchangingtheprogrammedreferencevolt-
age DAC; but a soft-start is initiated upon exiting thermal
shutdown.
PGOOD Pin
ThePGOODpinisanopen-drainoutputthatindicateswhen
all of the enabled regulator’s output voltages have risen to
within 92% of their programmed levels. The three bucks
each have separate PGOOD comparators with hysteresis.
The PGOOD flag drops if one of the enabled regulator’s
output voltages drops below 88% of the programmed
level. Output voltage transient drops of duration less than
2s are blanked and not reported at the PGOOD pin. The
PGOOD pin open-drain driver is disabled if PGOOD is
pulled up to a voltage above SVIN.
Programming the Reference
The full-scale reference voltage for each regulator is 0.8V.
The reference can be programmed in –25mV steps by
toggling the respective EN pin up to 15 times for a range
from800mVdownto425mV.ThisisillustratedinFigure3.
The EN pins require a minimum pulse width of 60ns, but
no more than 55s, as the toggle counter times out after
the EN pin remains high for around 125s (tEN). After the
tEN timeout, the counter state is latched and sent on to
the reference voltage DAC, and the counter is reset to full
scale. If the EN pin begins to toggle again, the counter
decrements on each falling edge. If the EN pin is toggled
more than 15 times, the counter remains fixed at the
lowest DAC reference level. To reprogram the DAC to full
scale, hold the EN pin low for 170s (tOFF), turning off the
buck, and then pull EN high once. The buck then initiates
a soft-start as VREF ramps up to the full-scale value.
If the DAC is reprogrammed without forcing a shutdown,
the soft-start ramp is not engaged and the reference
steps to the new value. Avoid using the full-scale 0.8V
reference in programmable output voltage applications
if the application cannot tolerate the transition through
shutdownandsoft-startwhenswitchingbetweendifferent
reference levels.
相關PDF資料
PDF描述
LTC3569EUDC#TRPBF 2.5 A SWITCHING REGULATOR, 3000 kHz SWITCHING FREQ-MAX, PQCC20
LTC3588EDD-2#TRPBF 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO10
LTC3588EMSE-2#PBF 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO10
LTC3588EMSE-2#TRPBF 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO10
LTC3588EDD-2#PBF 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO10
相關代理商/技術參數
參數描述
LTC3569EUD#PBF 功能描述:IC REG BUCK SYNC ADJ TRPL 20QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓(降壓) 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON(1.45x1) 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2
LTC3569EUD#TRPBF 功能描述:IC REG BUCK SYNC ADJ TRPL 20QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓(降壓) 輸出類型:固定 輸出數:1 輸出電壓:1.2V,1.5V,1.8V,2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP,10-MSOP(0.118",3.00mm 寬)裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤
LTC3569EUDC#PBF 功能描述:IC REG BUCK SYNC ADJ TRPL 20QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓(降壓) 輸出類型:固定 輸出數:1 輸出電壓:1.2V,1.5V,1.8V,2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP,10-MSOP(0.118",3.00mm 寬)裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤
LTC3569EUDC#TRPBF 功能描述:IC REG BUCK SYNC ADJ TRPL 20QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓(降壓) 輸出類型:固定 輸出數:1 輸出電壓:1.2V,1.5V,1.8V,2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP,10-MSOP(0.118",3.00mm 寬)裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤
LTC3569EUD-PBF 制造商:LINER 制造商全稱:Linear Technology 功能描述:Triple Buck Regulator With 1.2A and Two 600mA Outputs and Individual Programmable References