參數資料
型號: LTC3544BEUD#TR
廠商: LINEAR TECHNOLOGY CORP
元件分類: 穩壓器
英文描述: 0.8 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PQCC16
封裝: 3 X 3 MM, PLASTIC, MO-220WEED-2, QFN-16
文件頁數: 5/18頁
文件大?。?/td> 288K
代理商: LTC3544BEUD#TR
LTC3544B
3544bfb
A second, more severe transient is caused by switching
in loads with large (>1μF) supply bypass capacitors. The
discharged bypass capacitors are effectively put in parallel
with COUT, causing a rapid drop in VOUT. No regulator can
deliver enough current to prevent this problem if the load
switch resistance is low and it is driven quickly. The only
solution is to limit the rise time of the switch drive so that
the load rise time is limited to approximately (25 CLOAD).
Thus, a 10μF capacitor charging to 3.3V would require a
250μs rise time, limiting the charging current to about
130mA.
PC Board Layout Checklist
When laying out the printed circuit board, the following
checklist should be used to ensure proper operation of the
LTC3544B. These items are also illustrated graphically in
Figures 3 and 4. Check the following in your layout:
1. The power traces, consisting of the PGND trace, the
GNDA trace, the SW traces, the PVIN trace and the VCC
trace should be kept short, direct and wide.
applicaTions inForMaTion
2. Does each of the VFBx pins connect directly to the
respective feedback resistors? The resistive dividers
must be connected between the (+) plate of the cor-
responding output filter capacitor (e.g. C13) and GNDA.
If the circuit being powered is at such a distance from
the part where voltage drops along circuit traces are
large, consider a Kelvin connection from the powered
circuit back to the resistive dividers.
3. Keep C8 and C9 as close to the part as possible.
4. Keep the switching nodes (SWx) away from the sensi-
tive VFBx nodes.
5. Keep the ground connected plates of the input and
output capacitors as close as possible.
6. Care should be taken to provide enough space between
unshielded inductors in order to minimize any trans-
former coupling.
C6
R5
R6
L2
C4
VOUT3
C12
R8
R11
L3
C10
VOUT2
C3
C1
R2
VOUT4
3544B F03
R3
SW200B
SW300
PGND PVIN
SW1000
RUN100
GNDA
C15
R15
R16
RUN100
VFB100
RUN200A
SW200A
VFB200B
VFB200A
VFB200B
VFB300
RUN300
RUN200B
VFB200A
VCC GNDA
PGND
VCC
2.25V TO 5.5V
PVIN
2.25V TO 5.5V
C8
L4
L1
LTC3544B
C9
C13
VOUT1
Figure 3. LTC3544B Layout Diagram
相關PDF資料
PDF描述
LTC3544EUD 0.8 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PQCC16
LTC3547BEDDB 0.7 A DUAL SWITCHING CONTROLLER, 2700 kHz SWITCHING FREQ-MAX, PDSO8
LTC3549EDCB#TRM 0.6 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PDSO6
LTC3549EDCB#TR 0.6 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PDSO6
LTC3553EUD#TRPBF 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC20
相關代理商/技術參數
參數描述
LTC3544EUD 制造商:LINER 制造商全稱:Linear Technology 功能描述:Quad Synchronous Step-Down Regulator: 2.25MHz, 300mA, 200mA, 200mA, 100mA
LTC3544EUD#PBF 功能描述:IC REG BUCK SYNC ADJ QUAD 16QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓(降壓) 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON(1.45x1) 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2
LTC3544EUD#TRPBF 功能描述:IC REG BUCK SYNC ADJ QUAD 16QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓(降壓) 輸出類型:固定 輸出數:1 輸出電壓:1.2V,1.5V,1.8V,2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP,10-MSOP(0.118",3.00mm 寬)裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤
LTC3544EUDPBF 制造商:Linear Technology 功能描述:2.25MHz Sync Step-Down Converter LTC3544
LTC3544EUD-PBF 制造商:LINER 制造商全稱:Linear Technology 功能描述:Quad Synchronous Step-Down Regulator: 2.25MHz, 300mA, 200mA, 200mA, 100mA