- 您現在的位置：買賣IC網 > PDF目錄44991 > LTC3535EDD#PBF (LINEAR TECHNOLOGY CORP) SWITCHING REGULATOR, PDSO12 PDF資料下載
參數資料
| 型號： | LTC3535EDD#PBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING REGULATOR, PDSO12 |
| 封裝： | 3 X 3 MM, 0.75 MM HEIGHT, LEAD FREE, PLASTIC, DFN-12 |
| 文件頁數： | 3/16頁 |
| 文件大?。?/td> | 249K |
| 代理商： | LTC3535EDD#PBF |
LTC3535
11
3535f
Output Disconnect
The LTC3535 is designed to allow true output disconnect
by eliminating body diode conduction of the internal P-
channel MOSFET rectier. This allows for VOUT to go to zero
volts during shutdown, drawing no current from the input
source. It also allows for inrush current limiting at turn-
on, minimizing surge currents seen by the input supply.
Note that to obtain the advantages of output disconnect,
there must not be an external Schottky diode connected
between SW and VOUT. The output disconnect feature also
allows VOUT to be pulled high, without any reverse current
into a battery connected to VIN.
Thermal Shutdown
If the die temperature exceeds 160°C, the LTC3535 will
go into thermal shutdown. All switches will be off and
the soft-start capacitor will be discharged. The device
will be enabled again when the die temperature drops by
about 15°C.
Burst Mode OPERATION
Each channel of the LTC3535 will enter Burst Mode
operation at light load current and return to xed frequency
PWM mode when the load increases. Refer to the Typical
Performance Characteristics to see the output load Burst
Mode threshold current vs VIN. The load current at which
Burst Mode operation is entered can be changed by
adjusting the inductor value. Raising the inductor value
will lower the load current at which Burst Mode operation
is entered.
In Burst Mode operation, the LTC3535 still switches at a
xed frequency of 1MHz, using the same error amplier
and loop compensation for peak current mode control.
This control method eliminates any output transient when
switching between modes. In Burst Mode operation,
energy is delivered to the output until it reaches the
nominal regulation value, then the LTC3535 transitions
to sleep mode where the outputs are off and the LTC3535
consumes only 9μA of quiescent current from VOUT for
each channel. When the output voltage droops slightly,
switching resumes. This maximizes efciency at very light
loads by minimizing switching and quiescent losses. Burst
Mode output voltage ripple, which is typically 1% peak-to-
peak, can be reduced by using more output capacitance
(10μF or greater), or with a small capacitor (10pF to 50pF)
connected between VOUT and FB.
As the load current increases, the LTC3535 will automati-
cally leave Burst Mode operation. Note that larger output
capacitor values may cause this transition to occur at
lighter loads. Once the LTC3535 has left Burst Mode op-
eration and returned to normal operation, it will remain
there until the output load is reduced below the burst
threshold current.
Burst Mode operation is inhibited during start-up and
soft-start and until VOUT is at least 0.24V greater than VIN.
Note that each channel can enter or leave Burst Mode
operation independent of the other channel.
OPERATION (Refer to Block Diagram)
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3538EDCB#PBF | 0.8 A SWITCHING REGULATOR, 1200 kHz SWITCHING FREQ-MAX, PDSO8 |
| LTC3538EDCB | 0.8 A SWITCHING REGULATOR, 1200 kHz SWITCHING FREQ-MAX, PDSO8 |
| LTC3538EDCB#TR | 0.8 A SWITCHING REGULATOR, 1200 kHz SWITCHING FREQ-MAX, PDSO8 |
| LTC3541EDD-2 | 1.25 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PDSO10 |
| LTC3541EDD-2#TR | 1.25 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PDSO10 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3535EDD-TRPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual Channel 550mA 1MHz Synchronous Step-Up DC/DC Converter |
| LTC3536EDD#PBF | 功能描述:IC REG BUCK BOOST SYNC ADJ 12DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2 |
| LTC3536EDD#TRPBF | 功能描述:IC REG BUCK BOOST SYNC ADJ 12DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
| LTC3536EMSE#PBF | 功能描述:IC REG BUCK BST SYNC ADJ 12MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2 |
| LTC3536EMSE#TRPBF | 功能描述:IC REG BUCK BST SYNC ADJ 12MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
發布緊急采購，3分鐘左右您將得到回復。