- 您現在的位置：買賣IC網 > PDF目錄44990 > LTC3427EDC#PBF (LINEAR TECHNOLOGY CORP) 0.5 A SWITCHING REGULATOR, 1500 kHz SWITCHING FREQ-MAX, PDSO6 PDF資料下載
參數資料
| 型號： | LTC3427EDC#PBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 0.5 A SWITCHING REGULATOR, 1500 kHz SWITCHING FREQ-MAX, PDSO6 |
| 封裝： | 2 X 2 MM, LEAD FREE, PLSTIC, DFN-6 |
| 文件頁數： | 10/12頁 |
| 文件大?。?/td> | 202K |
| 代理商： | LTC3427EDC#PBF |
7
LTC3427
3427fa
APPLICATIO S I FOR ATIO
WU
UU
+
SW
LTC3427
1
GND
MINIMIZE
TRACE ON FB
2
VIN
MULTIPLE VIAS
TO GROUND PLANE
VIN
VOUT
FB
SHDN
3427 F01
3
6
5
4
Figure 1. Recommended Component Placement for a Single Layer Board. Traces Carrying High Current are Direct (GND, SW, VIN,
VOUT). Trace Area at FB is Kept Low. Lead Length to Battery Should be Kept Short. VIN and VOUT Ceramic Capacitors Should be as
Close to the LTC3427 as Possible. A Multilayer Board with a Separate Ground Plane is Ideal, but not Absolutely Necessary
COMPONENT SELECTION
Inductor Selection
The LTC3427 can utilize small surface mount and chip
inductors due to its fast 1.25MHz switching frequency. A
minimum inductance value of 3.3
H is necessary for 3.6V
and lower voltage applications and a 4.7
H for output
voltages greater than 3.6V. Larger values of inductance
will allow greater output current capability by reducing the
inductor ripple current. Increasing the inductance above
10
H will increase size while providing little improvement
in output current capability.
The approximate output current capability of the LTC3427
vs Inductance value is given below in Equation 1 and
illustrated graphically in Figure 2.
In
I
VD
fL
D
OUT MAX
P
IN
()
–
–
=
()
2
1
(1)
where:
n = estimated efficiency
IP = peak current limit value (0.5A min)
VIN = input (battery) voltage
D = steady-state duty ratio = (VOUT – VIN)/VOUT
f = switching frequency (1.25MHz typical)
L = inductance value
The inductor current ripple is typically set for 20% to 40%
of the maximum inductor current (IP). High frequency
ferrite core inductor materials reduce frequency depen-
dent power losses compared to cheaper powdered iron
types, improving efficiency. The inductor should have low
ESR (series resistance of the windings) to reduce the I2R
power losses, and must be able to handle the peak
inductor current without saturating. Molded chokes and
some chip inductors usually do not have enough core to
support the peak inductor currents of greater than 500mA
seen on the LTC3427. To minimize radiated noise, use a
toroid, pot core or shielded bobbin inductor. See Table 1
for suggested suppliers.
Output and Input Capacitor Selection
Low ESR (equivalent series resistance) capacitors should
be used to minimize the output voltage ripple. Multilayer
ceramic capacitors are an excellent choice as they have
extremely low ESR and are available in small footprints. A
2.2
F to 10F output capacitor is sufficient for most
applications. Larger values up to 22
F may be used to
obtain extremely low output voltage ripple and improve
transient response. An additional phase lead capacitor
may be required with output capacitors larger than 10
Fto
maintain acceptable phase margin. X5R and X7R dielec-
tric materials are preferred for their ability to maintain
capacitance over wide voltage and temperature ranges.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3496IUFD#TRPBF | SWITCHING CONTROLLER, 2300 kHz SWITCHING FREQ-MAX, PQCC28 |
| LTC3496EUFD#PBF | SWITCHING CONTROLLER, 2300 kHz SWITCHING FREQ-MAX, PQCC28 |
| LTC3496EUFD#TRPBF | SWITCHING CONTROLLER, 2300 kHz SWITCHING FREQ-MAX, PQCC28 |
| LTC3521EFE#TRPBF | SWITCHING REGULATOR, 1350 kHz SWITCHING FREQ-MAX, PDSO20 |
| LTC3521EUF#TRPBF | SWITCHING REGULATOR, 1350 kHz SWITCHING FREQ-MAX, PQCC24 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3428 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:4A, 2MHz Dual Phase Step-Up DC/DC Converter in 3mm 3mm DFN |
| LTC3428EDD | 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Up 1.6V to 4.5V 10-Pin DFN EP |
| LTC3428EDD#PBF | 功能描述:IC REG BOOST ADJ 4A 10DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2 |
| LTC3428EDD#TRPBF | 功能描述:IC REG BOOST ADJ 4A 10DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
| LTC3428EDDPBF | 制造商:Linear Technology 功能描述:4A 1MHz 2-ph.Step-up DC-DC Conv DFN10EP |
發布緊急采購，3分鐘左右您將得到回復。