- 您現在的位置：買賣IC網 > PDF目錄44990 > LTC3412AMPFE#TR (LINEAR TECHNOLOGY CORP) 6 A SWITCHING REGULATOR, 4000 kHz SWITCHING FREQ-MAX, PDSO16 PDF資料下載
參數資料
| 型號： | LTC3412AMPFE#TR |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 6 A SWITCHING REGULATOR, 4000 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封裝： | 4.40 MM, PLASTIC, TSSOP-16 |
| 文件頁數： | 4/20頁 |
| 文件大小： | 316K |
| 代理商： | LTC3412AMPFE#TR |
LTC3412A
3412afe
ApplicAtions inForMAtion
Output Voltage Programming
The output voltage is set by an external resistive divider
according to the following equation:
VOUT = 0.8V 1+
R2
R1
The resistive divider allows pin VFB to sense a fraction of
the output voltage as shown in Figure 2.
The value for IBURST is determined by the desired amount
of output voltage ripple. As the value of IBURST increases,
the sleep period between pulses and the output voltage
ripple increase. The burst clamp voltage, VBURST, can be
set by a resistor divider from the VFB pin to the SGND pin
as shown in Figure 1.
Pulse skipping, which is a compromise between low out-
put voltage ripple and efficiency, can be implemented by
connecting pin SYNC/MODEto ground. This sets IBURST to
0A. In this condition, the peak inductor current is limited
by the minimum on-time of the current comparator. The
lowest output voltage ripple is achieved while still operat-
ing discontinuously. During very light output loads, pulse
skipping allows only a few switching cycles to be skipped
while maintaining the output voltage in regulation.
Frequency Synchronization
The LTC3412A’s internal oscillator can be synchronized
to an external clock signal. During synchronization, the
top MOSFET turn-on is locked to the falling edge of the
external frequency source. The synchronization frequency
range is 300kHz to 4MHz. Synchronization only occurs if
the external frequency is greater than the frequency set
by the external resistor. Because slope compensation
is generated by the oscillator’s RC circuit, the external
frequency should be set 25% higher than the frequency
set by the external resistor to ensure that adequate slope
compensation is present.
Soft-Start
The RUN/SS pin provides a means to shut down the
LTC3412A as well as a timer for soft-start. Pulling the
RUN/SS pin below 0.5V places the LTC3412A in a low
quiescent current shutdown state (IQ < 1A).
The LTC3412A contains an internal soft-start clamp that
gradually raises the clamp on ITH after the RUN/SS pin is
pulled above 2V. The full current range becomes available
on ITH after 1024 switching cycles. If a longer soft-start
period is desired, the clamp on ITH can be set externally
with a resistor and capacitor on the RUN/SS pin as shown
in Figure 1. The soft-start duration can be calculated by
using the following formula:
tSS =RSSCSS ln
VIN
VIN –1.8V
(SECONDS)
Burst Clamp Programming
If the voltage on the SYNC/MODE pin is less than VIN by
1V, Burst Mode operation is enabled. During Burst Mode
Operation, the voltage on the SYNC/MODE pin determines
the burst clamp level, which sets the minimum peak
inductor current, IBURST. To select the burst clamp level,
use the graph of Minimum Peak Inductor Current vs Burst
Clamp Voltage in the Typical Performance Characteristics
section.
VBURST is the voltage on the SYNC/MODE pin. IBURST
can only be programmed in the range of 0A to 6A. For
values of VBURST greater than 1V, IBURST is set at 6A. For
values of VBURST less than 0.4V, IBURST is set at 0A. As
the output load current drops, the peak inductor currents
decrease to keep the output voltage in regulation. When
the output load current demands a peak inductor current
that is less than IBURST, the burst clamp will force the peak
inductor current to remain equal to IBURST regardless of
further reductions in the load current. Since the average
inductor current is greater than the output load current,
the voltage on the ITH pin will decrease. When the ITH
voltage drops to 150mV, sleep mode is enabled in which
both power MOSFETs are shut off along with most of the
circuitry to minimize power consumption. All circuitry is
turned back on and the power MOSFETs begin switching
again when the output voltage drops out of regulation.
Figure 2. Setting the Output Voltage
3412A F02
LTC3412A
VFB
SGND
VOUT
R2
R1
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3412AMPFE | 6 A SWITCHING REGULATOR, 4000 kHz SWITCHING FREQ-MAX, PDSO16 |
| LTC3412IFE#TR | 6.5 A SWITCHING REGULATOR, 4000 kHz SWITCHING FREQ-MAX, PDSO16 |
| LTC3412IFE | 6.5 A SWITCHING REGULATOR, 4000 kHz SWITCHING FREQ-MAX, PDSO16 |
| LTC3427EDC#PBF | 0.5 A SWITCHING REGULATOR, 1500 kHz SWITCHING FREQ-MAX, PDSO6 |
| LTC3496IUFD#TRPBF | SWITCHING CONTROLLER, 2300 kHz SWITCHING FREQ-MAX, PQCC28 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3412EFE | 功能描述:IC REG BUCK SYNC ADJ 16TSSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓（升壓） 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT |
| LTC3412EFE#PBF | 功能描述:IC REG BUCK SYNC ADJ 16TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2 |
| LTC3412EFE#TR | 功能描述:IC REG BUCK SYNC ADJ 16TSSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓（升壓） 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT |
| LTC3412EFE#TRPBF | 功能描述:IC REG BUCK SYNC ADJ 16TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓（升壓） 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT |
| LTC3412EFEPBF | 制造商:Linear Technology 功能描述:LTC3412 adj 2.5A sync SD dc-dc converter |
發布緊急采購，3分鐘左右您將得到回復。