參數資料
型號： LTC3411IMS
廠商： LINEAR TECHNOLOGY CORP
元件分類： 穩壓器
英文描述： 2 A SWITCHING REGULATOR, 4000 kHz SWITCHING FREQ-MAX, PDSO10
封裝： PLASTIC, MSOP-10
文件頁數： 4/24頁
文件大?。?/td> 247K
代理商： LTC3411IMS
LTC3411
12
3411fb
Ceramic Input and Output Capacitors
Higher value, lower cost ceramic capacitors are now be-
coming available in smaller case sizes. These are tempting
for switching regulator use because of their very low ESR.
Unfortunately, the ESR is so low that it can cause loop
stability problems. Solid tantalum capacitor ESR generates
a loop “zero” at 5kHz to 50kHz that is instrumental in giving
acceptable loop phase margin. Ceramic capacitors remain
capacitive to beyond 300kHz and ususally resonate with
their ESL before ESR becomes effective. Also, ceramic
caps are prone to temperature effects which requires the
designer to check loop stability over the operating tem-
perature range. To minimize their large temperature and
voltage coefcients, only X5R or X7R ceramic capacitors
should be used. A good selection of ceramic capacitors
is available from Taiyo Yuden, TDK and Murata.
Great care must be taken when using only ceramic input
and output capacitors. When a ceramic capacitor is used
at the input and the power is being supplied through long
wires, such as from a wall adapter, a load step at the output
can induce ringing at the VIN pin. At best, this ringing can
couple to the output and be mistaken as loop instability.
At worst, the ringing at the input can be large enough to
damage the part.
Since the ESR of a ceramic capacitor is so low, the input
and output capacitor must instead fulll a charge storage
requirement. During a load step, the output capacitor must
instantaneously supply the current to support the load
until the feedback loop raises the switch current enough
to support the load. The time required for the feedback
loop to respond is dependent on the compensation com-
ponents and the output capacitor size. Typically, 3 to 4
cycles are required to respond to a load step, but only in
the rst cycle does the output drop linearly. The output
droop, VDROOP, is usually about 2 to 3 times the linear
drop of the rst cycle. Thus, a good place to start is with
the output capacitor size of approximately:
C
I
fV
OUT
O
DROOP
≈
Δ
25
.
More capacitance may be required depending on the duty
cycle and load step requirements.
In most applications, the input capacitor is merely required
to supply high frequency bypassing, since the impedance
to the supply is very low. A 10μF ceramic capacitor is
usually enough for these conditions.
Setting the Output Voltage
The LTC3411 develops a 0.8V reference voltage between
the feedback pin, VFB, and the signal ground as shown in
Figure 5. The output voltage is set by a resistive divider
according to the following formula:
VV
R
OUT
≈+
08
1
2
1
.
Keeping the current small (<5μA) in these resistors maxi-
mizes efciency, but making them too small may allow
stray capacitance to cause noise problems and reduce the
phase margin of the error amp loop.
To improve the frequency response, a feed-forward capaci-
tor CF may also be used. Great care should be taken to
route the VFB line away from noise sources, such as the
inductor or the SW line.
APPLICATIONS INFORMATION
相關PDF資料
PDF描述
LTC3411IDD#TR 2 A SWITCHING REGULATOR, 4000 kHz SWITCHING FREQ-MAX, PDSO10
LTC3412AMPFE#TR 6 A SWITCHING REGULATOR, 4000 kHz SWITCHING FREQ-MAX, PDSO16
LTC3412AMPFE 6 A SWITCHING REGULATOR, 4000 kHz SWITCHING FREQ-MAX, PDSO16
LTC3412IFE#TR 6.5 A SWITCHING REGULATOR, 4000 kHz SWITCHING FREQ-MAX, PDSO16
LTC3412IFE 6.5 A SWITCHING REGULATOR, 4000 kHz SWITCHING FREQ-MAX, PDSO16
相關代理商/技術參數
參數描述
LTC3411IMS#PBF 功能描述:IC REG BUCK SYNC ADJ 10MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓（升壓） 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT
LTC3411IMS#TRPBF 功能描述:IC REG BUCK SYNC ADJ 10MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓（升壓） 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT
LTC3412 制造商:LINER 制造商全稱:Linear Technology 功能描述:8A, 4MHz, Monolithic Synchronous Step-Down Regulator
LTC3412A 制造商:LINER 制造商全稱:Linear Technology 功能描述:3A, 4MHz, Monolithic Synchronous Step-Down Regulator
LTC3412AEFE 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Down 2.25V to 5.5V 16-Pin TSSOP EP
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*