參數資料
型號: LTC2844IG#TRPBF
廠商: Linear Technology
文件頁數: 6/20頁
文件大?。?/td> 0K
描述: IC TXRX 3.3V MULTIPROTCOL 28SSOP
標準包裝: 2,000
類型: 收發器
驅動器/接收器數: 4/4
規程: 多協議
電源電壓: 3.3V
安裝類型: 表面貼裝
封裝/外殼: 28-SSOP(0.209",5.30mm 寬)
供應商設備封裝: 28-SSOP
包裝: 帶卷 (TR)
14
LTC2844
sn2844 2844fs
A
'
B
C
B
'
C
'
GENERATOR
BALANCED
INTERCONNECTING
CABLE
LOAD
CABLE
TERMINATION
RECEIVER
2844 F18
50
125
50
50
125
50
Figure 18. Typical V.35 Interface
Figure 19. V.35 Receiver Configuration
V.35 Interface
A typical V.35 balanced interface is shown in Figure 18. A
V.35 differential generator with outputs A and B with
ground C is connected to a differential receiver with
ground C
', inputs A' connected to A, B' connected to B. The
V.35 interface requires a T or delta network termination at
the receiver end and the generator end. The receiver
differential impedance measured at the connector must be
100
±10, and the impedance between shorted termi-
nals (A
' and B') and ground C' must be 150
±15.
In V.35 mode, both switches S1 and S2 inside the LTC2846
are on, connecting the T network impedance as shown in
Figure 19. The 30k input impedance of the receiver is
placed in parallel with the T network termination, but does
not affect the overall input impedance significantly.
The generator differential impedance must be 50
to
150
and the impedance between shorted terminals (A
and B) and ground C must be 150
±15. For the
generator termination, switches S1 and S2 are both on as
shown in Figure 20.
No-Cable Mode
The no-cable mode (M0 = M1 = M2 = 1) is intended for the
case when the cable is disconnected from the connector.
The bias circuitry, drivers and receivers are turned off, the
driver outputs are forced into a high impedance state, and
the supply current drops to less than 600
A.
LTC2846 Supplies
The LTC2846 uses an internal capacitive charge pump to
generate VDD and VEE as shown in Figure 21. A voltage
doubler generates about 8V on VDD and a voltage inverter
generates about – 7.5V for VEE. Three 1F surface mounted
tantalum or ceramic capacitors are required for C1, C2 and
C3. The VEE capacitor C4 should be a minimum of 3.3F.
All capacitors are 16V and should be placed as close as
possible to the LTC2846 to reduce EMI.
The LTC2846 has an internal boost switching regulator
which generates a 5V output from the 3.3V supply as
shown in Figure 22. The 5V VCC supplies its internal charge
pump and transceivers as well as its companion chip.
APPLICATIONS INFORMATION
WU
U
Figure 20. V.35 Driver
V.35 DRIVER
A
B
C
51.5
S2
S1
2844 F20
51.5
LTC2846
124
R3
124
R5
20k
LTC2846
RECEIVER
2844 F19
A
'
B
'
C
'
R1
51.5
R8
6k
S2
S3
R2
51.5
R6
10k
R7
10k
GND
R4
20k
S1
33
32
31
30
2844 F21
7
6
5
8
C3
1
F
C5
10
F
5V
C1
1
F
C2
1
F
C4
3.3
F
LTC2846
VDD
C1+
C1
VCC
C2+
C2
VEE
GND
+
Figure 21. Charge Pump
相關PDF資料
PDF描述
LTC2852MPS#PBF IC TXRX RS485 20MBPS 14-SOIC
LTC486ISW#TRPBF IC DVR RS485 LOW PWR QUAD 16SOIC
LTC490IS8#TRPBF IC TXRX RS485 LOW POWER 8-SOIC
LTC491IS#TRPBF IC TXRX RS485 LOW POWER 14-SOIC
LTC6900IS5#TR IC OSC SILICON 20MHZ TSOT23-5
相關代理商/技術參數
參數描述
LTC2845CG 功能描述:IC TXRX 3.3V MULTIPROTCOL 36SSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 標準包裝:250 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-TSSOP(0.173",4.40mm 寬) 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR)
LTC2845CG#PBF 功能描述:IC TXRX 3.3V MULTIPROTCOL 36SSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 標準包裝:250 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-TSSOP(0.173",4.40mm 寬) 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR)
LTC2845CG#TR 功能描述:IC TXRX 3.3V MULTIPROTCOL 36SSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 標準包裝:250 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-TSSOP(0.173",4.40mm 寬) 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR)
LTC2845CG#TRPBF 功能描述:IC TXRX 3.3V MULTIPROTCOL 36SSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 標準包裝:250 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-TSSOP(0.173",4.40mm 寬) 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR)
LTC2845CUHF 功能描述:IC TXRX 3.3V MULTIPROTOCOL 38QFN RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 標準包裝:250 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-TSSOP(0.173",4.40mm 寬) 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR)