- 您現在的位置：買賣IC網 > PDF目錄10019 > LTC2844IG#PBF (Linear Technology)IC TXRX 3.3V MULTIPROTCOL 28SSOP PDF資料下載
參數資料
| 型號： | LTC2844IG#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 7/20頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC TXRX 3.3V MULTIPROTCOL 28SSOP |
| 標準包裝： | 47 |
| 類型： | 收發器 |
| 驅動器/接收器數： | 4/4 |
| 規程： | 多協議 |
| 電源電壓： | 3.3V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 28-SSOP（0.209"，5.30mm 寬） |
| 供應商設備封裝： | 28-SSOP |
| 包裝： | 管件 |
15
LTC2844
sn2844 2844fs
mode, the TXD signal is routed to Pins 2 and 14 via Driver 1
in the LTC2846. In DCE mode, Driver 1 now routes the RXD
signal to Pins 2 and 14.
Multiprotocol Interface with RL, LL, TM and a DB-25
Connector
If the RL, LL and TM signals are implemented, there are not
enough drivers and receivers available in the LTC2846/
LTC2844. In Figure 25, the required control signals are
handled by the LTC2845. The LTC2845 has an additional
single-ended driver/receiver pair that can handle two more
optional control signals such as TM and LL.
Cable-Selectable Multiprotocol Interface
A cable-selectable multiprotocol DTE/DCE interface is
shown in Figure 26. The select lines M0, M1 and DCE/DTE
are brought out to the connector. The mode is selected by
the cable by wiring M0 (connector Pin 18) and M1 (con-
nector Pin 21) and DCE/DTE (connector Pin 25) to ground
(connector Pin 7) or letting them float. If M0, M1 or DCE/
DTE is floating, internal pull-up current sources will pull
the signals to VIN. The select bit M2 is floating and
therefore, internally pulled high. When the cable is pulled
out, the interface will go into the no-cable mode.
Compliance Testing
The LTC2846/LTC2844 chipset has been tested by TUV
Rheinland of North America Inc. and passed the NET1,
NET2 and TBR2 requirements. Copies of the test report are
available from LTC or TUV Rheinland of North America Inc.
The title of the report is Test Report No. TBR2/051501/02
The address of TUV Rheinland of North America Inc. is:
Receiver Fail-Safe
All LTC2846/LTC2844 receivers feature fail-safe opera-
tion in all modes. If the receiver inputs are left floating or
shorted together by a termination resistor, the receiver
output will always be forced to a logic high.
DTE vs DCE Operation
The DCE/DTE pin acts as an enable for Driver 3/Receiver 1
in the LTC2846, and Driver 3/Receiver 1 and Receiver 4/
Driver 4 in the LTC2844.
The LTC2846/LTC2844 can be configured for either DTE
or DCE operation in one of two ways: a dedicated DTE or
DCE port with a connector of appropriate gender or a port
with one connector that can be configured for DTE or DCE
operation by rerouting the signals to the LTC2846/LTC2844
using a dedicated DTE cable or dedicated DCE cable.
A dedicated DTE port using a DB-25 male connector is
shown in Figure 23. The interface mode is selected by logic
outputs from the controller or from jumpers to either VIN
or GND on the mode select pins.
A port with one DB-25 connector, but can be configured
for either DTE or DCE operation is shown in Figure 24. The
configuration requires separate cables for proper signal
routing in DTE or DCE operation. For example, in DTE
APPLICATIONS INFORMATION
WU
U
Figure 22. Boost Switching Regulator
GND
VIN
SW
SHDN
FB
VIN
3.3V
4
35
2844 F22
D1
L1
5.6
H
2, 34
R1
13k
BOOST
SWITCHING
REGULATOR
C5
10
F
C6
10
F
R2
4.3k
VCC
5V
480mA
C1,C2: TAIYO YUDEN X5R JMK316BJ106ML
D1: ON SEMICONDUCTOR MBR0520
L1: SUMIDA CR43-5R6
SHDN
336
TUV Rheinland of North America Inc.
1775, Old Highway 8 NW, Suite 107
St. Paul, MN 55112
Tel. (651) 639-0775
Fax (651) 639-0873
相關PDF資料 |
PDF描述 |
|---|---|
| IDT72V851L20PF8 | IC FIFO SYNC 4096X18 20NS 64QFP |
| MS27497E16B8SB | CONN RCPT 8POS WALL MNT W/SCKT |
| IDT72605L35PF8 | IC FIFO BI SYNC 256X18 64-TQFP |
| LTC2845CG#TRPBF | IC TXRX 3.3V MULTIPROTCOL 36SSOP |
| LTC2845CG#TR | IC TXRX 3.3V MULTIPROTCOL 36SSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2845CG | 功能描述:IC TXRX 3.3V MULTIPROTCOL 36SSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:250 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR) |
| LTC2845CG#PBF | 功能描述:IC TXRX 3.3V MULTIPROTCOL 36SSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:250 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR) |
| LTC2845CG#TR | 功能描述:IC TXRX 3.3V MULTIPROTCOL 36SSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:250 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR) |
| LTC2845CG#TRPBF | 功能描述:IC TXRX 3.3V MULTIPROTCOL 36SSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:250 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR) |
| LTC2845CUHF | 功能描述:IC TXRX 3.3V MULTIPROTOCOL 38QFN RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:250 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。