- 您現在的位置：買賣IC網 > PDF目錄10355 > LTC2489CDE#PBF (Linear Technology)IC ADC 16BIT DELTA SIG 14-DFN PDF資料下載
參數資料
| 型號： | LTC2489CDE#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 8/24頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 16BIT DELTA SIG 14-DFN |
| 標準包裝： | 91 |
| 位數： | 16 |
| 采樣率（每秒）： | 7.5 |
| 數據接口： | I²C，串行 |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 480µW |
| 電壓電源： | 單電源 |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 14-WFDFN 裸露焊盤 |
| 供應商設備封裝： | 14-DFN-EP（4x3） |
| 包裝： | 管件 |
| 輸入數目和類型： | 4 個單端，雙極；2 個差分，雙極 |
| 配用： | DC1010A-B-ND - BOARD DELTA SIGMA ADC LTC2489 |
LTC2489
16
2489fa
without changing the channel, a Stop may be issued after
acknowledgement of the global write command. Global
read commands are not allowed and the converters will
NAK a global read request.
Driving the Input and Reference
The input and reference pins of the LTC2489 are connected
directly to a switched capacitor network. Depending on
the relationship between the differential input voltage and
the differential reference voltage, these capacitors are
switched between these four pins. Each time a capacitor
is switched between two of these pins, a small amount
of charge is transferred. A simplified equivalent circuit is
shown in Figure 9.
When using the LTC2489’s internal oscillator, the input
capacitor array is switched at 123kHz. The effect of the
charge transfer depends on the circuitry driving the in-
put/reference pins. If the total external RC time constant
is less than 580ns the errors introduced by the sampling
process are negligible since complete settling occurs.
Typically, the reference inputs are driven from a low
impedance source. In this case, complete settling occurs
even with large external bypass capacitors. The inputs
(CH0-CH3, COM), on the other hand, are typically driven
from larger source resistances. Source resistances up
to 10k may interface directly to the LTC2489 and settle
completely; however, the addition of external capacitors
at the input terminals in order to filter unwanted noise
(antialiasing) results in incomplete settling.
Automatic Differential Input Current Cancellation
In applications where the sensor output impedance is
low (up to 10k
Ω with no external bypass capacitor or up
to 500
Ω with 0.001μF bypass), complete settling of the
input occurs. In this case, no errors are introduced and
direct digitization is possible.
For many applications, the sensor output impedance
combined with external input bypass capacitors produces
RC time constants much greater than the 580ns required
for 1ppm accuracy. For example, a 10k
Ω bridge driving a
0.1μF capacitor has a time constant an order of magnitude
greater than the required maximum.
The LTC2489 uses a proprietary switching algorithm
that forces the average differential input current to zero
independent of external settling errors. This allows direct
digitization of high impedance sensors without the need
for buffers.
The switching algorithm forces the average input current
on the positive input (IIN+) to be equal to the average input
current on the negative input (IIN–). Over the complete
conversion cycle, the average differential input current
(IIN+ – IIN–) is zero. While the differential input current is
APPLICATIONS INFORMATION
IN+
IN–
10kΩ
INTERNAL
SWITCH
NETWORK
10kΩ
CEQ
12μF
10kΩ
IIN
–
REF+
IREF
+
IIN
+
IREF
–
2489 F09
SWITCHING FREQUENCY
fSW = 123kHz INTERNAL OSCILLATOR
fSW = 0.4 fEOSC EXTERNAL OSCILLATOR
REF–
10kΩ
100Ω
INPUT
MULTIPLEXER
100Ω
Figure 9. Equivalent Analog Input Circuit
IIN+
(
)
AVG
= IIN–
(
)
AVG
=
VIN(CM) VREF(CM)
0.5
REQ
IREF+
(
)
AVG
≈
1.5VREF + VREF(CM) –VIN(CM)
(
)
0.5 REQ
–
VIN
2
VREF REQ
where:
VREF = REF+ REF
VREF(CM) =
REF+ –REF
2
VIN =IN+ IN , WHERE IN+ ANDIN ARE THE SELECTEDINPUT CHANNELS
VIN(CM) =
IN+ –IN
2
REQ = 2.98MΩ INTERNAL OSCILLATOR
REQ = 0.83310
12
(
)/f
EOSC EXTERNAL OSCILLATOR
相關PDF資料 |
PDF描述 |
|---|---|
| VI-J5T-MX | CONVERTER MOD DC/DC 6.5V 75W |
| MAX9717DEBL+T | IC AMP AUDIO PWR 1.4W STER 9UCSP |
| D38999/20WA98AN | CONN HSG RCPT 3POS WALL MT PINS |
| MAX9717CEBL+T | IC AMP AUDIO PWR 1.4W STER 9UCSP |
| MS27484E14A18SLC | CONN HSG PLUG 18POS STRGHT SCKT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2489IDE | 制造商:Linear Technology 功能描述:ADC Single Delta-Sigma 7.5sps 16-bit Serial 14-Pin DFN EP |
| LTC2489IDE#PBF | 功能描述:IC ADC 16BIT DELTA SIG 14-DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6 |
| LTC2489IDE#TRPBF | 功能描述:IC ADC 16BIT DELTA SIG 14-DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| LTC2492CDE | 制造商:Linear Technology 功能描述:ADC Single Delta-Sigma 7.5sps 24-bit Serial 14-Pin DFN EP |
| LTC2492CDE#PBF | 功能描述:IC ADC 24BIT DELTA SIG 14-DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6 |
發布緊急采購，3分鐘左右您將得到回復。