with an external conversion clock (CA0/f0 co" />
參數資料
型號: LTC2485IDD#PBF
廠商: Linear Technology
文件頁數: 19/40頁
文件大?。?/td> 0K
描述: IC ADC 24BIT I2C 10-DFN
標準包裝: 121
位數: 24
采樣率(每秒): 6.8
數據接口: I²C,串行
轉換器數目: 1
功率耗散(最大): 480µW
電壓電源: 單電源
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 10-WFDFN 裸露焊盤
供應商設備封裝: 10-DFN(3x3)
包裝: 管件
輸入數目和類型: 1 個差分,雙極
產品目錄頁面: 1348 (CN2011-ZH PDF)
配用: DC956A-ND - BOARD DELTA SIGMA ADC LTC2485
LTC2485
26
2485fc
APPLICATIONS INFORMATION
with an external conversion clock (CA0/f0 connected to
an external oscillator), the LTC2485 output data rate can
be increased as desired. The duration of the conversion
phase is 41036/fEOSC. If fEOSC = 307.2kHz, the converter
behaves as if the internal oscillator is used and the notch
is set at 60Hz.
An increase in fEOSC over the nominal 307.2kHz will
translate into a proportional increase in the maximum
output data rate. The increase in output rate is neverthe-
less accompanied by three potential effects, which must
be carefully considered.
First, a change in fEOSC will result in a proportional change
in the internal notch position and in a reduction of the
converter differential mode rejection at the power line fre-
quency. In many applications, the subsequent performance
degradation can be substantially reduced by relying upon
the LTC2485’s exceptional common mode rejection and by
carefully eliminating common mode to differential mode
conversion sources in the input circuit. The user should
avoid single-ended input lters and should maintain a
very high degree of matching and symmetry in the circuits
driving the IN+ and INpins.
Second, the increase in clock frequency will increase
proportionally the amount of sampling charge transferred
through the input and the reference pins. If large external
input and/or reference capacitors (CIN, CREF) are used,
the previous section provides formulae for evaluating
the effect of the source resistance upon the converter
performance for any value of fEOSC. If small external input
and/or reference capacitors (CIN, CREF) are used, the ef-
fect of the external source resistance upon the LTC2485
typical performance can be inferred from Figures 14,
15, 16 and 17 in which the horizontal axis is scaled by
307200/fEOSC.
Third, an increase in the frequency of the external oscillator
above 1MHz (a more than 3X increase in the output data
rate) will start to decrease the effectiveness of the internal
autocalibration circuits. This will result in a progressive
degradation in the converter accuracy and linearity. Typical
measured performance curves for output data rates up to
100 readings per second are shown in Figures 21 to 28. In
order to obtain the highest possible level of accuracy from
this converter at output data rates above 20 readings per
second, the user is advised to maximize the power supply
voltage used and to limit the maximum ambient operating
temperature. In certain circumstances, a reduction of the
differential reference voltage may be benecial.
Input Bandwidth
The combined effect of the internal SINC4 digital lter and
of the analog and digital autocalibration circuits determines
the LTC2485 input bandwidth. When the internal oscillator
is used with the notch set at 60Hz, the 3dB input bandwidth
is 3.63Hz. When the internal oscillator is used with the
notch set at 50Hz, the 3dB input bandwidth is 3.02Hz. If
an external conversion clock generator of frequency fEOSC
is connected to the CA0/f0 pin, the 3dB input bandwidth
is 11.8 10–6 fEOSC.
OUTPUT DATA RATE (READINGS/SEC)
–10
OFFSET
ERROR
(ppm
OF
V
REF
)
10
30
50
0
20
40
20
40
60
80
2485 F21
100
10
030
50
70
90
VIN(CM) = VREF(CM)
VCC = VREF = 5V
VIN = 0V
CA0/f0 = EXT CLOCK
TA = 85°C
TA = 25°C
OUTPUT DATA RATE (READINGS/SEC)
0
+FS
ERROR
(ppm
OF
V
REF
)
500
1500
2000
2500
3500
10
50
70
2485 F22
1000
3000
40
90 100
20 30
60
80
VIN(CM) = VREF(CM)
VCC = VREF = 5V
CA0/f0 = EXT CLOCK
TA = 85°C
TA = 25°C
Figure 21. Offset Error vs Output Data Rate and Temperature
Figure 22. +FS Error vs Output Data Rate and Temperature
相關PDF資料
PDF描述
LTC1443CDHD#TRPBF IC COMP W/REF LOW PWR QUAD 16DFN
LTC1444CDHD#TRPBF IC COMP QD LP 1.221VREF 16-DFN
AD9200ARSZ IC ADC 10BIT CMOS 20MSPS 28-SSOP
LTC1445CDHD#TRPBF IC COMP QD LP 1.221VREF 16-DFN
AD9283BRSZ-50 IC ADC 8BIT 50MSPS 3V 20-SSOP
相關代理商/技術參數
參數描述
LTC2486CDE#PBF 功能描述:IC ADC 16BIT W/PGA 14-DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率(每秒):1M 數據接口:串行,SPI? 轉換器數目:1 功率耗散(最大):- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤(4x4) 包裝:Digi-Reel® 輸入數目和類型:8 個單端,單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6
LTC2486CDE#TRPBF 功能描述:IC ADC 16BIT W/PGA 14-DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率(每秒):15 數據接口:MICROWIRE?,串行,SPI? 轉換器數目:1 功率耗散(最大):480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN(5x7) 包裝:帶卷 (TR) 輸入數目和類型:16 個單端,雙極;8 個差分,雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494
LTC2486IDE#PBF 功能描述:IC ADC 16BIT W/PGA 14-DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率(每秒):1M 數據接口:串行,SPI? 轉換器數目:1 功率耗散(最大):- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤(4x4) 包裝:Digi-Reel® 輸入數目和類型:8 個單端,單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6
LTC2486IDE#TRPBF 功能描述:IC ADC 16BIT W/PGA 14-DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率(每秒):15 數據接口:MICROWIRE?,串行,SPI? 轉換器數目:1 功率耗散(最大):480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN(5x7) 包裝:帶卷 (TR) 輸入數目和類型:16 個單端,雙極;8 個差分,雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494
LTC2487CDE#PBF 功能描述:IC ADC 16BIT DELTA SIG 14-DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率(每秒):45k 數據接口:串行 轉換器數目:2 功率耗散(最大):315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端,單極