TIMING CHARACTERISTICS The l denotes the specic" />
參數資料
型號: LTC2484IDD#PBF
廠商: Linear Technology
文件頁數: 38/42頁
文件大?。?/td> 0K
描述: IC ADC 24BIT 10-DFN
標準包裝: 121
位數: 24
采樣率(每秒): 6.8
數據接口: MICROWIRE?,串行,SPI?
轉換器數目: 1
功率耗散(最大): 480µW
電壓電源: 單電源
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 10-WFDFN 裸露焊盤
供應商設備封裝: 10-DFN(3x3)
包裝: 管件
輸入數目和類型: 1 個差分,雙極
產品目錄頁面: 1348 (CN2011-ZH PDF)
配用: DC939A-ND - BOARD DELTA SIGMA ADC LTC2484
LTC2484
5
2484fd
TIMING CHARACTERISTICS The l denotes the specications which apply over the full operating temperature
range, otherwise specications are at TA = 25°C. (Note 3)
SYMBOL
PARAMETER
CONDITIONS
MIN
TYP
MAX
UNITS
fEOSC
External Oscillator Frequency Range
(Note 15)
l
10
4000
kHz
tHEO
External Oscillator High Period
l
0.125
100
μs
tLEO
External Oscillator Low Period
l
0.125
100
μs
tCONV_1
Conversion Time for 1x Speed Mode
50Hz Mode
60Hz Mode
Simultaneous 50Hz/60Hz Mode
l
157.2
131.0
144.1
160.3
133.6
146.9
163.5
136.3
149.9
ms
External Oscillator
l
41036/fEOSC (in kHz)
ms
tCONV_2
Conversion Time for 2x Speed Mode
50Hz Mode
60Hz Mode
Simultaneous 50Hz/60Hz Mode
l
78.7
65.6
72.2
80.3
66.9
73.6
81.9
68.2
75.1
ms
External Oscillator
l
20556/fEOSC (in kHz)
ms
fISCK
Internal SCK Frequency
Internal Oscillator (Note 10)
External Oscillator (Notes 10, 11)
38.4
fEOSC/8
kHz
DISCK
Internal SCK Duty Cycle
(Note 10)
l
45
55
%
fESCK
External SCK Frequency Range
(Note 10)
l
4000
kHz
tLESCK
External SCK Low Period
(Note 10)
l
125
ns
tHESCK
External SCK High Period
(Note 10)
l
125
ns
tDOUT_ISCK
Internal SCK 32-Bit Data Output Time
Internal Oscillator (Notes 10, 12)
l
0.81
0.83
0.85
ms
External Oscillator (Notes 10, 11)
l
256/fEOSC (in kHz)
ms
tDOUT_ESCK
External SCK 32-Bit Data Output Time
(Note 10)
l
32/fESCK (in kHz)
ms
t1
CS
↓ to SDO Low
l
0200
ns
t2
CS
↑ to SDO Hi-Z
l
0200
ns
t3
CS
↓ to SCK↓
(Note 10)
l
0200
ns
t4
CS
↓ to SCK↑
(Note 10)
l
50
ns
tKQMAX
SCK
↓ to SDO Valid
l
200
ns
tKQMIN
SDO Hold After SCK
(Note 5)
l
15
ns
t5
SCK Set-Up Before CS
l
50
ns
t6
SCK Hold After CS
l
50
ns
t7
SDI Setup Before SCK
(Note 5)
l
100
ns
t8
SDI Hold After SCK
(Note 5)
l
100
ns
Note 1: Stresses beyond those listed under Absolute Maximum Ratings
may cause permanent damage to the device. Exposure to any Absolute
Maximum Rating condition for extended periods may affect device
reliability and lifetime
Note 2: All voltage values are with respect to GND.
Note 3: VCC = 2.7V to 5.5V unless otherwise specied.
VREFCM = VREF/2, FS = 0.5VREF
VIN = IN+ – IN, VIN(CM) = (IN+ + IN)/2
Note 4: Use internal conversion clock or external conversion clock source
with fEOSC = 307.2kHz unless otherwise specied.
Note 5: Guaranteed by design, not subject to test.
Note 6: Integral nonlinearity is dened as the deviation of a code from a
straight line passing through the actual endpoints of the transfer curve.
The deviation is measured from the center of the quantization band.
Note 7: 50Hz mode (internal oscillator) or fEOSC = 256kHz ±2%
(external oscillator).
Note 8: 60Hz mode (internal oscillator) or fEOSC = 307.2kHz ±2%
(external oscillator).
Note 9: Simultaneous 50Hz/60Hz mode (internal oscillator) or
fEOSC = 280kHz ±2% (external oscillator).
Note 10: The SCK can be congured in external SCK mode or internal SCK
mode. In external SCK mode, the SCK pin is used as digital input and the
driving clock is fESCK. In internal SCK mode, the SCK pin is used as digital
output and the output clock signal during the data output is fISCK.
Note 11: The external oscillator is connected to the fO pin. The external
oscillator frequency, fEOSC, is expressed in kHz.
Note 12: The converter uses the internal oscillator.
Note 13: The output noise includes the contribution of the internal
calibration operations.
Note 14: Guaranteed by design and test correlation.
Note 15: Refer to Applications Information section for performance
vs data rate graphs.
Note 16: For VCC < 3V, VIH is 2.5V for pin fO.
相關PDF資料
PDF描述
LTC2485IDD#PBF IC ADC 24BIT I2C 10-DFN
LTC1443CDHD#TRPBF IC COMP W/REF LOW PWR QUAD 16DFN
LTC1444CDHD#TRPBF IC COMP QD LP 1.221VREF 16-DFN
AD9200ARSZ IC ADC 10BIT CMOS 20MSPS 28-SSOP
LTC1445CDHD#TRPBF IC COMP QD LP 1.221VREF 16-DFN
相關代理商/技術參數
參數描述
LTC2485CDD#PBF 功能描述:IC ADC 24BIT I2C 10-DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率(每秒):1M 數據接口:串行,SPI? 轉換器數目:1 功率耗散(最大):- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤(4x4) 包裝:Digi-Reel® 輸入數目和類型:8 個單端,單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6
LTC2485CDD#TRPBF 功能描述:IC ADC 24BIT I2C 10-DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 位數:12 采樣率(每秒):3M 數據接口:- 轉換器數目:- 功率耗散(最大):- 電壓電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-23-6 包裝:帶卷 (TR) 輸入數目和類型:-
LTC2485IDD 制造商:Linear Technology 功能描述:ADC Single Delta-Sigma 7.5sps 24-bit Serial 10-Pin DFN EP
LTC2485IDD#PBF 功能描述:IC ADC 24BIT I2C 10-DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率(每秒):1M 數據接口:串行,SPI? 轉換器數目:1 功率耗散(最大):- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤(4x4) 包裝:Digi-Reel® 輸入數目和類型:8 個單端,單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6
LTC2485IDD#TRPBF 功能描述:IC ADC 24BIT I2C 10-DFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率(每秒):15 數據接口:MICROWIRE?,串行,SPI? 轉換器數目:1 功率耗散(最大):480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN(5x7) 包裝:帶卷 (TR) 輸入數目和類型:16 個單端,雙極;8 個差分,雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494