參數資料
型號: LTC2411IMS#PBF
廠商: Linear Technology
文件頁數: 32/40頁
文件大?。?/td> 0K
描述: IC A/D CONV 24BIT MICRPWR 10MSOP
標準包裝: 50
位數: 24
采樣率(每秒): 7.5
數據接口: MICROWIRE?,串行,SPI?
轉換器數目: 2
功率耗散(最大): 1mW
電壓電源: 單電源
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 10-TFSOP,10-MSOP(0.118",3.00mm 寬)
供應商設備封裝: 10-MSOP
包裝: 管件
輸入數目和類型: 1 個差分,雙極
產品目錄頁面: 1347 (CN2011-ZH PDF)
LTC2411/LTC2411-1
38
APPLICATIO S I FOR ATIO
WU
UU
Figure 46. Use a Differential Multiplexer to Expand Channel Capability
gain error or due to offset voltages. A 1
V/°Coffsetvoltage
drift translates into 0.05ppm/
°C gain error. Simpler alter-
natives, with the amplifiers providing gain using resistor
arrays for feedback, can produce results that are similar to
bridge sensing schemes via attenuators. Note that the
amplifiers must have high open-loop gain or gain error will
be a source of error. The fact that input offset voltage has
relatively little effect on overall error may lead one to use
low performance amplifiers for this application. Note that
the gain of a device such as an LF156, (25V/mV over
temperature) will produce a worst-case error of –180ppm
at a noise gain of 3, such as would be encountered in an
inverting gain of 2, to produce –10V from a 5V reference.
The error associated with the 10V excitation would be
–80ppm. Hence, overall reference error could be as high
as 130ppm, the average of the two.
Figure 47 shows a similar scheme to provide excitation
using resistor arrays to produce precise gain. The circuit
is configured to provide 10V and –5V excitation to the
bridge, producing a common mode voltage at the input to
the LTC2411/LTC2411-1 of 2.5V, maximizing the AC input
range for applications where induced 60Hz could reach
amplitudes up to 2VRMS.
The circuits in Figures 45 and 47 could be used where
multiple bridge circuits are involved and bridge output can
be multiplexed onto a single LTC2411/LTC2411-1, via an
inexpensive multiplexer such as the 74HC4052.
Figure 46 shows the use of an LTC2411/LTC2411-1 with
a differential multiplexer. This is an inexpensive multi-
plexer that will contribute some error due to leakage if
used directly with the output from the bridge, or if resistors
are inserted as a protection mechanism from overvoltage.
Although the bridge output may be within the input range
of the A/D and multiplexer in normal operation, some
thought should be given to fault conditions that could
result in full excitation voltage at the inputs to the multi-
plexer or ADC. The use of amplification prior to the
multiplexer will largely eliminate errors associated with
channel leakage developing error voltages in the source
impedance.
2411 F46
REF+
REF
IN+
IN
6
A0
A1
VCC
GND
13
3
6
12
47
F
14
1
5
10
16
5V
15
11
2
TO OTHER
DEVICES
4
9
8
5V
+
74HC4052
2
3
4
5
1
LTC2411/
LTC2411-1
相關PDF資料
PDF描述
LM2901VNG IC COMP QUAD SGL SUPPLY 14DIP
ISL4245EIRZ IC 3DRVR/5RCVR RS232 3V 32-QFN
NCV2901DR2G IC COMP QUAD SGL SUPPLY 14SOIC
LMV339DTBR2G IC COMPARATOR GP LV QUAD 14TSSOP
LMV339DR2G IC COMPARATOR GP LV QUAD 14-SOIC
相關代理商/技術參數
參數描述
LTC2412CGN 功能描述:IC ADC 2CH DIFF-IN 24BIT 16SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率(每秒):45k 數據接口:串行 轉換器數目:2 功率耗散(最大):315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端,單極
LTC2412CGN#PBF 功能描述:IC ADC 2CH DIFF-IN 24BIT 16SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率(每秒):1M 數據接口:串行,SPI? 轉換器數目:1 功率耗散(最大):- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤(4x4) 包裝:Digi-Reel® 輸入數目和類型:8 個單端,單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6
LTC2412CGN#PBF 制造商:Linear Technology 功能描述:IC, ADC, 24BIT, SSOP-16
LTC2412CGN#TR 功能描述:IC CONV A/D 24B 2CH DIFF 16-SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率(每秒):45k 數據接口:串行 轉換器數目:2 功率耗散(最大):315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端,單極
LTC2412CGN#TRPBF 功能描述:IC ADC 2CH DIFF-IN 24BIT 16SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率(每秒):45k 數據接口:串行 轉換器數目:2 功率耗散(最大):315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端,單極