- 您現在的位置：買賣IC網 > PDF目錄2084 > LTC2392HLX-16#PBF (Linear Technology)IC ADC 16B SER/PAR 500K 48LQFP PDF資料下載
參數資料
| 型號： | LTC2392HLX-16#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 7/26頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 16B SER/PAR 500K 48LQFP |
| 標準包裝： | 250 |
| 位數： | 16 |
| 采樣率（每秒）： | 500k |
| 數據接口： | 串行，并聯 |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 135mW |
| 電壓電源： | 模擬和數字 |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 48-LQFP |
| 供應商設備封裝： | 48-LQFP（7x7） |
| 包裝： | 托盤 |
| 輸入數目和類型： | 1 個差分，雙極 |
| 配用： | DC1500A-B-ND - BOARD SAR ADC LTC2392-16 |
LTC2392-16
15
239216fa
applications inFormation
Signal-to-Noise Ratio (SNR)
The signal-to-noise ratio (SNR) is the ratio between the
RMS amplitude of the fundamental input frequency and
the RMS amplitude of all other frequency components
except the first five harmonics and DC. Figure 5 shows
that the LTC2392-16 achieves a typical SNR of 94dB at a
500kHz sampling rate with a 20kHz input.
Total Harmonic Distortion (THD)
Totalharmonicdistortion(THD)istheratiooftheRMSsum
ofallharmonicsoftheinputsignaltothefundamentalitself.
The out-of-band harmonics alias into the frequency band
between DC and half the sampling frequency (fSMPL/2).
THD is expressed as:
THD
= 20log
V22 + V32 + V42...VN2
V1
where V1 is the RMS amplitude of the fundamental fre-
quencyandV2throughVNaretheamplitudesofthesecond
through Nth harmonics.
POWER CONSIDERATIONS
The LTC2392-16 provides three sets of power supply
pins: the analog 5V power supply (AVP), the digital 5V
power supply (DVP) and the digital input/output interface
power supply (OVP). The flexible OVP supply allows the
LTC2392-16 to communicate with any digital logic operat-
ingbetween1.8Vand5V,including2.5Vand3.3Vsystems.
Power Supply Sequencing
The LTC2392-16 does not have any specific power supply
sequencingrequirements.Careshouldbetakentoobserve
the maximum voltage relationships described in the Ab-
solute Maximum Ratings section. The LTC2392-16 has a
power-on-reset (POR) circuit. With the POR, the result of
the first conversion is valid after power has been applied
to the ADC. The LTC2392-16 will reset itself if the power
supply voltage drops below 2.5V. Once the supply voltage
is brought back to its nominal value, the POR will reinitial-
ize the ADC and it will be ready to start a new conversion.
Nap Mode
The LTC2392-16 can be put into the nap mode after a
conversion has been completed to reduce the power
consumption between conversions. In this mode some
of the circuitry on the device is turned off. Nap mode is
enabledbykeepingCNVSTlowbetweenconversions.When
the next conversion is requested, bring CNVST high and
hold for at least 250ns, then start the next conversion by
bringing CNVST low. See Figure 6.
Power Shutdown Mode
When PD is tied high, the LTC2392-16 enters power
shutdown and subsequent requests for conversion are
ignored. Before entering power shutdown, the digital
output data needs to be read. However, if a request for
power shutdown (PD = high) occurs during a conversion,
the conversion will finish and then the device will power
Figure 6. Nap Mode Timing for the LTC2392-16
CNVST
BUSY
NAP
tCONV
tACQ
NAP MODE
239216 F06
t5
相關PDF資料 |
PDF描述 |
|---|---|
| LTC2412IGN#TRPBF | IC ADC 2CH DIFF-IN 24BIT 16SSOP |
| LTC2413IGN#TRPBF | IC A/D CONV 24BIT MICRPWR 16SSOP |
| LTC2415-1IGN#TRPBF | IC ADC 24BIT DIFFINPUT/REF16SSOP |
| LTC2436-1IGN#TRPBF | IC CONV A/D 16B 2CH DIFF 16SSOP |
| LTC2439-1IGN#TRPBF | IC ADC 16BIT 16CH MCRPWR 28SSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2392ILX-16#PBF | 功能描述:IC ADC 16B SER/PAR 500K 48LQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
| LTC2392IUK-16#PBF | 功能描述:IC ADC 16B SER/PAR 500K 48QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
| LTC2392IUK-16#TRPBF | 功能描述:IC ADC 16B SER/PAR 500K 48QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
| LTC2393CLX-16#PBF | 功能描述:IC ADC 16BIT SER/PAR 1M 48-LQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6 |
| LTC2393CLX-16#PBF | 制造商:Linear Technology 功能描述:ANALOG TO DIGITAL (A/D) CONVERTER IC |
發布緊急采購，3分鐘左右您將得到回復。